查看所有试题
- 过滤式自救器要注意保养,一般可使用5年,也不用定期检查。“一坡三挡”中的上部挡车栏设在变坡店下方()处。正确#
错误10m
15m
20m#
- 发现有人触电,应赶紧拉他脱离电源。离开卸轨的箕斗速度应限制在()以下。用于屏蔽不必要原发射线的装置是()正确#
错误1.2m/s
0.5m/s#
2m/s影像增强器
高压发生装置
遮线器#
滤线器
X线管支架
- 压缩氧自救器佩戴后,要重新充氧和更换二氧化碳吸附剂。正确#
错误
- 井底信号工、把钩工应注意溜煤嘴放煤情况及开合状况,发现大块煤或矸石、湿煤或其它杂物等堵塞溜煤嘴时,要及时处理,处理不好要及时报告。提升绞车滚筒主轴与减速器出轴之间大都采用()。正确#
错误蛇形弹簧联轴器
弹
- 手动方式卸载时,在箕斗卸空并收到井底发来的信号后,方可向提升司机发出开车信号。当提升系统的惯性力高于系统的静阻力时,投入电气制动或机械制动的减速方式为()。正确#
错误负力减速#
正力减速
自由滑行
- 当断绳或连接装置断开时,能自动防止罐笼或车辆坠落的装置称罐耳。正确#
错误
- 井底信号工、把钩工应注意箕斗装煤量,超过规定时,及时报告。绞车减速器损坏的形式有磨损、打牙和()。正确#
错误锈蚀
齿面疲劳点蚀#
疲劳折断
- 在摇台抬起之前,就要发出开车信号。双滚筒绞车两钢丝绳都为右捻时,钢丝绳在滚筒上的缠绕方向上()。正确#
错误右旋#
左旋
交叉
- 进入卸载曲轨的箕斗,速度应限制在1.5m/s以下。双滚筒绞车更换水平时,需将()固定。正确#
错误固定滚筒
活动滚筒#
绞车主轴
- 《煤矿安全规程》规定:灌顶应设置可以打开的铁盖或铁门,一侧装设扶手。正确#
错误
- 斜井升降人员时的加、减速度不得超过0.5m/s2。离开卸轨的箕斗速度应限制在()以下。提升速度超过()的提升绞车必需装设限速装置。正确#
错误1.2m/s
0.5m/s#
2m/s2米/秒
3米/秒#
5米/秒
- 若罐底有阻车器的连杆装置时,必须设牢固的检查门。正确#
错误
- 升降人员用的钢丝绳,自悬挂时起每隔1年检查1次。正确#
错误
- 罐门可以向外开。绞车减速器损坏的形式有磨损、打牙和()。连锁店公共区域温度夏季应控制在26℃,冬季应控制在()以上。正确#
错误锈蚀
齿面疲劳点蚀#
疲劳折断18℃#
20℃
22℃
- 提升矿车的罐笼不一定必须装阻车器。正确#
错误
- 新装设的防坠器可不进行脱钩试验。带式输送机道防灭火水管间隔()设1个管接头和阀门。正确#
错误20m
30m
40m
50m#
- 使用中的立井罐笼防坠器,每半年应进行1次不脱钩检查性试验,每年应进行1次脱钩试验。正确#
错误
- 参与升降人员和物料的罐笼,必须装设可靠的防坠器。正确#
错误
- 专为升降人员和物料的罐笼,每层内1次能容纳的人数应明确规定,并在井口公布。正确#
错误
- 使用带衬垫的天轮,应保证衬垫的磨损量不超过一定值。正确#
错误
- 摩擦轮式提升机用钢丝绳,也应像缠绕式提升机用的钢丝绳一样,按《煤矿安全规程》规定进行试验。带式输送机道防灭火水管间隔()设1个管接头和阀门。用于屏蔽不必要原发射线的装置是()正确#
错误20m
30m
40m
50m#影
- 在单钩提升时,钢丝绳的静张力就是提升容器自身的重力、载荷重力和钢丝绳自重之和。正确#
错误
- 主提升机安全制动闸必须采用配重式或弹簧式的制动装置。当提升系统的惯性力高于系统的静阻力时,投入电气制动或机械制动的减速方式为()。正确#
错误负力减速#
正力减速
自由滑行
- 钢丝绳的钢丝一般由直径0.4~4mm的碳素钢或者合金钢制成。双滚筒绞车更换水平时,需将()固定。正确#
错误固定滚筒
活动滚筒#
绞车主轴
- 绞车运行时,司机不得与其他人交谈。当提升系统的惯性力高于系统的静阻力时,投入电气制动或机械制动的减速方式为()。正确#
错误负力减速#
正力减速
自由滑行
- 《煤矿安全规程》规定:使用中的单绳缠绕式绞车专为提升物料用钢丝绳的安全系数不得低于6。正确#
错误
- 提升钢丝绳绳芯的作用,只是吸收钢丝绳的张力。国际标准中,润滑油的牌号是以温度()时的运动粘度平均值命名的。双滚筒绞车更换水平时,需将()固定。正确#
错误20℃
30℃
40℃#固定滚筒
活动滚筒#
绞车主轴
- 有接头的钢丝绳可以用于立井提升。使用中的主井罐笼防坠器,每()应进行1次不脱钩检查性试验。离开卸轨的箕斗速度应限制在()以下。正确#
错误季度
半年#
1年1.2m/s
0.5m/s#
2m/s
- 二级制动优点之一是减少停车时由惯性引起的冲击,保证停车平稳。正确#
错误
- 钢丝绳在载荷作用下,丝与丝之间成平行接触状态,钢丝接触呈螺旋线,故称线接触钢丝绳。使用中的主井罐笼防坠器,每()应进行1次不脱钩检查性试验。正确#
错误季度
半年#
1年
- 《煤矿安全规程》规定:斜井矿井提升物料时,速度不得超过9m/s。正确#
错误
- 提升钢丝绳的捻向,分为右捻和左捻两种。“一坡三挡”中的上部挡车栏设在变坡店下方()处。国际标准中,润滑油的牌号是以温度()时的运动粘度平均值命名的。正确#
错误10m
15m
20m#20℃
30℃
40℃#
- 1984年12月18日,蹬钩工龙某在井下1203工作面作业时,擅自开动绞车,使下放的两节重车撞到停在空车道上的车斗,将掘进区爆破工庄某挤死,属于重大责任事故罪。使用中的主井罐笼防坠器,每()应进行1次不脱钩检查性试验。
- 斜巷升降人员或用矿车升降物料时的最大速度不得超过5m/s。正确#
错误
- 双滚筒提升机调绳时两容器必须空载,调绳期间在特殊情况下可进行单钩提升。正确#
错误
- 低速继电器SDJ在速度低于0.5m/s时,释放;当速度高于1.5m/s时,吸合。正确#
错误
- 提升速度图是表示提升设备在一个周期内的速度变化规律的图。双滚筒绞车主轴采用的是()。正确#
错误滑动轴承#
滚动轴承
滚子轴承
- 液压站的超压保护动作值调定为系统压力的5%。等速阶段过速保护继电器的动作值是()。正确#
错误253V#
242V
220V
- 动力制动与微拖动均属负力减速。当提升系统的惯性力高于系统的静阻力时,投入电气制动或机械制动的减速方式为()。正确#
错误负力减速#
正力减速
自由滑行
- 盘式制动器所产生的制动力矩的大小与油压的大小成正比关系。正确#
错误