查看所有试题
- 室内噪声测试时,测试话筒高度距地面()。(1.0~1.2)m
(1.2~1.5)m#
(1.5~1.7)m
(1.7~2.0)m
- 通信网络系统试运行验收测试应从初验测试合格后开始,试运行周期可按合同规定执行,但不应少于()。100M计算机网络中的M表示为()。1个月
2个月
3个月#
4个月C
- 某密码锁电路如图,开锁的规则为,先拨对密码A、B、C、D,再用钥匙开通电源,门锁打开,接通报警音响。正确的开锁密码为()。A、A=0、B=1,C=0;D=1,C=0;D=1,#
C、A=1、B=0,C=0;D=0
- 下面各个选项中哪个是楼宇自动化系统中的现场总线()。A、ProfiBus
B、ControlNET
C、CAN#
D、P-Net
- 在自控系统中,遇到两种或多种物料流量的情况下,或者需要多种控制参数保持严格比例的关系的时候,就需要用到()A、单回路系统
B、多回路控制系统
C、比值控制系统#
D、复合控制系统
- 操作系统的主要职能是()工程项目总成本费用构成是()。A、管理和控制计算机系统中的全部硬件、软件资源#
B、合理组织计算机工作流程#
C、为用户提供一个良好的工作环境和友好的接口#
D、系统资源管理和提供用户界
- 黑白监视系统中可使用的显示终端为()。B
- 在网络通信系统中,如果所有工作站都不能上网,则可能有如下原因,正确的是()A、电缆连接有问题#
B、网卡安装有问题#
C、网络协议有问题#
D、网卡与工作站的其他硬件设备冲突
- 智能建筑的一个重要课题就是对能源节约的研究,在传统建筑设备中能耗比例最大的系统为()。TCP/IP分层模型共有()层。A、送排风系统
B、电梯系统
C、照明系统
D、空调暖通系统#5
3
6
4#
- 视觉照明环境检测工作面水平照度在房间内距墙面1m(房间面积小时,取0.5m),距地面为()的假定工作面上进行测试,或在实际工作台面上进行测试。一对称负载接入三相交流电源后,线电流等于相电流的倍,则此负载不可能是
- 在检查智能化系统数据集成功能时,对各子系统全部检测,()合格为检测合格。A、100%#
B、90%以上
C、80%以上
D、50%以上
- 信息插座引针3、6芯应接到()。一个功能完整的智能大楼中包含了多个不同技术类别的子系统,其中较大的系统有()。线对1
线对2
线对3#
线对4A、建筑和装潢#
B、综合布线和计算机网络#
C、大楼设备管理、安保和消防#
- 中央管理工作站存储的历史数据时间应大于()个月。以下属于逻辑取及线圈驱动指令的是()A、3#
B、6
C、10
D、12A、ON
B、LD#
C、LDN#
D、ALD
- 空间环境采取的降低噪声和隔声措施应恰当。办公室内噪声测试推荐值:()。使用Cat5e对绞电缆作为100M计算机网络传输介质时,以下说法正确的是()。(30~35)dBA
(35~40)dBA
(40~45)dBA#
(45~50)dBAA
- 信号在测量周期的最大瞬态值用什么表示()A、峰值#
B、平均值
C、有效值
D、绝对值
- 根据质量和性能的不同,EIA/TIA为双绞线电缆定义了若干种不同质量的型号,其中计算机网络综合布线使用第3、4、5类。第4类线,电缆的传输频率为(),用于话音传输和最高传输速率为16Mb/s的数据传输,主要用于基于令牌的
- 监控中心机柜(架)背面、侧面离墙净距离应()。A、≤0.8m
B、≥0.8m#
C、≤0.5m
D、≥0.5m
- 多模光纤在1300nm的最大损耗为()。在接地制式TT的供电系统中,电气设备的金属外壳要()?1.5dB#
2.0dB
3.0dB
3.75dBA、接在单独的接地极上#
B、接在保护线上
C、接在中性线上
D、绝缘
- 时域中的周期信号在频域中表现为()使用一般通用示波器不能测得的参数是()。A、离散谱线#
B、连续谱线
C、随机信号
D、随机谱线C