查看所有试题
- 关于电磁辐射污染环境的特点,以下说法不正确的是()有用信号与污染是共生的
产生污染有可预见性
产生的污染有可控制性
以上说法都不正确#
- 样品在加入硫酸和高氯酸消解时,电热板逐渐升温至(),保持此温度消解,直至完成。试液剧烈沸腾
大量冒白烟#
试液颜色变深
- 试样的铯-137含量表示为()土壤有机质是指土壤中()的总称。Bq/L
Bq/g#
g/kg
g/L含碳化合物#
动植物残体
土壤微生物
- 采集环境空气中颗粒物样品时,采样前应确认采样滤膜无针孔和破损,滤膜的毛面应()。向上#
向下
不分上下
- 色谱柱固定液为苯基(50%)甲基硅酮(OVl7),液相载荷量是()%气相色谱法测定环境空气和废气中二硫化碳时,气相色谱的定量管以及与色谱柱连接的管均采用()管光度法测定土壤和城市生活垃圾中全氮时,在样品消解时,
- 在进行固体废物浸出性毒性测试时,固液比一般为()1∶2
1∶5
1∶10#
1∶20
- 在环境空气监测点采样口周围()空间,环境空气流动不受任何影响。如果采样管的一边靠近建筑物,至少在采样口周围要有()弧形范围的自由空间。A.90°,180°
B.180°,90°
C.270°,180°#
D.180°,270°
- 用气相色谱法定量分析样品组分时,分离度至少为()光度法测定土壤中全氮时,土壤消煮液显()0.50
0.75
1.0#
1.5
1.5碱性
中性
酸性#
- 将采样管后塞侧端与采样泵连接,以()L/min的流速连续采集10~100L样品气体,采样后用硅橡胶塞和密封帽密封采样管两端。0.2~0.3
0.3~0.5
0.5~1.0#
1.0~1.5
- 确定探测器阈电压和工作电压时,“坪”长应()根据《土壤质量六六六和滴滴涕的测定》(GB/T14550-1993)进行测定时,采用的检测器是()大于60V#
小于60V
大于80V
小于80V氮磷检测器
热电导检测器
电子捕获检测器#
火
- 配制标准溶液的亚硝酸钠应预先在()中于燥(),不能直接放在()于燥烘箱,2,干燥器
干燥器,24,烘箱#
干燥器,12,烘箱
- 每一批活性炭采样管对每一化合物的解吸效率都应≥()%。60
70
80#
90
- 当气相色谱的各部温度、气体流量稳定正常,连续两次进同一标准样品2μ1,其峰面积相对偏差≤()%,即可认为仪器处于稳定状态在对水质、土壤等样品中进行有机污染物监测分析时,一般使用正己烷、苯、醚、乙酸乙酯或二氯甲
- 使用的玻璃色谱柱长()m,内径()mm。每一批活性炭采样管对每一化合物的解吸效率都应≥()%。根据《全国土壤污染状况调查样品分析测试技术规定》,采用红外分光光度法测定土壤样品中石油类的溶剂介质为()1,2
2,2
- 测定固定污染源排气中丙烯醛,用校准曲线进行定量分析时,任何一次开机分析样品,都应首先绘制校准曲线,然后每分析5~10个样品插入校准曲线中一个浓度适当的标样,其测定值与原校准曲线中的测定值比较,相对偏差应小于(
- 测定固定污染源排气中丙烯醛,用校准曲线进行定量分析时,任何一次开机分析样品,都应首先绘制校准曲线,然后每分析5~10个样品插入校准曲线中一个浓度适当的标样,其测定值与原校准曲线中的测定值比较,相对偏差应小于(
- 每次采样样品数在10个之内和每10个样品应做一个平行样,平行样的相对偏差应≤()%10
15
20
25#
- 空气API指数为50~100时,对应空气质量等级为()。一级
二级#
三级
四级
- 环境空气质量功能区划中的二类功能区是指()。RAD7测氡仪探测氡气的方法是()A.自然保护区、风景名胜区
B.城镇规划中确定的居住区、商业交通居民混合区、文化区、一般工业区和农村地区#
C.特定工业区
D.一般地