查看所有试题
- 与滚动轴承相比,滑动轴承工作时具有()的特点。下列物质中,既能使KMnO4褪色,又能使溴水褪色的是()。寿命长#
承载能力高#
抗振性好#
噪声小#乙烷
笨
乙炔#
丙烷
- 石油炼制中,催化裂化的原料一般为()。低沸馏分油
中间馏分油
重质馏分油#
渣油
- 冷却水中换热器水侧传热表面上沉积物增多,则冷却水侧的污垢热阻()。增大#
不变
减小
无法判断
- 在石油化工生产装置中,现场照明线路控制通常使用()。无阀滤池U形进水管底部的标高()虹吸下降管管口。封闭式循环冷却水系统的特点有()。拉线开关
空气开关
胶合开关
防爆开关#高于
等于
低于#
无法判断补水量小
- 一般来说,前馈控制系统常用于()的场合。造成循环水集水池液位急剧下降的原因有()。干扰因素多
扰动频繁而又幅值较大#
主要扰动可测而不可控#
扰动对被控变量影响显着,单靠反馈控制难以到要求的情况#补水水量小
- 电渗析器的工作要求有()。A, B, C, D
- 离心泵一般不能低于设计流量()%的状态下连续运行。25
30#
35
40
- 炼油厂循环水工艺的水质标准中含油量应()。水体尤其是静止水体中,由于过量接受()等植物影响物质,使水体生态平衡遭到破坏,表层藻类植物大量繁殖,水体底层缺氧而进行厌氧分解,产生各种有毒的.恶臭的代谢物,从而使
- 水泵选择遵循的原则为()。A, B, C, D
- 半固态的润滑剂称为润滑脂,它是根据()来划分牌号。A、滴点
B、粘度
C、针入度#
D、皂分
- 化工生产中要求把两种物料按一定比列配合,以保证反应充分借阅能量,此条件下可使用()控制系统进行自动控制。能与水中某些离子或腐蚀下来的金属离子相互结合沉淀在金属的表面上,形成一层难溶的沉淀物或络合物,从而阻
- 若增加离心泵叶轮叶片数量,扬程为(),液体的水力损失增大。平流隔油池有()特点。增大#
减少
不变
无法确定耐冲洗负荷#
构造简单#
布水非常均匀
占地面积少
- 潜污泵()之间是静密封。《我国污水综合排放标准》中规定COD属于第()污染物。冷却水循环使用易产生的问题是()三种现象。电机输出轴与泵体
电缆和接线盒#
上下壳体#
电机壳体与泵体#B腐蚀、结垢、黏泥#
腐蚀、结
- 在无机酸中,俗称“三大强酸”是指()。压力容器运行中严禁()。盐酸#
硫酸#
硝酸#
磷酸移动
超温#
超压#
超负荷#
- 以下情况中,会引起重力式无阀滤池不能进行自动反洗的是()。A、进水量偏小
B、进水量偏大
C、挡板未固定#
D、循环水浊度偏高
- 下图()表示安装的阀门手轮在正上方。A、#
B、
C、
D、
- 循环水处理中使用剥离剂时需要有一定的()配合才能起到剥离作用。预膜过程实际上是大剂量的投加()的过程。泵正常停车时,首先关闭水泵()再按停车按钮,再关进口阀及所有阀门。A、温度
B、压力
C、流速#
D、pHA、
- 污油在水中存在的状态是()氯气和氨水反应会产生()现象。重力式无阀滤池反冲洗强度的大小,一般通过改变()来重新设定。悬浮状态
乳化状态
溶解状态
三种状态同时存在#A、黄绿色气体
B、白色烟雾#
C、红棕色气体
- 化工行业标准推荐的Ⅰ型标准腐蚀试片的面积为()cm2。确定滤池滤层的厚度应考虑的因素有()。氯气消毒的适宜pH值范围为()。18
28#
38
40水质#
滤料的种类#
水温
滤料的级配#5~7#
7~9
9~11
11~13
- 下列不是斜板隔油池优点的是()。当投加缓蚀剂进行冷却水处理时,对于含不锈钢换热设备的循环冷却水系统,氯离子浓度不宜大于()mg/L。A、增加了处理量
B、加大了油珠上浮的距离#
C、占地面积小
D、提高单位池容的分
- 在不可压缩理想液体恒定流中,微小流束内不同的过水断面上,单位重量液体所具有()保持相等。下列因素中,能导致循环水总铁高的是()。动能
