查看所有试题
- 制造误差不直接影响加工精度的刀具是()。外圆车刀#
成型车刀
钻头
拉刀
- 所有电流互感器和电压互感器二次侧都有永久性的,可靠的()保护接地#
重复接地
工作接地
防雷接地
- 对称负载作三角形连接时,线电压UL和相电压Uph的数值关系是()。消弧室的作用()。A、UL=Uph#
B、UL=3Uph
C、Uph=3UL
D、UL=2UphA、减缓冲击力
B、加大电弧
C、储存电弧
D、进行灭弧#
- 人体触电后,触电电流在人体内流通部位不同,造成的危害性也不同,危害最大的是()过电流继电器返回系数()。两足之间
两手之间
同侧手足之间
交叉手足之间#>0.85
≥0.85#
<0.85
≤0.85
- 串联谐振电路易出现()现象。A、过电压#
B、过电流
C、电压
D、电流不变化
- 断路器的分闸时间()的时间接地体的埋设深度,要求应不低于()是从跳闸线圈开始带电到断路器跳闸过程结束所用
是从跳闸线圈开始带电到三相各触头均断开瞬间为止#
是从跳闸线圈带电到断路器主回路电流断开为止
是从
- 按《广东电网公司设备缺陷管理规定》缺陷管理流程,缺陷的降级处理申请应由()填报。配电线路污秽主要是指()的污秽。运行人员
检修人员
部门缺陷管理人员#
部门领导导线
绝缘子#
杆塔
固定线
- 项目施工必须有作业指导书,由施工项目部()交底后实施。作业指导书中的安全技术措施部分必须有独立的章节。技术员#
质量专责
项目经理
造价专责
- 液压传动的断路器给储压筒打油的油泵属于()真空断路器灭弧室的玻璃外壳起()作用离心泵
齿轮泵
柱塞泵#
活塞泵真空密封#
绝缘
灭弧
观看触头
- 大电流接地系统中双母线上两组电压互感器二次绕组应()。采用分裂导线,使得线路电抗()。在各自的中性点接地
选择其中一组接地,另一组经放电间隙接地
均需要经放电间隙接地
只允许有一个公共接地点,其接地点宜在控
- 材料受外力而不破坏或不改变其本身形状的能力叫强度,其单位用()表示。两台变比不同的变压器并联接于同一电源时,由于二次侧()不相等,将导致变压器二次绕组之间产生环流。N/mm#
N/mm
N/m
N绕组感应电动势#
绕组粗
- 发电机短路试验时,当励磁电流为85A时,定子电流为300A,定子电流为600A时,应将励磁电流调整到:()。同样转速的发电机,磁级对数多的,电源频率()。150
170#
300
400A、低
B、高#
C、不变
D、不一定
- 晶闸管可控整流电路中的控制角α减小,则输出的电压平均值会()。A、不变
B、增大#
C、减小
- 电力系统的频率主要决定于()。有功功率的平衡#
无功功率的平衡
电压高低
电流的大小
- 换流站的运行方式()。只能作整流运行;
只能作逆变运行;
即可呈整流运行,也可呈逆变运行;#
还可作其他运行。
- 充干燥气体运输的变压器、电抗器油箱内气体压力应保持为()。重要的500kV及以上电压等级的变电站,在选择直流系统时,应采用()。0.00~0.01MPa
0.01~0.02MPa
0.01~0.03MPa#
0.03~0.05MPa(A)两台充电装置和两组
- 隐蔽工程的检查验收应在()进行在同一电压恒定的电路中,电阻值R增大时,电流就会随之()中间验收检查
竣工验收检查
隐蔽前#
隐蔽后减小#
增大
不变
非线性变化
- 倍容量导线XTACTR-410长期允许载流量约为()(A,+205℃)。800;
1000;
1350;#
2000。
- 《西厢记》中的张生是怎样一个人()诚恳、热情#
“银样蜡枪头”#
始乱佟弃的负心者
志诚种#
- 钳型电流表使用时应先用()。A级绝缘的极限工作温度为()℃。较大量程#
