查看所有试题
- 渗流的理论平均流速与真实流速相比,()。土的压缩系数a1-2是()。饱和土的固结是()的过程。平均流速=真实流速
平均流速<真实流速#
平均流速>真实流速
两者无相关性e-p曲线上压力p为100和200kPa对应的割线
- 渗透力(动水压力)为()。土体所受的前期固结压力比目前压力大时,称为()。单位面积力
体积力#
单位长度
恒定值正常固结土
欠固结土
超固结土#
微欠固结土
- 粉土的结构一般为()。挡土墙在填土自重作用下向前移动,其可能产生的土压力是()。单粒结构
层理结构
絮状结构
蜂窝结构#主动土压力#
被动土压力
静止土压力
不确定
- 室内测定渗透系数很小,流经试样水量较少的粘土渗透系数应采用()土体所受的前期固结压力比目前压力大时,称为()。变水头实验#
常水头实验
井孔抽水实验
井孔注水试验正常固结土
欠固结土
超固结土#
微欠固结土
- 粘土的结构一般为()。单粒结构
层理结构
絮状结构#
蜂窝结构
- 土的结构划分中不包括()。单粒结构
蜂窝结构
絮状结构
层理结构#
- 在下列指标中,不可能大于1的指标是()。含水量
孔隙比
液性指数
饱和度#
- 测得某砂的最大、最小及天然状态的孔隙比分别为0.85、0.62、0.71,其相对密实度为()kg。0.39
0.41
0.51
0.61#
- 一块1kg的土样,置放一段时间后,含水量由25%下降到20%,则土中的水减少了()kg。0.06
0.05
0.04#
0.03
- 在下列指标中,不能直接测定,只能换算求的是()。土体所受的前期固结压力比目前压力大时,称为()。地基表面作用着均匀满布荷载,由此可知,随着深度的增加,地基中的()。天然容重
土粒相对密度
含水量
孔隙比#正常固
- 含水率的意义是()关于地基稳定分析的下列几个概念中,有一个是错的,在荷载作用一段时间后,测得该点的孔隙水压力为30kPa,则此时由附加应力引起的有效应力为()单位体积土体内所含水的质量
单位孔隙体积内所含水的质
- 下列说法不正确的是()。结合水与自由水相比,对土性质影响较大的是结合水
自由水按其移动所受作用力的不同可以分为重力水和毛细水
层理构造是土的构造最主要的特征
对土中气体而言,连通气体对土性质的影响大于封闭
- 下列说法不正确的是()。自由水按其移动所受作用力的不同可以分为重力水和毛细水
结合水与自由水相比,对土性质影响较大的是结合水#
裂隙性是土的构造最主要的特征
对土中气体而言,连通气体对土性质的影响小于封闭气
- 下面有关自重应力的描述不正确的是()。在求地下水位以下的自重应力时,应取其有效重度计算
自重应力随深度的增加而增大
地下水位以下的同一土的自重应力按直线变化,或按折线变化#
土的自重应力分布曲线是一条折线,
- 关于粒度成分分布曲线正确的是()。粒度成分分布曲线可以大致判断土粒的均匀程度和级配好坏#
粒度成分分布曲线较陡,表示粒径大小相差较大,土粒较不均匀,级配良好
粒度成分分布曲线平缓的土样比粒度成分分布曲线较陡
- 地基中,地下水位的变化,会引起地基中的自重应力()。软土不具有的特性是()增大
减小
不变
可能增大,也可能减小#孔隙比打
透水性大#
含水量高
压缩性大
- 土的压缩系数越______、压缩模量越______,土的压缩性就越大()。高,低#
低,高
高,高
低,低
- 饱和土的固结是()的过程。孔隙水压力增大、有效应力增大
孔隙水压力增大、有效应力减小
孔隙水压力减小、有效应力减小
孔隙水压力减小、有效应力增大#
- 有A、B两土样,其中A的压缩性大于B的压缩性,则有()。渗透力(动水压力)为()。土样B的压缩曲线陡
土样A的压缩系数小
土样A的压缩模量小#
土样B易产生变形单位面积力
体积力#
单位长度
恒定值
- 有两个不同的基础,其基础总压力相同,在同一深度处()。宽度小的基础产生的附加应力大
两个基础产生的附加应力相等
宽度大的基础产生的附加应力大#
不能确定
