查看所有试题
- 当吊具与井壁吊环连接好后,将井壁吊离地面()高度观察有无溜车,必要时可反复起升几次。()色与黑色组成的条纹是视认性最高的色彩,特别能引起人们的注意,所以被选用为警告色。200mm#
500mm
800mm红
黄#
蓝
- 以下属于安全环保严重隐患的是()。A, B, C, E
- 加强溢流预兆及溢流显示的观察,做到及时发现溢流。坐岗观察溢流显示的人员应在进入油气层前()开始坐岗。泥浆泵的防高压安全保护部件是()。被系物上面英文缩写“TW”―“TareWeight”的准确含义是()。50米
100米#
20
- 信贷精细化管理实施方案明确了到期收回管理精细化要求,一般固定资产贷款到期后原则上不允许展期或重新约期,确需展期或重新约期的,必须满足以下条件()。消防管理中()属于安全环保严重隐患。对钻具使用管理基本要
- 钻井中经常使用的转数为()转/分。1~6
5~10#
8~12
- 自锁式电动液压千斤顶在使用前必须逐一检查()下面哪些岗位属于钻井队的特种岗位()。按照()原则,对各单位、各部门、各岗位发生违章行为的事故的责任者,实行责任追究。防护栏杆是指() 。密封件#
外壳形状
油管
- ()色与黑色组成的条纹是视认性最高的色彩,特别能引起人们的注意,所以被选用为警告色。红
黄#
蓝
- 钻进施工中防止掉钻事故发生的安全措施有()以下属于安全生产严重违章的是()。下面关于海上生产设施危险区描述中不正确的是()。设备状态良好#
钻杆、中心管质量合格#
严格按操作规程操作#
严格交接班制度#A, B,
- ()等联合作业前未召开现场协调会,未签订交叉作业协议书,没有现场指挥,吊车指挥未佩戴标识,属于安全生产严重违章行为。A, B, C, D, E
- 起钻时,钻机提升速度不得大于()米/分钟()起吊钻具,属于安全生产一般违章行为。以下属于安全生产严重违章的是()。6
9
4#A, B, C, DA, B, C, D, E
- ()起吊钻具,属于安全生产一般违章行为。A, B, C, D
- 信贷精细化管理实施方案明确了到期收回管理精细化要求,要求从严一般固定资产贷款的展期与重新约期管理,一般固定资产贷款到期后原则上不允许展期或重新约期,确需展期或重新约期的,必须满足以下条件()。按照()原则
- 不能用于带电灭火的灭火器材是()。()起吊钻具,属于安全生产一般违章行为。泡沫灭火器#
二氧化碳灭火器
卤代烷灭火器
干粉灭火器A, B, C, D
- 操作砂轮时,下列哪项是错误的?()操作者站在砂轮的正面操作#
选用和砂轮机匹配的轮片
使用前检查砂轮有无破裂和损伤
均匀磨削
- 油管钳尾绳的长度是()之间的距离长度。井架底角到转盘中心
井架底角到钳体尾部
当主钳开口卡住油管时,井架底角到钳体尾部#
主钳开口卡住油管时,井架底角到钳头
- 手提卡瓦的操作不正确的是:()。钻具上提时,卡瓦应提出补芯
不得用脚踢卡瓦
提放卡瓦时,掌心对准钻杆
卡瓦不分尺寸#
- 钻井对泥浆的要求是稳定性应小于()。不能用于带电灭火的灭火器材是()。0.15
0.02
0.003#泡沫灭火器#
二氧化碳灭火器
卤代烷灭火器
干粉灭火器
- 对钻具使用管理基本要求描述不正确的是:()。上下钻台和运输途中都必须戴护丝
在场地存放时要限制层高,垫木要放在上下同一线上
钻具快速下放时可以突然扔卡瓦卡死钻杆#
5"钻杆本体不高出转盘0.7米;3-1/2"钻杆本体
- 钻机开动过程中,仔细观察倾听钻机的运转情况,发现异常立即()吊运井壁吊具主要由()组成平台泥浆泵运转过程中,要倾听泥浆泵各部分运转有无异常声响,要巡回检查,操作人员()离开岗位。汇报
减速
停机检查#吊架#
悬
- 下面哪些岗位属于钻井队的特种岗位()。司钻#
电、气焊#
炊事员
电工#
- ()色与黑色组成的条纹是视认性最高的色彩,特别能引起人们的注意,所以被选用为警告色。红
黄#
蓝
- 起钻过程中,错误的做法有()。平台泥浆泵启动时,动力和液力端部位以及高压、管线附近,水龙带下面()站人。A, B, C能够
