查看所有试题
- ()是把光信号转化为电信号的器件。承载GPRS业务的信道为:()A、光检测器#
B、光放大器
C、光分路器
D、光发送器TCH
SCCH
PDCH#
PGCH
- VoIP语音丢包率高将导致语音质量下降,极限值为()。A、0.2%
B、0.3%
C、0.4%
D、0.5%#
- 高压配电方式指从区域变电所,将35kV以上的高压降到()高压送至企业变电所及高压设备的接线方式。A、10-20kV
B、6-10kV#
C、380V
D、220V
- 网络部内部的投诉电话要确保()小时通畅和及时接听,监控中心的值班人员要每天进行电话测试。A、5×24
B、7×24#
C、5×12
D、7×12
- 电池的管理方式正常情况下应处于()。A、半自动
B、自动或手动
C、手动方式
D、自动方式#
- 适当调整整流模块的数量,保证开关电源工作性能及效率。整流模块不宜长期工作在小于额定值()的状态下。A、0.05
B、0.1#
C、0.2
D、0.3
- 蓄电池的容量选择与什么相关()A、负载容量#
B、电源容量
C、负载工作电压范围
D、负载连接线的长度
- VoIP语音丢包率高将导致语音质量下降,预警值为()。A、0.2%#
B、0.3%
C、0.4%
D、0.5%
- 各维护单位应建立、保存与辖区内全业务接入网有关的各种客户资料、网络资料、SLA资料等应至少保存()年。对于已经到更新时间的设备,经过检测性能仍然合格,经过主管部门批准后()。A、五
B、四
C、三#
D、二A、不可
- 接入网时延达标率参考值,KPI指标集要求()。用户交流总输入刀闸、交流输入空开、模块输入空开,上电顺序为()。A、≥90%
B、≥95%
B、≥97%
D、≥99%#A、刀闸、输入空开、模块空开#
B、输入空开、刀闸、模块空开
C、模
- 根据《中国移动通信集团浙江有限公司客户网络服务SLA标准规范》本地铜牌级用户故障排查恢复时间()小时。DNS的作用是()。A、≤10
B、≤8#
C、≤6
D、≤3A、为客户机分配IP地址
B、访问HTTP的应用程序
C、将计算机名翻
- 在配置ONT模板时,那种类型ONU可以选择SNMP管理模式。()在实施WLAN和运营商室内分布网络中,常用到的射频电缆WLAN信号损耗描述正确的是()A、A类
B、B类#
C、C类
D、以上都可以1/2超柔馈线100m损耗19.2dB#
1/2标准
- 接入网时延达标率参考值,KPI指标集要求()。A、≥90%
B、≥95%
B、≥97%
D、≥99%#
- 电压互感器在额定容量下可以长期运行,但在任何情况下不允许超过最大容量运行,然而可以在工作电压超过额定值()情况下长期运行。A、30%
B、20%
C、10%#
D、5%
- 维护指标统计管理是衡量服务质量的一项重要指标,其中不包括()。用户交流总输入刀闸、交流输入空开、模块输入空开,上电顺序为()。A、接通率
B、中继可用率
C、硬件故障率
D、故障处理及时率#A、刀闸、输入空开、
- 新版本补丁实施时,随工人员必须在凌晨()之前完成割接结果确认。A、4:00
B、5:00#
C、6:00
D、7:00
- 通信电源系统的三遥功能是指()A、遥测、遥信、遥控#
B、遥测、遥感、遥控
C、遥测、遥信、遥感
D、遥感、遥信、遥控
- 不间断电源保护功能不包括()。A、输出短路
B、输出过载
C、机内过温
D、输入短路#