查看所有试题
- 某钢筋混凝土单层排架式厂房,有42个C20独立混凝土基础,基础剖面如下图所示,基础底面积为2400mm(宽)×3200mm(长),每个C20独立基础和C15素混凝土垫层的体积共为12.37m3,基础下为C15素混凝土垫层厚10.0mm。基坑开挖
- 对于较厚的焊件t>20mm,应采用U形缝、K形缝和()形缝。某场地土方平整,用方格网法计算土方工程量,绘制的方格网如下图中所示,已知方格的边长为20m×20m,不考虑土的可松性,场地的排水坡度。试计算并回答下列问题X#
I
- 建筑屋面防水等级分为()个等级。某新建酒店原定于2012年12月18日开业,可由于工期延误,不得不将开业日推迟到2013年1月18日,那么在开业前应由()来办理工程竣工验收备案。某钢筋混凝土单层排架式厂房,有42个C20独立
- 混凝土的()主要与其密实度及内部孔隙的大小和构造有关。下列劳动合同条款,属于必备条款的是()。抗冻性
抗侵蚀性
抗老化
抗渗性#用人单位的名称、住所和法定代表人或者主要负责人#
劳动者的姓名、住址和居民身份
- 地下室防水混凝土墙和底板的厚度不能过薄,墙的厚度应在()mm以上。在楼板施工中,以下不合理的模板施工方法的是()。100
150
200#
180"滑一浇一"法
框模法#
先滑墙体楼板跟进法
楼板降模法
- 工程质量事故具有()的特点。轻型井点系统的平面布置主要取决于基坑的平面形状和开挖深度,应尽可能将基坑内各主要部分都包围在井点系统中,一般采用()形式。砌体工程冬期施工的方法主要有()。复杂性#
固定性#
严
- 按照工程网络计划的原理,关键工作是指在网络计划中()最小的工作。当混凝土分层浇筑到模板高度的(),且第一层混凝土的强度达到出模强度时,方可进行初滑。总时差#
自由时差
持续时间
时间间隔1/3
2/3#
3/4
1/2
- 下列()因素不会使静定结构引起反力及内力。钢筋混凝土斜截面受剪截面破坏形式()。根据《建筑工程安全生产管理条例》的规定,专职安全生产管理人员负责对安全生产进行现场监督检查,对违章指挥、违章操作的,应当(
- 混凝土的()主要与其密实度及内部孔隙的大小和构造有关。悬挑长度为1.5m、混凝土强度为C30的现浇阳台板,当混凝土强度至少应达到()时方可拆除底模。某建筑物第一层现浇楼面有L1梁,其钢筋保护层厚度定为20mm,断面图
- 建筑平面图中,外部尺寸一般分三道分别是()。木地面的构造方式不包括()。某工程在施工的过程中,地下水位比较高,若在雨季进行基坑开挖,遇到连续降雨或排水困难,就会引起基坑塌方或地基受水浸泡影响承载力,这属于(
- 扣件式钢管脚手架的杆件中,下列属于"受力杆"的有()。观察验槽的重点应选择在()。纵向水平杆#
力杆#
剪力撑
横向水平杆#
连横杆#基坑中心线
基坑边角处
受力较大的部位#
最后开挖的部位
- 民用建筑按使用性质分类分为()。某工程基坑开挖至设计标高后,组织了基坑验槽,发现基坑底部土质情况与设计要求相符,只是在东南角上出现两处局部土体强度偏低,必须进行处理。设计单位提出了相应的处理办法,施工单位
- 当柱作为建筑物的承重构件时,填充在柱间的墙仅起()的作用。吊挂式顶棚一般由()部分组成。安全生产许可证有效期满需要延期的,企业应当于期满前()个月向原安全生产许可证颁发管理机关办理延期手续。承重
分隔空
- 土的实测指标包括()。以下关于混凝土施工缝留设的位置,正确的是()。天然密度#
比重#
干密度
含水量#
孔隙率宜留在结构剪力较小的部位#
宜设在门槛洞口上#
混凝土墙的施工缝不得留在纵横墙交接处
施工缝应留在次
- 选定施工方案后,制定施工进度时,必须考虑施工顺序、施工流向,主要分部分项工程的施工方法,特殊项目的施工方法和()能否保证工程质量。以下施工安全技术保证体系组成不包括()。某公共建筑屋面大梁跨度为40m,设计为
- 当建筑物上部为柱承重结构,但地基承载力弱时,宜采用()。下列不是施工测量贯穿于整个施工过程中主要内容的有()。一般排水沟的横断面和纵向坡度不宜小于()。独立基础
条形基础
箱形基础
井格式基础#施工前建立与
- 有关招标投标的法律文件中,法律效力最高的是()。《招标投标法》#
《招标投标法实施条例》
《江苏省招标投标条例》
《工程建设项目施工招标投标办
- 陶瓷卫生产品分为()。釉面内砖
瓷质卫生陶瓷#
墙地砖
陶制卫生陶瓷#
抛光砖
- 一般来说有()因素会激发人们开发新型材料。依次施工的缺点是()。脚手架的安全措施中描述正确的是()。供不应求
现有的材料存在缺陷,不满足要求#
贸易逆差
科学进步#
社会环境变化#由于同一工种工人无法连续施工
- 基础详图常用()的比例绘制。基本模数是建筑模数协调统一标准中的基本尺度单位,用符号M表示,即1M=()。板内分布钢筋不仅可使主筋定位,分担局部荷载,还可()。1:50、1:20、1:10#
1:100、1:00、1:50
1:200
- 77[单项选择题]石膏制品表面光滑细腻,主要原因是()。当因降水而危及基坑及周边环境安全时,宜采用()方法。有一安装施工单位承接了一单层装配式工业厂房安装任务,该厂房长120m,宽36m,柱距6m×12m。施工单位编制了起
- 控制大体积混凝土裂缝的方法有()。防水涂膜可在()进行施工。增加水泥用量
在保证强度的前提下,降低水灰比#
控制混凝土内外温差#
优先选用低水化热的水泥#
及时对混凝土覆盖保温#气温为20℃的雨天
气温为-5℃的雪天
- 在制图中,尺寸线应采用()。点画线
细实线#
中实线
虚线
- 建筑工业化的内容包括()。某多层住宅工程,位于6度抗震设防区,共5层,坡屋面。基础为钢筋混凝土条形基础,基础墙采用MU15的烧结普通标准砖砌筑.上部墙体采用MU15的烧结多孔砖砌筑,所用的砂浆有M10的水泥砂浆和M7.5的
- 属于不常用水泥品种的是()。某地区设防烈度为7度,乙类建筑抗震设计应按下列要求进行设计()。硅酸盐水泥
白水泥#
普通水泥
矿渣水泥地震作用和抗震措施均按8度考虑
地震作用和抗震措施均按7度考虑
地震作用按8度
- 框架结构的主要承重构件有()。无筋砌体局部受压的破坏形态有()。某钢结构厂房工程,基础为预应力管桩基础,轻钢门式钢架结构,彩钢板屋面。钢柱有等截面和变截面柱,框架外包墙及办公区域墙体采用砖砌体,强度等级为M
- 当梁的高度大于()时,可单独浇筑。0.5m
0.8m
1m#
1.2m