查看所有试题
- 在检查智能化系统数据集成功能时,对各子系统全部检测,()合格为检测合格。A、100%#
B、90%以上
C、80%以上
D、50%以上
- 紧急广播系统应备声压级要求()。≥80dB
≥83dB
≥86dB#
≥90dB
- 仪用放大器构成包括()A、同相放大器#
B、反向放大器
C、减法器#
D、加法器
- 当晶体二极管工作在伏安特性曲线的正向特性区,而且所受正向电压大于其门坎电压时,则晶体二极管相当于()GB50339-2003标准的性质是什么()?A、大电阻
B、断开的开关
C、接通的开关#
D、小电阻A
- 下列哪项不属于管理子系统的组成部分或设备()。在三极管放大电路中,三极管电位最高的一端是()配线架
网络设备#
水平跳线连接
管理标识A、PNP管的发射极#
B、PNP管的集电极
C、NPN管的发射极
D、NPN管的集电极
- 卫星通信系统的四大系统中,哪一个是起到连接卫星线路和用户中枢的作用()通常一次完整的系统开发生命周期包括()。A、空间分系统
B、地球站群#
C、跟踪遥测及指令系统
D、监控管理分系统A、系统分析#
B、系统设计#
- 监控中心机柜(架)背面、侧面离墙净距离应()。有关电气控制系统说法正确的是()。对综合布线光缆布线进行衰减测试,以下说法正确的是()。A、≤0.8m
B、≥0.8m#
C、≤0.5m
D、≥0.5mA、电气控制系统是由各种有触点的
- 公共广播系统电声性能测量点距地面高度应为()。监控中心机柜(架)背面、侧面离墙净距离应()。浙江省地方标准要求,彩色监视系统清晰度指标为()。1.2m~1.5m#
1.0m~1.2m
1.2m
1.5mA、≤0.8m
B、≥0.8m#
C、≤0.5m
- PWM整流器()在自控系统中,遇到两种或多种物料流量的情况下,或者需要多种控制参数保持严格比例的关系的时候,就需要用到()A、不可四象限运行
B、功率因数可接近于±0.1
C、可用于电力牵引#
D、可用于太阳能并网发电
- 系统集成()影响火灾报警系统及消防联动系统的独立运行。当晶体二极管工作在伏安特性曲线的正向特性区,而且所受正向电压大于其门坎电压时,则晶体二极管相当于()A、可以
B、不可以
C、不宜
D、不得#A、大电阻
B、
- 关于楼宇自动化系统集成的原则,下列叙述正确的是()A、保持技术先进性#
B、系统具有开放性#
C、集成后的系统便于管理#
D、可扩充性好#
E、系统运行中的各种操作具有安全性#
F、有最好或接近最好的投资效益,即系统集
- 在集散控制的中央监控系统中,以下所列哪些功能属于它的基本功能()已知图示电路中的US=2V,IS=2A。电阻R1和R2消耗的功率由()供给。使用Cat5e对绞电缆作为100M计算机网络传输介质时,以下说法正确的是()。A、报告
- 多模光纤在1300nm的最大损耗为()。1.5dB#
2.0dB
3.0dB
3.75dB
- 接触器直接启停与保护线路如下图所示,要启动电动机时,应()A、先合QS,再合QS,使KM线圈得电,使电机连续运行
C、先合QS,然后按SB2,KM自锁,使KM线圈得电,KM触点断开
- 晶闸管串联时,为达到静态均压,可在晶闸管两端并联相同的()。三相全控桥整流电路中,晶闸管的触发方式可以是()。A、电阻#
B、电容
C、电感
D、阻容元件A、窄触发脉冲
B、方波脉冲
C、双窄触发脉冲#
D、宽脉冲触发#
- 下面各个选项中哪个是楼宇自动化系统中的现场总线()。A、ProfiBus
B、ControlNET
C、CAN#
D、P-Net
- 视觉照明环境检测工作面水平照度在房间内距墙面1m(房间面积小时,取0.5m),距地面为()的假定工作面上进行测试,或在实际工作台面上进行测试。市电掉电后,访客对讲系统的备用电源应能保证系统正常工作()小时以上。
- 下列各子系统中,属于建筑设备监控系统监控范围的是()。综合布线系统采用通道链路模型进行测试,测试仪器端到端的最长链路距离为()。A、空调与通风系统
B、一卡通系统
C、视频监控系统
D、视频会议系统#D
- 应用于有线电视的同轴电缆的阻抗是()。通常可用两种方法抑制逆变器的输出谐波,即多重化方法和()方法。A、50Ω
B、60Ω
C、75Ω#
D、100ΩA、波形调制
B、频率调制#
C、电流调制
D、电压调制
- 视觉照明环境检测中,应急照明灯的照度要求为在离地面0.8m处水平照度不应低于()。下列哪项不属于管理子系统的组成部分或设备()。5lx#
11lx
15lx
21lx配线架
网络设备#
水平跳线连接
管理标识