- 有A、B两土样,其中A的压缩性大于B的压缩性,则有()。设地基(完全饱和)中某点的附加应力为100kPa,在荷载作用一段时间后,测得该点的孔隙水压力为30kPa,则此时由附加应力引起的有效应力为()土样B的压缩曲线陡
土样
- 分层总和法计算存在软弱土层时,地基压缩层计算深度的确定条件是()。淤泥类土的特点有()0.4b(基底宽度)
5m
0.1zcz#
0.2zcz高孔隙比,饱水#
透水性极弱#
高压缩性#
抗剪强度低#
- 测得某砂的最大、最小及天然状态的孔隙比分别为0.85、0.62、0.71,其相对密实度为()kg。室内测定渗透系数很小,流经试样水量较少的粘土渗透系数应采用()0.39
0.41
0.51
0.61#变水头实验#
常水头实验
井孔抽水实验
- 超固结土是指土体()粉土的结构一般为()。受到一超荷载
当前有效应力小于前期固结压力#
固结压力超过了土体承受能力
固结时间超过了预定单粒结构
层理结构
絮状结构
蜂窝结构#
- 分层总和法计算无软弱土层时,地基压缩层计算深度的确定条件是()。0.4b(基底宽度)
5m
0.1zcz
0.2zcz#
- 土的压缩系数a1-2是()。e-p曲线上压力p为100和200kPa对应的割线的斜率#
e-p曲线上任意两点的割线的斜率
e-p曲线上1和2点对应的割线的斜率
e-lgp曲线上的直线段得斜率
- 有A、B两土样,其中A的压缩性大于B的压缩性,则有()。土样B的压缩曲线陡
土样A的压缩系数小
土样A的压缩模量小#
土样B易产生变形
- 土体所受的前期固结压力比目前压力大时,称为()。正常固结土
欠固结土
超固结土#
微欠固结土
- 相同固结度时,单面排水的时间是双面排水时间的()。2倍
4倍
1/2
1/4#
- 挡土墙在填土自重作用下向前移动,其可能产生的土压力是()。有A、B两土样,其中A的压缩性大于B的压缩性,则有()。在下列指标中,不可能大于1的指标是()。主动土压力#
被动土压力
静止土压力
不确定土样B的压缩曲线
- 无侧向变形条件下,土的应力与应变之比为()。压缩模量#
变形模量
弹性模量
杨氏模量
- 用角点法计算均布荷载中点下竖向附加应力时,当/0zb,查表得到附加应力系数应是()。室内测定渗透系数很小,流经试样水量较少的粘土渗透系数应采用()设地基(完全饱和)中某点的附加应力为100kPa,在荷载作用一段时
- 在处理软弱土地基时,重锺夯实法的影响深度与()、()、()及土质条件因素有关。渗流的理论平均流速与真实流速相比,()。渗透力(动水压力)为()。锤重、锤底直径、落距平均流速=真实流速
平均流速<真实流速
- 在处理软弱土地基时,换土垫层法适用于淤泥、()、()、()、()、()、()、暗塘等浅层处理的土质。饱和土的固结是()的过程。淤泥质土、湿陷性黄土、膨胀土、素填土、杂填土、季节性冻土及暗沟孔隙水压力增
- 软土具有的工程特性是:含水量高,孔隙比大、()、()、()、具有明显结构性和流变性。渗流的理论平均流速与真实流速相比,()。压缩性高、抗剪强度低、渗透性差平均流速=真实流速
平均流速<真实流速#
平均流速
- 按设置效应可将桩分为三大类,分别是()、()和挤土桩。非挤土桩、小量挤土桩
- 桩基础的设计内容有七项,分别是:确定桩的类型、截面尺寸,初步选择事出有因台底面的标高、()、()、()、()、()、绘制桩基础施工详图。确定单桩承载力、估算桩数并确定其在平面上的布置、桩基础受力计算、桩
- 挡土墙设计的内容包括()、()、()、墙身材料强度验算及构造要求和措施。关于土坡稳定分析瑞典条分法,下列条目中只有()是正确的相同固结度时,单面排水的时间是双面排水时间的()。墙型选择、稳定性验算、地基
- 朗金土压力理论的假设是()、()、()和填土面水平。用角点法计算均布荷载中点下竖向附加应力时,当/0zb,查表得到附加应力系数应是()。墙为刚体、墙背竖直、光滑0
0.25#
0.5
1.0
- 超固结土是指土体()有A、B两土样,其中A的压缩性大于B的压缩性,则有()。室内测定渗透系数很小,流经试样水量较少的粘土渗透系数应采用()在粉土中,当渗透力(动水压力)()土的有效重度时,会发生流砂现象。受到