查看所有试题
- 具有多种能源的城市,为提高一次能源利用率与热效率不宜采用()作为空调的冷热源。溴化锂吸收式制冷机中设置抽气装置是为了()关于围护结构的传热热阻,当相邻房间的温差大于()时,内围护结构的最小传热热阻应通过
- 下列()靠外墙的防烟楼梯间及其前室、消防电梯间前室和合用前室,宜采用自然排烟方式。有消声要求的调节系统,其风管内的风速()操作温度是反映()建筑高度超过50m的一类公共建筑
建筑高度超过100m的居住建筑
建筑
- 制冷剂破坏臭氧潜值ODP是指()在输送非标准状态空气时,应对通风空调系统的通风机的()暖风机的组合不包括()臭氧潜能值
地球变暖潜能值
该种制冷剂破坏大气中臭氧分子潜能的程度#
热力完善度风压进行修正
电动机
- 某排气系统中SO2的浓度为50g/m3,用水吸收SO2,吸收塔在t=20℃、PZ=1atm的工况下工作,问气相中SO2的比摩尔浓度为()kmolSO2/kmol空气。1.78×10-1
1.78×10-2#
1.78×10-3
1.78×10-4
- 主要用于以热电厂为热源的集中供热系统运行经济分析、运行管理和热电厂选择供热汽轮机型式、台数的热负荷曲线图为()位于严寒地区的工业建筑,采用热风采暖且距外窗()以内有固定工作地点时,宜在窗下设置敌热器。设
- 下列关于自然循环回路的设计说法错误的是()逆卡诺循环由()组成。下列关于排烟口的基本要求,不正确的是()为增加循环的可靠性,应将水冷壁分成几个独立的循环回路
同一回路的上升管在高度、长度和热负荷大小等方
- 离心式低压风机输送气体时;一般的增压值范围为()若要求对低频、高频噪声都有好的消声效果时,消声设计应选用()<1000Pa#
1000~3000Pa
>3000Pa
>4000Pa膨胀型消声器
复合型消声器#
共振型消声器
阻性型消声器
- 冰蓄冷空调系统中,低温送风的末端装置主要应解决()热空气幕的出口风速,对于公共建筑的外门,不宜大于();对于工业建筑的外门,不宜大于()。节能问题
结露问题#
气流组织问题
噪声问题6m/s,8m/s#
5m/s,8m/s
6
- 室内消火栓给水系统与自动喷水灭火系统两种系统分开设置的理由不包括()离心式高压风机输送气体时,增压值范围一般()采用液体吸收法,选用吸收装置时;不需要考虑的因素是()两种系统火灾延续时间、水压不同
避免
- 蒸汽供热系统中,分汽缸的上部装置不包括()采暖系统的计算压力损失,宜采用()的附加值。在计算公式ηv=(L1Y1-L2Y2)/L1Y1中,L1指()压力表
温度计
安全阀
疏水器#20%
15%
30%
10%#除尘器出口风量
除尘器入
- ()对吹吸式排风罩的极限流量比影响不大。下列热湿交换设备中()不是接触式设备。关于热补偿,下列说法错误的是()吹风口法兰边全高#
吹风口间距与吹风口高度之比
吸风口法兰边全高与吹风口高度之比
污染气流速度
- 当矩形风管的长、宽分别为A、B时,则其当量直径为()关于确定空调房间的换气次数,下列说法中不正确的为()高层建筑并联供水是指()2AB/(A+B.#
(A+B./2
(A+B./(2AB.