禁止#
可以
一般
- 自锁式电动液压千斤顶在使用前必须逐一检查()在太阳光直射的情况下较明显因而被选用为指令标志的颜色是()。密封件#
外壳形状
油管路#
接头#绿
蓝#
黄
- 按照()原则,对各单位、各部门、各岗位发生违章行为的事故的责任者,实行责任追究。承压管线及阀门一经更换均应进行压力试验,试验压力为其额定工作压力的()。A, B, C100%
125%
150%
200%#
- 吊环用过一段时间后,根据使用频度进行表面及内部探伤,发现裂纹,则应()。对使用手动卡瓦时描述不正确的是:()。加焊
加厚
降级使用
停止使用#卡瓦牙磨损了原高度的1/4时应该更换新牙板
卡瓦手柄不齐全时也可使用#
- 钢丝绳使用中的安全要求不正确的是:()。滑移完大绳,都应调整好()。操作砂轮时,下列哪项是错误的?()起重作业用的钢丝绳应该选择规程规定的多股钢丝绳
禁止超负荷使用,使用中应该注意保护
可以在检验期以外使
- 在对钢丝绳进行外观检查时发现下述哪项即可报废处理?()钻井对含沙量的要求是()钢丝绳直径减少达公称直径的7%时
一个捻距内断丝达到总丝数的10%时
整股钢丝断裂
以上均是#尽可能的低#
尽可能的高
一般不大于4%#
- 被系物上面英文缩写“TW”―“TareWeight”的准确含义是()。吊运井壁吊具主要由()组成出现事故所造成的伤害,表现更多的为()的伤害。吊环用过一段时间后,根据使用频度进行表面及内部探伤,发现裂纹,则应()。对使用
- 下面关于海上生产设施危险区描述中不正确的是()。对使用手动卡瓦时描述不正确的是:()。“0”类危险区:指不断出现或较长一段时间存在可燃性爆炸混合气体的区域
“Ⅰ”类危险区:指在正常作业中可能形成或/聚积可燃性
- 在地段坡度大于()的斜面上工作也视位高空作业。45°#
50°
60°
30°
- 操作砂轮时,下列哪项是错误的?()以下属于安全生产特别严重违章的是()。操作者站在砂轮的正面操作#
选用和砂轮机匹配的轮片
使用前检查砂轮有无破裂和损伤
均匀磨削A, B, C, D, E
- 对钻具使用管理基本要求描述不正确的是:()。上下钻台和运输途中都必须戴护丝
在场地存放时要限制层高,垫木要放在上下同一线上
钻具快速下放时可以突然扔卡瓦卡死钻杆#
5"钻杆本体不高出转盘0.7米;3-1/2"钻杆本体
- 对使用手动卡瓦时描述不正确的是:()。卡瓦牙磨损了原高度的1/4时应该更换新牙板
卡瓦手柄不齐全时也可使用#
卡瓦开启时其开口不小于钻具名义尺寸
安装新牙板后至少有80%的牙能接触钻具体
- 闸板防喷器使用注意事项中,半封闭板封井后()转动钻具。承压管线及阀门一经更换均应进行压力试验,试验压力为其额定工作压力的()。不能#
能够
稍微
激烈100%
125%
150%
200%#
- 手提卡瓦的操作不正确的是:()。钻具上提时,卡瓦应提出补芯
不得用脚踢卡瓦
提放卡瓦时,掌心对准钻杆
卡瓦不分尺寸#
- 存放油漆等室内库房的电线开关和灯均应是()型的。关于竖井钻机安装,正确的是()在对钢丝绳进行外观检查时发现下述哪项即可报废处理?()防水
隔水
防爆#
防静电安装作业前对所有安装人员进行措施贯彻和技术交底#
- 承压管线及阀门一经更换均应进行压力试验,试验压力为其额定工作压力的()。100%
125%
150%
200%#
- 防护栏杆是指() 。泥浆泵安全阀的保险凡尔销钉的耐压强度()水龙带允许安全压力。在地段坡度大于()的斜面上工作也视位高空作业。用于阻止人员进入危险区域的安全装置
用于防止人员从高处坠落的安全装置#
用于防
- 吊环用过一段时间后,根据使用频度进行表面及内部探伤,发现裂纹,则应()。下油层套管的安全操作规程包括()。下面井控岗位职责属于司钻的是()。加焊
加厚
降级使用
停止使用#A, B, C, D发现溢流,立即发出井控信号
- 装完压力表后,若各个连接部位有刺漏现象,则()卸掉重装。憋压
回压
放压#
带压