查看所有试题
- 患者,男,45岁,左上第一磨牙隐裂致急性牙髓炎完善根管治疗后,检查发现后牙咬合紧磨耗重,临床牙冠短小。口腔医师嘱某患者下颌自然闭合到与上颌牙齿接触,并紧咬,口内检查见所有牙都保持接触,试问此时这个患者下颌所处的
- 患者,50岁,下颌可摘局部义齿修复后初戴3天,咀嚼食物有痛感,口内检查:活动义齿修复,右下颌舌骨嵴隆突处黏膜有溃疡点。造成摘戴义齿疼痛的原因是()患者,左侧牙齿均无接触,右侧上下颌的前磨牙和磨牙都有接触,这种情
- 患者,男,70岁,无牙颌。上颌牙槽嵴吸收较少,有一定的高度和宽度,形态丰满;下颌牙槽嵴高度明显降低,大部分吸收而低平。贵金属材料制作铸造金属全冠相对于镍铬合金而言,不包括()A生物相容性更高
材料化学稳定性更高
- 患者,男,11岁。左上1牙颈部冠折,已行根管治疗。关于覆盖义齿附着体叙述错误的是()E制作简单易于维修#
费用较高
义齿局部基托变薄易折裂
颌间距离有限时排牙困难
对口腔卫生维护要求较高
- 下面不是铸造金属全冠牙体预备的要求的是()利用牙尖斜面的解剖形态诱导下颌滑动到特定的治疗颌位的垫是()轴面预备后相互形成6°的内聚角
轴面预备后无倒凹
面预备应与面解剖外形相一致
颈部形成1mm以上的斜面肩台
- 患者,双侧下后牙缺失,戴可摘局部义齿1周后,咀嚼食物时,右缺隙侧与基托吻合部黏膜出现灼痛,局部黏膜有红肿、溃烂,停止戴义齿后症状缓解,再次使用出现同样症状。覆盖义齿双层顶盖间内外层间隙常规保留约()['解决方案
- 局部义齿支托的作用,下列不正确的是()不可能造成铸造支架式义齿就位困难的是()稳定
支持
可防止向脱位#
可防止食物嵌塞
恢复咬合琼脂印模质量不好
高温包埋材料的热膨胀系数不够
模型有缺损
开时用力过大
戴义齿
- 牙龈会因失去食物按摩而废用萎缩是由于()外伤性牙折伴牙周膜挤压伤或撕裂伤者,可能有根尖周反应,根充后应至少观察()['牙冠轴面突度过大#
牙冠轴面突度过小
牙冠轴面无突度
牙冠外展隙过小
牙冠面食物排溢道不明
- 患者,男,摘戴义齿时疼痛明显,口内检查:活动义齿修复,基牙稳固,义齿固位性及稳定性好,咬合接触良好,右下颌舌骨嵴隆突处黏膜有溃疡点。造成摘戴义齿疼痛的原因是()前腭杆的前缘应()咬合压力过大
卡环固位过紧
基
- 以下关于缓冲型和非缓冲型冠外附着体的描述,错误的是()人工解剖式牙牙尖斜度为()非缓冲型冠外附着体常需采用两个或多个基牙形成联冠
采用缓冲型冠外附着体的义齿戴入后,允许义齿在各方向上有轻微的运动
缓冲型冠
- 女,67岁,出现上唇牵拉疼痛,右侧时有咬颊黏膜,上颌颊黏膜转折处可见约2~3mm大小的溃疡面,右侧颊黏膜见2mm大小的血肿,下颌为双侧游离端义齿,侧向咬合时,工作侧出现早接触,余无异常。可摘局部义齿蜡型的要求
- 患者,男,56岁,下颌剩余右侧54,和左侧234。其中右侧4松动Ⅱ度,近中倾斜并向对颌伸长,X线片示剩余根长10~15mm,近中倾斜,向对颌伸长,牙槽骨吸收至根中1/3。烤瓷熔附金属全冠的遮色瓷厚度应掌握在()B越薄越好
越厚越
- 下列说法错误的是()患者,全身状况良好,无义齿修复史。左下6拔除1年。要求做固定修复。检查:左下6缺失,近中舌尖缺失,髓腔暴露,内干尸治疗,大面积银汞充填。余牙良好。拍片示:左下7髓室内白色致密影,残冠,根尖无异
- 患者右下7近中面龋坏,去尽腐质未及髓,牙髓活力测试反应正常,临床牙冠较短。基牙间的分散程度可以增强义齿的固位作用,因为()B基牙越分散,倒凹的深度越大
基牙越集中,各固位体间的相互制约作用越强
基牙越分散,倒凹
- 活髓牙制作烤瓷熔附金属全冠的牙体预备要预防穿髓,上颌第一磨牙髓角的高度是()患者戴下颌义齿后,出现咬舌现象,分析原因是()近中舌侧髓角最高
近中颊侧髓角最高#
远中舌侧髓角最高
远中颊侧髓角最高
四个髓角高度
- 患者,男,40岁,以左侧后牙修复后不适1个月,自发痛3天求诊。检查发现患者牙列完整,除左上第一磨牙铸造金属全冠修复外,36岁,右下456缺失,口内其余余留牙健康。设计可摘局部义齿。支点线最好设计成()A斜线式
直线式
横
- 患者,60岁,口内检查缺失,对颌为天然牙,无,设计义齿为混合支持式可摘局部义齿,进行性加重。复诊检查剩余牙槽嵴大面积压痕,卡环固位可,咬合接触密合。铸造金属全冠修复后出现基牙疼痛,一定要拆除的原因是()B咬合早接
- 4个月前因牙周病拔除,女,今要求烤瓷桥修复。口腔检查:右上中切牙缺失,牙槽嵴高度无明显异常,较平整。左上中切牙近中切角缺损,未露髓,叩诊阴性,无松动。上下前牙牙龈轻度红肿,易出血,余牙未见明显异常。对半卡环
联