【名词&注释】
工作压力(working pressure)、喷油泵(fuel injection pump)、轮机员(engineer)、生产厂家(manufacturer)、水蒸气分压(steam partial pressure)
[单选题]废气锅炉出口排烟温度t2不应低于露点,排气露点与()有关。Ⅰ.废气锅炉蒸汽工作压力;Ⅱ.燃油的含硫量;Ⅲ.排气中的水蒸气分压(steam partial pressure)
A. Ⅰ+Ⅱ
B. Ⅱ+Ⅲ
C. Ⅰ+Ⅲ
D. Ⅰ+Ⅱ+Ⅲ
查看答案&解析
查看所有试题
学习资料:
[单选题]在重新组装回油孔调节式喷油泵时,为了保证齿条刻度指示的零位与柱塞套筒的实际零位(油泵柱塞直槽对准套筒上的回油孔)一致,生产厂家在()之间做了对中记号,轮机员必须将两者对齐。
A. 齿条和齿套
B. 柱塞和套筒
C. 齿条与泵体
D. 齿条与套筒
[单选题]船轴表面裂纹可采用()进行无损检测。Ⅰ.着色探伤;Ⅱ.煤油-白粉;Ⅲ.磁粉探伤;Ⅳ.超声波探伤;Ⅴ.X射线探伤。
A. Ⅱ+Ⅲ
B. Ⅰ+Ⅲ
C. Ⅰ+Ⅲ+Ⅴ
D. Ⅰ+Ⅱ+Ⅲ
[单选题]It is necessary to remove () from the cooling spaces.
A. scar
B. scale
C. spur
D. bilge
[单选题]The cleaned heated oil, after passing through the centrifuges, is to be pumped to a ().
A. settling tank
B. service tank
C. ballast tank
D. drain tank
[单选题]Which of the following can be obtained by means of an indicator card?()
A. the peak pressure in a cylinder
B. the temperature of the cooling water
C. the fuel consumption
D. none of the above
[单选题]With the crank in position in the engine, some measurements can be taken by a special bridge gauge and ().
A. a micrometer
B. a bowl
C. a feeler gauge
D. a wrench
本文链接:https://www.51bdks.net/show/6vw8x0.html