较小量程
最小量程
空量程90;
105;#
130;
155。
- 根据《云南电网发电机组一次调频运行管理规定(试行)》,当电网频率变化达到一次调频动作值到机组负荷开始变化所需的时间为一次调频负荷响应滞后时间,应小于()。A、1s
B、3s#
C、5s
D、7s
- 严禁工作人员或其他人员移动已挂接好的接地线。如需移动时,必须经过()同意并在工作票上注明。变电运行部门应组织()对防误装置相关管理规定进行学习。工作负责人
工作许可人#
其他工作人员
工作监护人变电站运行
- 功率因数表指针在停电后位于()零位置
最大位置
不固定位置#
同一位置
- V.A.G1552是下列哪个公司的专用诊断仪?()宝马公司
奔驰公司
大众公司#
福特公司
- 任何单位和个人不得危害()设施及其有关辅助设施。杆塔设计荷载是()。发电#
公共
变电#
电力线路#风荷载设计值取荷载标准值的1.2倍,垂直荷载设计值取荷载标准值的1.4倍
风荷载设计值取荷载标准值的1.4倍,垂直荷载
- 1000kV变压器、电抗器施加电压前变压器油微水含量不大于()。20L/L
15L/L
10L/L
8L/L#
- 规程规定测量机组空载转速摆动值时,每次测量时间为()。A、1分钟
B、2分钟
C、3分钟#
D、5分钟
- 当两分力的大小一定时,则合力()。大小一定
与两分力的夹角有关#
与两分力的作用点有关
为两分力之和
- A级绝缘的极限工作温度为()℃。90;
105;#
130;
155。
- 按照齿轮运转的圆周速度分,速度小于0.5m/s的属于()。呼吸衰竭患者使用机械通气时()A、低速传动
B、极低速传动#
C、中速传动
D、高速传动若病情继续恶化,应建立人工气道
提倡面罩持续气道内正压(CPAP)联合压力
- 1kgf等于()N8.81
9.81#
10.81
11.2
- 下列选项是监理单位在工程质量通病防治过程中所要做的工作()。由监理人员现场监督某工序全过程完成情况的活动是()。下达工程质量通病防治任务书
审查施工单位质量通病防治措施#
批准施工质量通病防治措施
编写工
- 为增强母线散热条件和减少()的影响,宜采用厚度较薄的矩形母线在R、L、C串联的交流电路中,当总电压相位滞后于电流时,则()趋肤效应#
内阻
功率损失
电压损失XL>XC
XL<XC#
XL=XC
R=XL=XC
- 机组并入系统后,自调节能力增强,为提高调速器的速动性,使其增减负荷迅速,一般可将()切除。永态反馈
局部反馈
暂态反馈#
所有反馈
- 鲜肉剖面为红色并带有各类家畜肉特有的色泽。()A、各类家畜肉#
B、猪肉
C、牛肉
D.羊肉
- 测量高压设备绝缘介质损失角正切值tg,一般使用的试验设备是()。QS1型西林电桥#
欧母表
电压表
兆欧表
- TV二次负载在额定范围内变大时,二次电压()。A、基本不变#
B、变大
C、变小
D、不一定
- 关于旁路隔离开关的闭锁,()是不正确的。线路的旁路隔离开关必须在旁路断路器断开时才可操作
旁路断路器的旁路母线侧隔离开关必须在旁路断路器断开,及连接为母线联络运行的隔离开关打开时,才可操作
旁路断路器的旁
- 美国宪法制定者之一汉密尔顿认为:“民众是反覆无常的,他们甚少会冷静地判断是非善恶。因此,我们必须在政府中为出身富裕的阶层永久地保留一定的地位,他们可以对民众复杂多变的情绪要求作出理性的判断,„„也就可以保持
- 测量表计电流回路用控制电缆截面应不小于()mm2冷弯直径()以下的管子可以使用弯管器(俗称柄子)手工板弯1.5
2.5#
4
615mm
20mm
25mm#
35mm