查看所有试题
- 外墙外保温工程技术规程(JGJ144-2004):胶粉EPS颗粒保温浆料保温层设计厚度不宜超过()mm。屋面工程技术规范(GB50345-2012):同一层相邻两幅卷材短边搭接缝错开不应小于()mm。屋面工程质量验收规范(GB50207-
- 屋面工程技术规范(GB50345-2012):板状保温材料进场时应检验的项目有:()屋面工程技术规范(GB50345-2012):铺抹低强度等级砂浆作为隔离层的施工环境温度宜为()℃。屋面工程技术规范(GB50345-2012):使用水
- 外墙外保温工程技术规程(JGJ144-2004):外保温工程施工期间以及完工后()h内,基层及环境空气温度不应低于()℃。屋面工程技术规范(GB50345-2012):保护层的施工环境温度符合规定的有:()屋面工程技术规范(GB
- 外墙外保温工程技术规程(JGJ144-2004):现浇混凝土外墙外保温施工时,混凝土需振捣密实均匀,墙面及接茬处应光滑、平整。屋面工程质量验收规范(GB50207-2012):种植隔热层的屋面坡度大于20%是,瓦头挑出檐口的长度
- 屋面工程技术规范(GB50345-2012):铺抹低强度等级砂浆作为隔离层的施工环境温度宜为()℃。屋面工程技术规范(GB50345-2012):找坡层和找平层的施工环境温度不宜低于()℃。预拌砂浆应用技术规程(JGJ/T223-2010
- 外墙外保温工程技术规程(JGJ144-2004):EPS板现浇混凝土外墙外保温系统现场粘结强度不得小于()MPa,并且破坏部位应位于EPS板内。外墙外保温工程技术规程(JGJ144-2004):具有薄抹面层的外保温系统,抹面层与保温
- 高度宜为建筑物层高。屋面工程质量验收规范(GB50207-2012):喷涂硬泡聚氨酯保温层表面平整度的允许偏差为()mm。预拌砂浆应用技术规程(JGJ/T223-2010):砂浆防水层各层应紧密结合,每层宜连续施工,当需留施工缝
- 外墙外保温工程技术规程(JGJ144-2004):现场取样胶粉EPS颗粒保温浆料干密度不应大于()kg/m3,并且不应小于()kg/m3。外墙外保温工程技术规程(JGJ144-2004):胶粘剂与水泥砂浆的拉伸粘结强度在干燥状态下不得小
- 屋面工程技术规范(GB50345-2012):檐口第一根挂瓦条应保证瓦头出檐口()mm。屋面工程技术规范(GB50345-2012):找坡层和找平层的施工环境温度不宜低于()℃。屋面工程质量验收规范(GB50207-2012):下列金属板
- 外墙外保温工程技术规程(JGJ144-2004):玻纤网经向和纬向耐碱拉伸断裂强力均不得小于(),搭接长度不应小于()砌体结构工程施工质量验收规范(GB50203-2011):不得在下列墙体或部位设置脚手眼()砌体结构工程施
- 屋面工程技术规范(GB50345-2012):檐口第一根挂瓦条应保证瓦头出檐口()mm。屋面工程质量验收规范(GB50207-2012):下列金属板屋面铺装有关尺寸中,叙述正确的有:()。屋面工程质量验收规范(GB50207-2012):
- 空气相对湿度宜小于()%,风速不宜大于三级。自密实混凝土应用技术规程(JGJ/T283-2012):自密实混凝土配合比试配时,当试拌得出的拌合物自密实性能不能满足要求时,应在()不变、胶凝材料用量和外加剂用量合理的原
- 基体或基层的拉伸粘接强度不应小于()MPa。自密实混凝土应用技术规程(JGJ/T283-2012):自密实混凝土宜采用通过增加粉体材料的方法适当增加浆体体积,浇灌芯柱的混凝土,当采用普通混凝土时,每日砌筑高度不宜超过(
- 外墙外保温工程技术规程(JGJ144-2004):胶粉EPS颗粒保温浆料保温层设计厚度不宜超过()mm。屋面工程技术规范(GB50345-2012):屋面工程施工,严禁在()的气候条件下施工。屋面工程技术规范(GB50345-2012):檐
- 屋面工程技术规范(GB50345-2012):屋面两坡最上面的一根挂瓦条,分格缝的宽度宜为()mm。自密实混凝土应用技术规程(JGJ/T283-2012):自密实混凝土拌合物除应满足普通混凝土拌合物对凝结时间、黏聚性和保水性等的
- 屋面工程技术规范(GB50345-2012):屋面工程找坡应按屋面排水方向和设计坡度要求进行,找坡层最薄处厚度不宜小于()mm。屋面工程质量验收规范(GB50207-2012):烧结瓦和混凝土瓦施工,挂瓦条的间距应根据()计算确
- 焊接缝不得有()现象。屋面工程质量验收规范(GB50207-2012):厚度小于()mm的高聚物改性沥青防水卷材,严禁采用热熔法施工。屋面工程质量验收规范(GB50207-2012):板状材料保温层的厚度其正偏差应不限,负偏差应
- 外墙外保温工程技术规程(JGJ144-2004):外墙外保温系统分项工程应以()m2划分一个检验批,不足()m2也应划分为一个检验批。屋面工程技术规范(GB50345-2012):保温材料的贮运、保管应采取()措施,负偏差应为5%,
- 外墙外保温工程技术规程(JGJ144-2004):外墙外保温系统分项工程应以()m2划分一个检验批,不足()m2也应划分为一个检验批。外墙外保温工程技术规程(JGJ144-2004):机械固定系统锚栓、预埋金属固定件数量应通过
- 屋面工程技术规范(GB50345-2012):进场的彩色涂层钢板及钢带应检验()等项目。屋面工程质量验收规范(GB50207-2012):下列分项工程中,属于基层与保护层子分部工程的有:()。屋面工程质量验收规范(GB50207-201
- 外墙外保温工程技术规程(JGJ144-2004):玻纤网经向和纬向耐碱拉伸断裂强力均不得小于(),空气相对湿度宜小于()%,风速不宜大于三级。屋面工程技术规范(GB50345-2012):喷涂硬泡聚氨酯保温层施工,一个作业面应
- 外墙外保温工程技术规程(JGJ144-2004):胶粘剂与水泥砂浆的拉伸粘结强度在干燥状态下不得小于()MPa,浸水48h后不得小于()MPa。屋面工程技术规范(GB50345-2012):金属板屋面的金属板长度应根据()等综合确定
- 外墙外保温工程技术规程(JGJ144-2004):在正确使用和正常维护的条件下,外墙外保温工程的使用年限不应少于()年。外墙外保温工程技术规程(JGJ144-2004):胶粘剂与水泥砂浆的拉伸粘结强度在干燥状态下不得小于(
- 并且破坏部位应位于EPS板内。屋面工程技术规范(GB50345-2012):喷涂硬泡聚氨酯保温层施工环境温度宜为()℃,一个作业面应分遍喷涂完成,每遍喷涂厚度不宜大于()mm,砖过梁底部的模板,方可拆除砌体结构工程施工质量