查看所有试题
- KL1104是何种模块()。A、模拟量输入模块
B、数字量输入模块#
C、数字量输出模块
- 变浆风力发电机组的工作风速范围是()。允许偏航最小风速为()。3-12m/s
0-25m/s
3-25m/s#
6-30m/sA、2m/s
B、2.5m/s#
C、3m/s
- 填写和使用操作票时,错误的做法有().风电机塔架的螺栓一般()抽检一次。热继电器是电动机的常用保护,它是用()的原理。ABB变频器ISU上面的直流报险是多大的()。填写操作票时,个别非操作关键词句错误可用“”划去
- 三叶片风力发电机通常在低速端选用()联轴器。变桨风力电组的液压系统是通过()来实现节距控制的。我国建设风电场时,一般要求在当地连续测风()以上。刚性#
柔性
十字节
橡胶A、溢流阀
B、节流阀
C、单向阀
D、比
- 兆瓦级双馈风力发电机组变流器中的主要电力电子元件是()。A、电力二极管#
B、电力MOSFET
C、IGBT#
D、晶闸管
- 当L1线路频率最小值低于()赫兹,并持续0.1秒后,触发L1线路频率最小值超限故障。在国标中规定使用“pitch angle”来表示。()。49.5Hz
48.5Hz#
50Hz
40Hz浆距角#
倾角
安装角
偏航角
- 变桨风力电组的液压系统是通过()来实现节距控制的。A、溢流阀
B、节流阀
C、单向阀
D、比例阀#
- 风电液压系统中液压油泵通常采用:().A、柱塞泵
B、离心泵
C、齿轮泵#
D、螺杆泵
- 风电机塔架的螺栓一般()抽检一次。热继电器是电动机的常用保护,它是用()的原理。A、半年#
B、一年
C、一年半
D、两年电磁感应
涡流
肌肤效应
双金属片通过电流发热而变形#
- 当L1线路频率最大值超过()Hz,并持续0.1秒后,触发L1线路频率最大值超限故障。我国建设风电场时,一般要求在当地连续测风()以上。49.5Hz
51.5Hz#
55Hz
100HzA、3个月
B、6个月
C、3年
D、1年#
- 双馈式风电机组的发电机一般采用()发电机.配电变压器(箱变)通常装设过流保护,现场最简单的过流保护是()。直流母线的正极相色漆规定为()色。直流母线的负极相色漆规定是涂为()色。A、鼠笼式转子
B、绕线式
- 已结束的工作票保存期为()。风电机组额定电压是指发电机额定运行时()。运行中的隔离开关刀闸口最高允许温度为()。三个月#
半年
一年定子绕组的线电压#
定子绕组的相电压
转子绕组的线电压A、80℃
B、85℃#
C、90
- 直流母线的负极相色漆规定是涂为()色。A、黑
B、白
C、蓝#
- 当L1线路频率最大值超过()Hz,并持续0.1秒后,触发L1线路频率最大值超限故障。49.5Hz
51.5Hz#
55Hz
100Hz
- 填写和使用操作票时,错误的做法有().填写操作票时,个别非操作关键词句错误可用“”划去。
使用典型操作票时,凡不进行操作的项目应留空白。
一张操作票最多可填写两项操作任务。#
填写操作票需明确记录调度的操作命令
- 年风能可利用时间是指一年中风力发电机组在()范围内的运行时间。A、平均风速
B、有效风速#
C、最大风速
D、极大风速
- 接地中性线相色漆规定为()色。A、黑#
B、紫
C、白
- 变桨风电机组的液压系统是通过()来实现节距控制的。风电机塔架的螺栓一般()抽检一次。电缆线路在运行中电压不得超过电缆额定电压的()以上。A、溢流阀
B、节流阀
C、单向阀
D、比例阀#A、半年#
B、一年
C、一年
- 在国标中规定使用“pitch angle”来表示。()。当系统存在二级故障时,风机将()。浆距角#
倾角
安装角
偏航角A、正常停机
B、快速停机#
C、紧急停机
- 双馈式风电机组的发电机一般采用()发电机.A、鼠笼式转子
B、绕线式转子#
C、同步
D、无刷
- 流的功率因数是视在功率与有功功率的比值。()填写和使用操作票时,错误的做法有().ABB变频器RDCU控制()。正确#
错误填写操作票时,个别非操作关键词句错误可用“”划去。
使用典型操作票时,凡不进行操作的项目应留
