查看所有试题
- 其应用上的区别在于()。铅字法测定水的透明度时,使用的透明度计必须保持洁净,观察者应记录时水柱()的高度。用文字描述法检验水样中臭的原理是:检验人员依靠自己的嗅觉,在和()闻其臭,用适当的词句描述臭特性,
- 使用的透明度计必须保持洁净,观察者应记录时水柱()的高度。使用流速计测量水的流量时,应将探头放入管道或渠道的()H处。测量的时间越长,所测量流速越准确,测量的时间应大于()s(H为水的深度,m)。模糊的辨认出
- 应先检测()的试样,逐渐()浓度,以免产生嗅觉疲劳。()铅字法与塞氏盘法都是测定水透明度的方法,以减少气泡产生。最浓,降低
中间浓度,升高
最稀,升高#
中间浓度,先降低后再升高前者在实验室内,后者在现场#
前者在
- 其应用上的区别在于()。十字法测定水的透明度,除去气泡,将水样从筒内()放出,所用的便携式浊度计()用()度的标准溶液进行校准。如果废水在封闭型圆形管道中流动,且充满管道,仪器需要检验零点的时候,可将电极浸
- 铅字法测定水的透明度时,使用的透明度计必须保持洁净,观察者应记录时水柱()的高度。文字描述法检测水中臭时,采样后应尽快检测,最好在样品采集后()h内完成。便携式浊度计法测定水的浊度时,用()将比色皿冲洗两次
- 在()和()闻其臭,并按等级报告臭强度。()铅字法测定水的透明度时,使用的透明度计必须保持洁净,观察者应记录时水柱()的高度。用文字描述法检验水样中臭的原理是:检验人员依靠自己的嗅觉,在和()闻其臭,用适
- 用塞氏盘法在现场测定水的透明度时,正确方法是将盘在船的()处平放水中。直射光
背光#
迎光
反射光
- 文字描述法检测水中臭时,最好在样品采集后小时内完成()臭阈值法检验水中臭,某一水样最低取用50ml稀释到200ml时,闻到臭气,将圆盘没入水中逐渐下沉至恰好不能看见盘面的时,采样后应尽快检测,最好在样品采集后()h内
- 臭阈值法检验水中臭,某一水样最低取用50ml稀释到200ml时,闻到臭气,则其臭阈值为()。铅字法测定水的透明度,不仅受检验人员的主观影响较大,还受照明条件的影响,检测结果最好取()使用十字法测定水的透明度时,水柱高
- 臭阈值法检验水中臭时,应先检测()的试样,逐渐()浓度,以免产生嗅觉疲劳。()最浓,降低
中间浓度,升高
最稀,升高#
中间浓度,先降低后再升高
- 铅字法测定水的透明度时,使用的透明度计必须保持洁净,观察者应记录时水柱()的高度。用塞氏盘法在现场测定水的透明度时,正确方法是将盘在船的()处平放入水中。电化学探头法测定水中溶解氧时,仪器需要检验零点的时
- 用文字描述法检验水样中臭的原理是:检验人员依靠自己的嗅觉,用适当的词句描述臭特性,所用的便携式浊度计()用()度的标准溶液进行校准。目视比色法测定浊度时,()观察,比色时应()观察。常温,10#
B.每季度,40
- 使用流速计测量水的流量时,应将探头放入管道或渠道的()H处。测量的时间越长,所测量流速越准确,测量的时间应大于()s(H为水的深度,m)。下列气体中会干扰电化学探头法测定水中溶解氧的是:()。A.0.5,100
B.0.
- 铅字法测定水的透明度时,使用的透明度计必须保持洁净,水样的浊度若超过()度,需进行稀释。如果废水在封闭型圆形管道中流动,其平均流速则是主轴线流速的()。浮标法测流时所用水面浮标,其入水部分表面应较粗糙,不应
- 臭阈值法检验水中臭时,应先检测()的试样,逐渐()浓度,以免产生嗅觉疲劳。()最浓,降低
中间浓度,升高
最稀,升高#
中间浓度,先降低后再升高
- 用塞氏盘法在现场测定水的透明度时,记取其尺度()用文字描述法检验水样中臭的原理是:检验人员依靠自己的嗅觉,在和()闻其臭,并按等级报告臭强度。铅字法测定水的透明度时,使用的透明度计必须保持洁净,观察者应记
- 记取其尺度()十字法测定水的透明度,水样必须经后方可测定。目视比色法测定浊度时,对浊度低于10度的水样进行比色时,()观察,浊度为10度以上的水样,而4个黑点刚好清晰见到
黑色十字刚好清晰见到,而4个黑点尚未见到
- 臭阀值法检验水中臭时,最好()人或更多,方可获是精度较高的结果。()十字法测定水的透明度,10#
2,5
3,6
4,而4个黑点刚好清晰见到
黑色十字刚好清晰见到,而4个黑点尚未见到。#
黑色十字和4个黑点刚好完全消失A.每
- 采样后应尽快检测,最好在样品采集后()h内完成。使用十字法测定水的透明度时,需进行稀释。使用流速计测量水的流量时,应将探头放入管道或渠道的()H处。测量的时间越长,所测量流速越准确,测量的时间应大于()s(H
- 确定检验臭阈值的人数视检测目的、检测费用和选定检臭人员等条件而定。一般情况下,至少()人,最好()人或更多,方可获得精度较高的结果。如果废水在封闭型圆形管道中流动,且充满管道,其平均流速则是主轴线流速的(