查看所有试题
- 真空激光准直管道内的气压一般控制在()以下,并应按此要求选择真空泵和确定允许漏气速率。A、1MPa;
B、1kPa;
C、88Pa;
D、66Pa。#
- 一支钢弦式位移计,埋在洞室围岩中,测得读数1250Hz,开挖放炮时电缆被打断,如果该仪器工作正常立刻认真地接好后重读,结果测得的读数()。在岩质边坡上埋设测斜管,埋设深度宜超过预计最深位移带()。A、不变;
B、忽
- 两个物体相对滑动时会产生摩擦力,这个力的方向()。与岩土工程所处的自然环境有关的外部物理事件,主要有地震、水文、()、地层错位等。A、与滑动方向一致;
B、与滑动方向相反;#
C、与接触面垂直;
D、与接触面平
- 在重力坝观测坝段的中心断面上,温度计宜采用网格状布置,网格间距离为()。监测工程合同实施中,合同的变更一般由()编制,并通过一定方式向承包商下达。A、3~5m;
B、5~8m;
C、8~15m;#
D、15~25m。A、业主;
B
- 根据地下洞室围岩的位移判断它不稳定的主要依据是()。A、位移值超过200mm;
B、位移值超过500mm;
C、位移速率越来越大;#
D、位移速率越来越小。
- 在大坝垂直位移观测时,用三角高程测量方法,其推算高程的边长不应大于600m,每条边的中误差不应大于()mm。A、0.5;
B、1.0;
C、3.0;#
D、5.0。
- 安装自动化监测系统的硬件和软件,应()。A、能代替手工作业;
B、能兼容各类传感器;#
C、能检测全部钢弦式仪器;
D、能检测全部电阻式仪器。
- 在Windows98中,显示在窗口最顶部的称为()。混凝土坝在水库第一次蓄水期,其观测次数:对水平位移和垂直位移规定为()。A、标题栏;#
B、信息栏;
C、菜单栏;
D、工具栏。A、2~3次/天;
B、1次/天~1次/旬;#
- 在严寒地区,混凝土大坝坝体的应变计组的位置应()冰冻深度。纵缝附近的测点距离纵缝为A、。A、大于,1~1.5m;#
B、大于,2~3m;
C、小于,1.5~2m;
D、小于,2~3m。
- 高混凝土坝,对库水位温度观测点的布置,从库水位到死水位以下10m处的范围内,每隔()宜布置一个测点。A、3~5m;#
B、6~8m;
C、8~10m;
D、10~12m。
- 埋设在混凝土坝坝基岩体中的单管式测压管,孔深离建基面应不大于()。A、1m;#
B、2m;
C、3m;
D、5m。
- 在大坝垂直位移观测时,用三角高程测量方法,其推算高程的边长不应大于600m,每条边的中误差不应大于()mm。A、0.5;
B、1.0;
C、3.0;#
D、5.0。
- 办公软件Excel的三个主要功能是:电子表格、()和数据库。A、文件输入;
B、文字输入;
C、公式计算;#
D、公式输入。
- 监测工程合同实施中,合同的变更一般由()编制,并通过一定方式向承包商下达。岩体水压法变形试验的目的是为了求得岩体的()和变形模量E等设计参数。A、业主;
B、监理工程师;#
C、设计代表;
D、质量监督机构。A、
- 真空激光准直管道内的气压一般控制在()以下,并应按此要求选择真空泵和确定允许漏气速率。在岩质边坡上埋设测斜管,埋设深度宜超过预计最深位移带()。A、1MPa;
B、1kPa;
C、88Pa;
D、66Pa。#A、5m;#
B、4m;
C
- 钢筋计R-25的检验(率定),规范规定测点数(),间距。拱坝应加强对()坝高处的地震反应观测。倒垂线钻孔深度宜参照坝工设计计算结果,达到变形可忽略不计外处,当缺少计算结果时,可取坝高的()。岩体水压法变形试验
- 监测工程合同实施中,合同的变更一般由()编制,并通过一定方式向承包商下达。在岩质边坡上埋设测斜管,埋设深度宜超过预计最深位移带()。A、业主;
B、监理工程师;#
C、设计代表;
D、质量监督机构。A、5m;#
B、4
- 引张线的设备应包括端点装置,测点装置,()及其保护管。安装自动化监测系统的硬件和软件,应()。量水堰应设在排水沟的直线段,堰身采用矩形断面,其长度大于堰上最大水头的7倍,且总长不得小于()。A、定位卡;
B、滑
- 监测系统的控制单元,对混凝土坝而言,应控制混凝土与岩石接合面,(),坝体结构,接缝。岩体水压法变形试验的目的是为了求得岩体的()和变形模量E等设计参数。A、上游防水面;
B、基础岩体;#
C、反滤设施;
D、加固结