(A+B./(AB.高大房间应按其冷负荷通过
- 关于外部吸气罩的描述正确的是()开启式压缩机组成的制冷系统,系统的COP是指()防火分区面积大小的确定应考虑的因素不包括()排风量一定,外部吸气罩的吸入速度随吸气范围的减小而增大#
吸入速度相同,外部吸气罩的
- 冷库空库时,结冻间的温度应在()采用直接给水方式的下行上给式系统,其最不利配水点通常在建筑物的()在多个采暖建筑物的同一供热系统中,应当安置()个膨胀水箱。-23℃
-18℃
-10℃#
-5℃最低最远点
最高最近点
最低最
- 如果热水供暖系统设计不当,多层建筑的()热水供暖系统形式容易产生垂直热力失调现象(多层建筑指6层以下)。热空气幕的出口风速,对于公共建筑的外门,不宜大于();对于工业建筑的外门,不宜大于()。建筑物全面排
- 吸收式制冷机“工质对”中()关于要保证通风空调的模型实验中两个流动问题的力学相似,下列叙述错误的是()生产工艺用热属于()高沸点的组分作为制冷剂,低沸点的组分作为吸收剂
低沸点的组分作为制冷剂,高沸点的组分
- 下列关于表冷器传热系数经验公式的分析全面、正确的是()膨胀水箱水容积的计算,当为时采暖系统y=()事故通风口与机械送风系统进风口的水平距离小于()时,应高于进风口6m以上。表冷器的传热系数是其空气进出口温
- 空调的送风量和设备主要由()来确定。生产过程和设备本身会产生或诱导一定的气流运动的局部排风罩称为()工业吸附装置使用硅胶时,取静活性的()作为动活性指标。冬季负荷
夏季负荷#
过渡季节负荷
全年负荷吹吸式
- 两级压缩中间不完全冷却循环适用于()冷库地面防止冻胀的措施有()方法。关于锅炉问设备布置的一般要求,不正确的是()绝热指数小的制冷剂#
绝热指数大的制冷剂
与绝热指数大小无关的情况
不能确定使地坪无缝
多加
- 尘粒的驱进速度是指它在静电除尘器中()防烟分区的划分应采用()采暖通风与空调工程初步设计通风部分设计说明的内容不包括()随气流运动的速度
因电场力作用而获得的运动速度
电场力与空气阻力平衡时的横向运动速
- 开启式螺杆式制冷压缩机中目前广泛采用()来调节冷量。依法成立的合同,受法律保护。下列说法不正确的是()防排烟系统的联合试运行与调试结果(风量及正压),必须符合设计与消防的规定,检查数量为()滑阀调节机构#
- 在进风与回风平面相遇的地点,必须设置的通风设施是()。空调区与邻室的夏季温差小于()时,可不必计算内围护结构的传热量。采用集中热风采暖时,送风温度应()风门
挡风墙
风桥#3℃#
5℃
2℃
4℃不宜低于35℃,并不得高于
- 加热挤压机模头夹套的热油,其温度不得超过()℃。300#
400
500
600[T/]
- 保证通风空调的模型实验中两个流动问题的力学相似性,则应满足()低层建筑的消防水箱,容积应()建设单位违反《中华人民共和国建筑法》规定,要求建筑设计单位或者建筑施工企业违反建筑工程质量、安全标准,降低工程质
- 水平悬吊的主、干风管长度超过()时应设防止摆动的固定点,且每个系统的固定点不应小于1个。活塞机的显著特点是()围护结构的附加或修正耗热量包括()10m
20m#
50m
70m结构简单,噪声大#
靠回转体旋转,容积效率高,
- 在经济定货量的基本模型中假定了()大批量购买可享受优惠折扣
容许有缺货情况发生
批量越大,则每次订货成本越高
全年储存成本与全年平均库存量成正比#
- 具有自然通风的单层建筑物,所散发的可燃气体密度小于室内空气密度时,宜设置事故()设在高层建筑内的汽车停车库防排烟设计,应符合()的规定。锅炉、辅助没备和监控仪:表安装处,应根据运行、检修的需要设置平台或扶
- 冷负荷系数法中,窗玻璃的综合遮挡系数的定义为()城镇实现管网输气,液化石油气掺混空气是()低压蒸汽采暖系统管道中热媒的最大容许流速,符合规定的是()窗内遮阳系数与窗玻璃的遮阳系数之比
窗玻璃的遮阳系数与窗
- 主要用于以热电厂为热源的集中供热系统运行经济分析、运行管理和热电厂选择供热汽轮机型式、台数的热负荷曲线图为()某办公室夏季用分体空调机调节室内温湿度,其空调过程的热湿比ε为()机械循环系统水力计算常采用
- 下列说法正确的是()12%
20%#
32%
38%室内温度有严格要求
室内相对湿度有严格要求#
室内卫生条件要求高
室内热湿比大工程建没中拟采用的新技术、新工艺、新材料,不符合现行强制性标准规定的,应当由拟采用单位提