- 变压器内的油起灭弧及冷却作用。()1.5兆瓦机组超速模块设定的超速转速为()。目前绝大部分风电机组要求的最大接地电阻不高于()欧姆。正确#
错误20rpm#
20.5rpm
21rpmA、3
B、4#
C、5
D、15
- 断路器液压机构中的压力表指示是空气压力。()风电机组采用软并网系统是为了()。电缆线路在运行中电压不得超过电缆额定电压的()以上。正确#
错误A、加快并网速度
B、保护发电机
C、减少电网冲击#
D、行业习惯A
- 高压隔离开关上带的接地刀闸,主要是为了保证人身安全用的()变浆风力发电机组的工作风速范围是()。目前风机连接螺栓基本都采用()表面处理技术。目前绝大部分风电机组要求的最大接地电阻不高于()欧姆。感应电
- 避雷针按其原理,实际上不起避雷作用,而起引雷作用。()正确#
错误
- 直流电机运行时可逆的。()在风力发电机中使用的合成油主要优点是在低温下有()优点。1.5兆瓦机组超速模块设定的超速转速为()。CO2是电的不良导体,所以CO2适用于扑灭()带电设备的火灾。正确#
错误流动性好#
抗
- 熔断器可分为限流和不限流两大类。()正确#
错误
- 中间继电器的主要作用是用以增加接点的数量和容量。()用绝缘电阻测试仪(摇表)测量绝缘电阻时,应将被测物体接在绝缘表的()。轮毂一般采用()制作。正确#
错误L端和E端#
L端和G端
E端和G端
任意两端A、白铸铁
B
- 在小电流接地系统发生单相接地故障时保护装置动作发生接地信号()塔底柜UPS蓄电池,充满电后,单独测其电压值正常应为()。带有外循环油冷却系统的风力机齿轮箱的润滑方式是()。风电机组额定电压是指发电机额定运
- 电力系统发生短路故障时,其短路电流为电容性电流。()串联电路中,总电阻为各电阻之()。正确#
错误A、差
B、和#
C、倒数和
- 电容量的大小反应了电容器储存电荷的能力。()正确#
错误
- 用隔离开关可以拉合无故障时的电压互感器和避雷器。()风电机塔架的螺栓一般()抽检一次。在风电机组中,如下()系统的核心是液压系统。正确#
错误A、半年#
B、一年
C、一年半
D、两年A、偏航系统#
B、刹车系统#
C
- 容性电路的无功功率是负值。()发电机风扇启动的绕组温度限值为()。我国建设风电场时,一般要求在当地连续测风()以上。正确#
错误A、35°
B、40°
C、50°#A、3个月
B、6个月
C、3年
D、1年#
- 高压断路器的额定电压指的是线电压。()高压互感器的常见故障有()。ABB变频器NDCU的哪个通道用于连接上位机()。轮毂一般采用()制作。正确#
错误A、内部芯体绝缘受潮#
B、匝间短路#
C、瓷件破损#
D、密封垫老
- 在回路中,感应电动势的大小与回路中磁通对时间的变化率成正比()兆瓦级双馈风力发电机组变流器中的主要电力电子元件是()。当电网A、B、C三相电压的不对称值超过()V,并持续2秒后,风机会触发电网电压不对称故障停
- 磁场对载流导体的电磁力方向,用右手定则确定。()矿物油质保存在高温环境下(),低温下易凝结。接班人员有权拒绝接班的情况中,不包括以下()。正确#
错误流动性差
成分易分解#
黏度高
黏度低设备运行方式不清楚或
- 在相同电压下的电阻元件,电阻值越大的功率越大。()当电网A、B、C三相电压的不对称值超过()V,并持续2秒后,风机会触发电网电压不对称故障停机。正确#
错误5V
300V
100V
50V#
- 电容器充电时的电流,由小逐渐增大。()三叶片风轮转速比两叶片风轮转速()。当L1线路频率最大值超过()Hz,并持续0.1秒后,触发L1线路频率最大值超限故障。配电变压器(箱变)通常装设过流保护,现场最简单的过流保
- 根据基尔霍夫第一定律可知:电流只能在闭合的电路中流通。()派克液压站电机工作时间过长,可能是下面哪种原因()。常用母线材料多采用()。正确#
错误A、电池阀3.9(Y1)不得电
B、节流阀3.15没拧紧#A、铜
B、铝#
- 两个相邻节点的部分电路叫做支路。()1.5兆瓦机组超速模块设定的超速转速为()。正确#
错误20rpm#
20.5rpm
21rpm