机械能#
位能
压能补充水总铁高#
系统腐蚀加重#
系统新管线投用#
补充水浊
- 下列杀生剂中属于非氧化型杀生剂的是()。在重力式无阀滤池的小修中,若出现滤料严重结块,则应()。水泵在运行()小时左右就要对填料进行更换。A、氯
B、臭氧
C、二氧化氯
D、季铵盐#A、进行强制反洗处理
B、人工
- 在循环冷却水系统中,金属材料遇到的腐蚀是属于()范畴。采用()混凝剂,混凝的效果受pH值影响较小,有助于提高混凝效果。A、化学腐蚀
B、化学或电化学腐蚀
C、电化学腐蚀#
D、物理和化学腐蚀A、有机高分子#
B、铝盐
- 应用声波测量物位,是根据声波从发射至接收到反射回波的时间间隔与物位成比列的关系。下列声波特点中,正确的是()。水泵第二相似定律是确定两台工况相似水泵的()之间关系。声波不能在固体中传播
声波穿过气体介质
- 碱清洗时,要同时向水中添加()去润湿油脂.尘埃和生物物质,以提高清洗效果。冷却塔在每平方米有效面积上,单位时间内所()水负荷。AC
- 下列物质中,不能与水发生化学反应的是()。下列物质中属于阻垢剂的是()。CH3CL
C2H2
C2H4
C2H6#HEDP#
ClO2
ZnSO4
1227
- 范德华力是()的作用力。CO2是天然水中主要的杂质,它是决定水中()的主要因素之一原子间
分子间#
离子键
共价键碱度#
浊度
色度
透明度
- 在环状给水网中,任一用户均有()的供水路线。1条
2条
3条
2条或2条以上#
- 压力式过滤器的运行周期可分为()几个步骤。机泵润滑油部件的油槽中润滑油应加至()处为宜。A、反洗、过滤、正洗
B、过滤、反洗、正洗#
C、反洗、排气、过滤、正洗
D、过滤、反洗、过滤、正洗A、1/3~1/2
B、1/2~
- 给离心泵加盘根,每道盘根接口错开()度。混凝剂使水中胶体粒子脱稳的作用的主要是()。60
100
120#
50A、吸附
B、粒间架桥
C、网捕
D、电中和#
- 在直流冷却水系统中,水中各种矿物质和离子含量基本上()。冷却水系统中直接引起金属腐蚀的细菌,按其作用来分有铁沉积细菌、产硫化物细菌和()。为了保循环水泵的正常运转,要求轴承最高温度不大于()℃。A、保持不
- 当pH=8时,水中[OH-]=()mol/L。B
- 再平衡系统中增大反应物浓度,平衡向()移动在给水系统配水管网中,根据各管线所起的作用和管径大小,可分为()等类型。钢凝混凝土排水管分为()水管。左
右#
先左后右
先右后左干管#
分配网#
引入管#
输水管自应力#
- 下列澄清池中,()属于循环泥渣型澄清池。A、单层锥底式悬浮澄清池
B、双层水力悬浮澄清池
C、脉冲澄清池
D、机械加速澄清池#
- 污水中的溶解油主要由()浮选池
曝气池#
调节池
隔油池
- 大、中、小型电动机共用一台变压器时,启动的顺序是()。过滤式防毒面具使用场所的空气中氧含量不应低于()。A、大、中、小#
B、小、中、大
C、中、小、大
D、中、大、小A、15%
B、18%
C、20%#
D、21%
- 在无水塔的管网中,二级泵房的扬程应在用水量最高时使()达到规定的自由水压。以下有关湿度的叙述正确的是()。循环水使用氯气杀菌,PH值较高时氯耗()。控制点#
最高点
最远点
水塔湿度即指空气中所含水蒸气的分量
- 酸雨会造成严重的环境污染,形成酸雨的主要原因是人类活动向大气中排放了大量的()造成循环水出水温度高的原因有()。一氧化碳
二氧化碳
三氧化硫
二氧化硫#气温高#
空气湿度大#
风机运行台数少#
冷却塔布水不均匀#
- 循环冷却水中微生物的繁殖对金属的腐蚀影响是()。加速腐蚀#
降低腐蚀
不变
无法判断
- 根据水的酸度定义,()不属于酸度范畴。A、强酸
B、强酸弱碱盐
C、弱酸
D、弱酸强碱盐#