查看所有试题
- 固定义齿修复中,基牙倾斜角度较大时,可采用以下设计获得共同就位道,除外()系统病史的内容不包括()A.改良3/4冠固位体B.桩核冠固位体C.套筒冠固位体D.半固定桥E.增加基牙A.有无药物过敏史B.修复治疗情况C.是否患
- 固定桥的基牙牙槽骨吸收不能超过根长的()与义齿吸附力无关的因素是()1/5
1/4
1/3#
1/2
2/3基托材料#
基托与黏膜的接触面积
瓷牙
金属牙合
- 正常覆盖时,上颌前牙切缘咬在下颌前牙唇面的距离是()锤造冠就位后邻接关系不良,常见原因有()0mm
3mm以内#
3~5mm
5~7mm
7mm以上代型邻面加蜡过多#
加蜡过少
邻接区以下蜡未内收
相邻牙邻面突度过大
邻牙突度过
- 以下哪条对全冠龈边缘位置设计无影响()固定桥承受力时,桥体会发生弯曲变形,以下正确的是()固位力大小
美观因素
牙龈的保护
边缘密合#
牙体预备操作的难易A.桥体的弯曲变形量与桥体的宽度成反比B.桥体的弯曲变形
- 有关无牙颌全口义齿修复印膜的要求,下列哪项不正确()戴全口义齿出现咬舌现象,需磨改()印模边缘圆钝
上颌后缘的翼上颌切迹
上颌后缘与前颤动线一致#
下颌后缘盖过磨牙后垫
远中舌侧边缘向远中伸展到下颌舌骨后间
- 全口义齿修复应在拔牙多长时间后进行()选色时应首先确定()1周
3周
1个月
3个月#
6个月A.明度B.彩度C.色调D.半透明区的分布及程度E.个性特征
- 女,63岁。戴全口义齿月余,义齿仅在功能状态下易脱落。旧全口义齿无此现象。可能造成义齿固位差的原因是()通常拔牙后,一般多长时间后开始进行固定修复较合适()咬合不平衡#
基托边缘伸展过长
后堤区处理不当
基托
- 患者女56岁,戴全口义齿5天讲话和进食时上下牙有撞击声,是由于()制作套筒冠固位体,依靠内外冠的紧密接触产生固位力的固定桥是()A.前牙排列覆牙合过大B.下颌前伸C.息止牙合间隙过大D.垂直距离过低E.垂直距离过高A.
- 下颌牙列中牙周膜面积最大的是()后堤区的作用是()第三磨牙
第二磨牙
第一磨牙#
第二前磨牙
尖牙基托后缘定位
边缘封闭#
支持
排列后牙的标志
缓冲作用
- 冠桩修复时,桩的直径应为()在残冠或残根上先形成金属桩核或树脂核,然后再制作全冠修复体称()A.根径的1/4B.根径的1/3C.根径的1/2D.根径的2/3E.根径的3/4A.嵌体B.桩冠C.桩核冠D.混合全冠E.部分冠
- 可摘局部义齿在临床上最常用的形式是()无牙颌口腔专项检查的内容()铸造支架式可摘局部义齿
钢丝弯制式可摘局部义齿
牙支持式可摘局部义齿
黏膜支持式可摘局部义齿
混合支持式可摘局部义齿#A.上下颌弓,牙槽嵴大小
- 修复前口腔的一般处理有()颌间距离过小在排牙时错误的是()A.处理急性症状B.保证良好的口腔卫生C.拆除不良修复体D.治疗和控制龋病及牙周病E.以上都对A.磨短,薄上前牙B.大量磨改下前牙C.不磨改下前牙,只使切缘向舌
- 种植义齿修复时,若对颌牙为可摘局部义齿,其咬合应为()一般的全口义齿塑料基托的厚度为()A.组牙功能牙合B.尖牙保护牙合C.平衡牙合D.以上均不可E.以上均可A.0.5~1mmB.1.0mm~1.5mmC.1.5mm~2mmD.2.0~2.5mmE.2.5m
- 桩核冠修复中,对所修复残冠的处理不正确的是()牙体预备的基本要求是()去除薄壁
去除腐质
沿龈乳头顶连线切断#
去除无基釉
尽可能保留残冠硬组织A.开辟修复体所占空间,保证修复体一定的强度、厚度和美观B.预备良
- 舌杆宽度为()属于固定桥冠内固位体的是()A.1~2mmB.3~4mmC.5~6mmD.>6mmE.为下前牙舌侧龋缘至口底距离的1/2金属全冠
烤瓷全冠
3/4冠
针型固位高嵌体#
桩冠
- 关于无牙颌上颌结节的叙述,正确的是()取全口印模时,制作个别托盘的目的是()牙槽嵴两侧的圆形骨突
上颌结节颊侧多有明显倒凹#
义齿基托不应覆盖结节颊面
基托在结节远中尽量伸展
上颌结节是主承托区便于操作
能获