查看所有试题
- 关于车身倾斜的原因。甲认为:单侧悬挂弹簧弹力不足是其中之一。乙认为:轮胎气压不平衡只是引起上述故障的原因。丙认为:减振器损坏是其中之一。看法正确的是()。活塞敲缸是指工作行程开始的瞬间(或当活塞上行时
- 汽油抗爆性能的好坏,决定于汽油的()。住东风EQ109O型汽车离合器盖用钢板冲压而成,在其侧面气飞轮接触处开有四个缺口,这四个缺口主要作用是()。加速阀装在制动阀到制动气室的管路上作用是()。节温器不能正常关
- 驾驶员技术水平与行车安全()a)驾驶员技术水平高低是衡量驾驶员素质的重要条件。b)驾驶员要有扎实的基本功c)驾驶员要有良好的车感d)驾驶员要有良好的应变能力许多新型蓄电池可通过观察加液孔盖内的颜色判断蓄电
- 一般水冷发动机的正常工作温度是80℃~90℃,低于或高于这个温度都会使耗油()。与机械变速器相比,()不是自动变速器的特点。增加#
降低
不变维修简单#
加工工艺复杂
传动效率低
汽车的操纵性和安全性好
- 视图主要用于表达机件的外部形状,其中经常使用的基本视图为:主视图、()和左视图。电动势由线圈本身的电流变化所引起的感应叫自感电动势,其方向用()来确定。汽车维护的间隔里程:通常一级维护为()km;二级维护
- 位于较深孔处的螺母和螺栓可用()扳手装拆。东风EQ1092型汽车的后桥,属于()。汽车在中、高速或某一较高转速时,出现行驶不稳,严重时转向盘有振手的感觉故障现象是()。用剖切平面局部地剖开机件所得到的剖视图,叫
- 二冲程汽油机气缸上有进气孔,排气孔和()三个孔,通过这些孔来完成进气、压缩、作功和排气过程。爱岗敬业具体要求是树立职业思想、强化职业责任、()。装备ABS系统的汽车,紧急制动时驾驶员应该()。通气孔
空气孔
- 百分表的小指针可指示()。在用最高设计车速小于70km/h的汽车,四灯制前照灯远光光束发光强度应达到()坎德拉。离合器()会加速分离轴承老化并产生噪音。A、大指针转过的格数
B、大指针转过的圈数#
C、小指针转过
- 驶出高速公路时,要观察路面情况,打开(),进入辅路。当出现发动机点火系工作正常而发动机不能启动或发动机能启动,工作时明显动力不足,减少空气量不见好转且导致发动机熄火现象时的故障可能是()。拉起驻车制动手柄
- 关于自动变速器液压油,下列()是错误的。A、自动变速器液压油高度检查必须在常温下进行#
B、自动变速器液压油高度检查前应使发动机怠速运转一段时间
C、自动变速器液压油液面高度热态比凉态高
D、液面高度检查前,在
- 汽车发动机起动系一般由起动机,控制继电器,()等组成。根据欧姆定律:当电压不变时,电阻()。A、点火开关#
B、发电机
C、电压调节器
D、硅二极管整流器越大,电流不变
不变,电流越大
越大,电流越大
越小,电流越大#
- 关于万向传动装置抖动的原因。甲认为:万向节十字轴装配过紧,转动不良是其中之一。乙认为:中间支撑轴承支架安装偏斜,轴承调整不当是其中之一。丙认为:只有传动轴动不平衡是其原因。看法正确的是()。表示磁场内各
- ()是气压制动跑偏的原因。气门提前开启角是指气门在上止点前开启时,与之相对应的()转角。千分尺是一种精密量具,其测量精度为()mm。车轮定位角失准不可能造成()。A、制动总泵.制动踏板行程调整不当
B、空气压
- ()是目前国内外汽车应用最广泛的一种转向器。冰雪道路驾驶对轮胎的要求是()。起动机组装后,应()。变速器操纵机构的检查:拆下变速器盖,清洗干净,将变速器盖固定在台虎钳上,当某一变速叉已在档位上时推动另一变
- 化油器式汽油机可燃混合气形成装置主要是指()。在空气制动式主供油装臵中,将极少量的空气引人到化油器空气室中降低了()处的压力差,从而降低了汽油的流速和流量。若汽车在行驶中发现发动机突然过热,且踩下加速踏
- 关于汽车维护目的,说法正确的是()。在匀强磁场中运动的直导体产生的感应电动势的方向是从()电位。在前轮定位中,为提高车轮直线行驶的稳定性及转向轻便,在设计上叫做()。A、及时发现和消除故障.隐患
B、恢复汽
