查看所有试题
- 若电磁换向阀有嗒的一声而无气流声则()。电磁阀是好的而换向阀有故障#
换向阀是好的,电磁阀有故障
电磁阀是好的,换向阀也是好的
电磁阀有故障,换向阀也有故障
- 用普通录音磁带在杜比B型降噪工作状态的录音机中放音会()。超声延时线对色度信号的作用是()。提高倍噪比
使高音变差#
使低音变差
使音质变好把FV,FU信号分离
反相
延时约一行时间
B和C#
- 彩色电视机信号和黑白电视信号的区别是彩色电视信号中有()信号。三基色
三个色差
色同步
色度#
- 为了排除耦合元件对信号传输的不良影响,又能在级间传递直流信号,可将前一级输出端与后一级输入端直接连接。这种耦合方式称()耦合。当TA7343的压控振荡器停振时,故障现象是()。热泵空调制热时的故障现象及判断错
- TA7698的行振荡的振荡频率是()。2450MHZ微波穿透能力为()cm。彩色电视机的色度通道主要由()等电路组成。行频
半行频
二倍行频#
500KHZ1~2
2~4#
4~6
6~8色度带通放大器#
延迟解调器#
G-Y矩阵、副载波产生电
- 欲使某NPN放大管从饱和状态进入放大状态可采取()电阻的方法。减小上偏置
减小下偏置#
减小射极
加大集电极
- 高频电磁灶主要由()组成。空调蒸发器的排管普遍使用叉排方式,使其比顺排()。遥控微处理器的工作电压是由()提供的。图示电路中,电压U=()。防静电腕带使用要求:()加热部分、控制部分和冷却部分
加热部分、
- 自动消磁电路每次自动消磁都要在消磁线圈中产生一个()磁场。目前广范应用的DVI接口是()在注水漂洗过程中,水位超过溢水口高度,显示H21,如何处理?()一台录音机在更换磁头后放音音量比以前小多了:故障通常是由
- TA7680的中放和高放AGC的控制方式是()。ACC电路是()的缩写。全自动波轮洗衣机脱水状态下吱吱声响原因可能是()。将亮度信号延迟0.6μs是为了()中放是正向AGC,高放是反向AGC
中放是反向AGC,高放是正向AGC
均为
- 彩色电视机包含了黑白电视机所没有的特殊电路和器件,主要有()。解码器
高频头
彩色显像管及其附属电路
A和C#
- 全自动洗衣机控制面板在报警状态显示U11表示什么状态()电饭锅中双金属片温控器的控制温度是()()是指“返修”、“返工”或调整和涉及现有的不合格所进行的处置。A、排水不畅通#
B、机盖未关闭
C、衣物偏芯不平衡70℃
- 电源电压不随负载变化的称()。色纯度是指彩色显像管呈现单色光栅的()。TTL电路使用的电源电压VCC=()电压源#
电流源
电源
电压纯净程度#
亮度
色调
色饱和度0.2V
0.8V
3.6V
5V#
- 彩色的色调是由光的()决定的。开关电源中的150μF/400V电容失效的现象是()。微波炉灶门观察窗的玻璃夹层中有()丝网。滚筒洗衣机排水管的设置以下正确的有()幅度
亮度
掺入白光的多少
频率#无光栅无伴音
图像
- 当TA7343的压控振荡器停振时,故障现象是()。全自动波轮洗衣机安全开关判定为机盖打开状态的时间间距为()。全自动波轮洗衣机脱水时,打开机盖在多少秒内脱水桶尚未停止的情况委托维修()如果觉得洗衣结束后的蜂鸣
- 关于电磁换向阀下述不正确的是()。遥控彩色电视机出现无字符显示故障,有可能是()等引起的。用来换切制冷剂流向
用于热泵空调中
电磁线圈断电,电磁阀无法动作
使用电磁阀对系统制冷量无影响#电视机的行场逆程脉冲
- 立体声解码器的输入信号是()信号。当电视机接收()时,ACK电路自动关闭色度通道。使用全自动波轮洗衣机脱水时出现撞桶现象,应首先指导用户检查()。电冰箱中常用的符合石油部标准的冷冻油(润滑油)是()和
差
- 高频电磁灶主要由()组成。磁控管工作时,阴极热丝或直热式阴极灯丝加上约()V电压。以下可以用来洗涤羽绒服的洗衣机是()。加热部分、控制部分和冷却部分
加热部分、控制部分和电路部分
加热部分、冷却部分和电路
- PAL制是逐行倒相的平衡调幅制,其逐行倒相的信号是()信号。电子调速大多利用()的电压导通角的可调性来实现。全自动波轮洗衣机电源线蓝色线与电脑程控器哪根颜色线相连接()一台电视机出现烧“保险管”故障,处理措
- 热泵型空调器除霜的方法是()为了防止潜在的不合格、缺陷或其他不希望的情况发生,消除其原因所采取的措施指()。红外加热
制冷剂放热#
PTC加热
电热丝加热纠正措施
纠正
预防措施#
预防
- 超声延时线对色度信号延迟的精确时间是()μS。全自动洗衣机排水条件不良,排水慢,应指导用户检查()63.943#
63
52
40排水管长度是否超过三米#
排水管端部是否泡在水中#
排水管高度是否超过10CM#
排水管是否被线屑堵
- 在电视系统中,用显像三基色配出1单位白光量的关系式是()。目前广泛使用的彩色显像管是()。自动消磁电路每次自动消磁都要在消磁线圈中产生一个()磁场。图示电路中,电压U=()。Y=0.11R+0.59G+0.30B
Y=0.30R+0.