- 汽车前轮定位中的车轮外倾的作用是()。()不是变速器漏油的原因。过量空气系数等于()时,火焰传播速率最高,燃烧速度最快,发动机的功率最大,因而称这种混合气为功率混合气。A、使转向轮自动回正,转向操纵轻便
B、
- 尺寸数字一般标注在(),也允许注写在尺寸线的中断处。欧姆定律中,当电压不变时,电阻(),电流()。()是车辆涉水前最重要的准备工作。尺寸界线上方
尺寸界线下方
尺寸线的上方#越大;不变
不变;越大
越大;越大
- 上下渡船应()美国对营运司机的要求及检查方法采用“七步检查法”。首先是()多缸发动机排列形式有单列式、对置式和()三种。柴油发动机要求凸轮轴与曲轴正时装配外,还要求()与其正时装配。A、高速
B、加速
C、低
- ()是制动甩尾的原因。对于动力转向系统,汽车每行驶15000Km时,应()。在行驶期间发现车辆无法摘挡,驾驶员应()。A、制动阀调整不当
B、两前轮车轮制动器间隙不一致
C、车架变形,前轴位移
D、后桥悬架弹簧弹力不一
- ()不是活塞头部的主要作用。()不是电控发动机怠速控制系统中的装置或部件。汽车空调系统的维护,从储液干燥器视液镜往下看,若看不到气泡,则表示系统内()。承受气体压力、并传给连杆
承受侧压力#
与活塞环一起实
- 曲轴的平衡重用来平衡由连杆轴颈、曲柄等回转零件所引起()。汽油机不易起动,着火后又逐渐熄火,一般属()故障。新车走合期结束后,必须遵照工厂的规定进行保养,并同时更换()。散热器表面脏污会导致()。轴向力
- EFI系统按进气量检测方式可分为()两种。蓄电池主要由()组成。直列六缸四冲程发动机,当第一缸工作时(0-180°),第二缸的位置是(发火顺序1-5-3-6-2-4)()。A、直接向气缸内喷射装置或向进气歧管内喷射装置
B、
- ()的可燃气根本不能燃烧,发动机会熄火。汽车发动机一个工作循环曲轴旋转720°,凸轮轴旋转()。当汽车发电机电压高于蓄电池额定电压14V时,触点式电压调节器磁化线圈的电磁力矩()弹簧弹力矩,触点()。山路行车之
- 变速器中,一般()的传动比最大。汽车的四漏现象是指:()。()不属于交通事故的特征。A、超速挡
B、高速挡
C、低速挡
D、倒挡#漏冷却水,漏电解液,漏润滑脂
漏电解液,漏冷却液,漏空调制冷液
漏机油,漏燃油,漏电解
- 两侧车轮各自独立地通过弹性元件与车架相连,当一侧车轮跳动时,另一侧车轮不受影响,属于()类型。在发动机怠速运转的情况下,拔下某缸喷油器线束,若发动机的转速无明显的变化,则说明()。()不是电控发动机怠速控制
- 夜间使用灯光的时间一般与城市路灯开熄时间一致,灯光需照出30m以外.车速超过30Km/h时,应使用()。汽车小修是指保证或恢复车辆工作能力的()修理。塞尺又称厚薄规,用来测量()。在用最高设计车速小于70km/h的汽车,
- 关于发动机怠速不稳定,运转自动熄火的原因,下列说法不正确的是()。()用来测量工件或材料的长度.宽度和厚度。根据需要合理确定转弯路线、行车速度和转向时机,做到()甲说:制动管路漏油会造成制动失效;乙说:制
- 前驱动轿车的半轴上均安装()万向节。下列()不是行驶中有撞击声或异响的原因。散热器的作用是将发动机水套内流出水的热量传递给()。下列行车方式中,不受建制限制,便于挖掘运输潜力,但不便于管理的是()。A、普
- 柴油机运转均匀,急加速时转速不能提高,排气管排出少量黑烟。下列()不是其原因。行车安全的首要条件()汽车上装差速器后,转弯时可以使内侧车轮转矩(),外侧车轮转速()。装配图的()注明了机器或部件的名称、比
- 对新车或大修后的汽车要进行()。延长轮胎使用寿命的最有效措施是保持最适宜的()。热线式空气流量计自洁电路的检查:起动发动机并加速到2500r/min以上,使发动机怠速运转,关闭点火开关,从流量计入口处观察流量计内
- 关于我国现行的汽车维护原则,甲说:“预防为主,强制维护”;乙说:“预防为主,定期检测”;说法正确的是()。活塞销的两端在活塞销座内能自由转动,中部与连杆小头固定连接,这种连接称为()。气缸体和气缸盖均是铝合金