查看所有试题
- 在地层测试中,()主要适用于海上钻井和斜度较大的定向井。挑样之前要熟悉单井剖面资料和岩屑描述,选择具有()层位进行挑样。多流测试器MFE
压力控制测试器PCD#
单封隔器
双封隔器代表性的#
普遍性的
特殊性的
标志
- 在射孔过程中,对储层伤害的描述,错误的为()。完井地质总结报告的前言部分叙述各项地质资料的录取情况、工作量和()完成情况。用()将《油砂代表样》或《岩样汇集》本装订好,在封面透明塑料袋内装入标识卡片。射
- 典型油层的深探测电阻率是典型水层的()。下列气测异常可以用烃比值图版解释,其中评价为油层的是()。1~2倍;
3~5倍;#
相同;
1/2倍。C1/C2=1,C1/C3=20,C1/C4=5
C1/C2=8,C1/C3=20,C1/C4=30#
C1/C2=40
- 方解石占85%,粘土矿物占12%,白云石占3%的碳酸盐岩应命名为()。A、石灰岩
B、泥灰岩
C、含泥灰岩#
D、泥云岩
- 企业技术标准审定时,根据标准的情况不同,可采用()2种形式。储层敏感性评价的最终目的是()。调查研究和征求意见
会议审定和会签审定#
送审稿和组织审定
制订计划和审批发布油层评价
储层评价
储层保护#
岩性描述
- 深井泵是依靠抽油机带动()使活塞在套管内部做往复运动来抽油的。采油树
抽油杆#
抽油泵
驴头
- 井队长保证国家和公司安全生产法令、规定、指示和有关规章制度在本单位贯彻执行,把()工作列入议事日程。在进行吊单根作业前,钻具单根应排在滑道()以后,。A、安全环保#
B、安全生产
C、安全法规A、前面
B、中间#
- 根据作用性质,将沉积构造分为()大类。二
三#
四
五(A)二(B)三(C)四(D)五
- 下列岩屑中无法用P-K仪测量其孔隙度的是()。在盆地普遍沉陷的背景上,局部地区发生褶皱而形成的背斜构造称为()。完井地质总结建议对测试获:[业油气流的,可初步进行()和评估。松散砂砾岩岩屑;#
灰岩岩屑
致密
- 下列药品不能与碘酒混用的是()。大缝大洞在井径曲线上显示为()。文档编辑需修改页面格式时,首先要选定(),在“页面设置”对话框中进行操作。酒精
紫药水
红药水#
双氧水缩小的平值段
缩小的尖刀状
扩大的锯齿状#
- 油井月资料全准井数20口,月应取资料井数22口,月油井资料全准率()。1.1
110%
91%#
0.91
- 岩样汇集制作时将挑选出的岩样装入()特制的小塑料袋内,把填好的标签装在塑料袋内,并装入标识纸卡片同时将袋口折叠,用大头针别好。35mm×35mm
25mm×25mm
40mm×50mm#
45mm×45mm
- 除了给气体检测分析系统提供载气外,空压机还可提供()。A、助燃气#
B、热源
C、压力源
D、油源
- 刚性满眼钻具组合中,上稳定器直径与钻头直径的差值应不大于()。A、5mm
B、8mm
C、6mm#
- 相比两侧同一反射波的同相轴,其振幅特征相当突出,形成“粗、黑”的强振幅剖面特征,是()最直观、最表面的特征。亮点#
暗点
平点
转折点
- 在自喷井中途测试中判断天然气的性质,一般应在天然气的密度稳定时取()合格样。表皮系数可正可负,均质油藏S=0,非均质油藏S=-3时,表示末受污染,大于者表示(),小于者说明()。2个#
3个
4个
5个受污染;趋于完善#
- 石油中的碳氢化合物通常又被称为()。A、烃类化合物#
B、烯类化合物
C、炔类化合物
D、烷类化合物
- 有机物质向油气转化的全过程,可划分为()个逐步过渡的阶段。六
四#
三
二
- 人工神经网络技术评价油气层的实质是()。通过沉积旋回、砂体组合剖面分析,()物性好。地震剖面上层序内部反射同相轴本身的延伸情况与同相轴之间的相互关系,按照内部结构形态一般分为()。模拟人脑神经冲动传导原
- 钻井液处理时应收集()六个方面的资料。处理药剂名称、浓度、数量、处理时的井深、处理时间和处理前后性能变化情况等#
处理药剂的名称、生产日期、数量、处理时的井深、处理时间和处理前后性能变化等
处理药剂的密
- 下列工作中属于地质生产技术管理人员应该了解其基本原理但不强求熟练掌握的是()。石油采收率是采出地下原油占原始石油储量的百分数。采收率为()的石油采收率等级为低。储层参数和地震参数之间的关联性是进行储层
- 煤矿井下的“三专两闭锁”中的“三专”指()采矿生产中采用的地质图形主要有()放顶煤回采的缺点:()A、专用开关#
B、专用设备
C、专用变压器#
D、专用线路#A、地形地质图#
B、剖面图#
C、水平切面图#
D、煤层底板等
- 采煤机割顶煤时,要注意()支撑掩护式支架的适用条件()A、顶板保持平整#
B、不留顶煤#
C、不能破坏顶板#A、适用在中厚以上煤层#
B、倾角在12度以下#
C、底板稳定#
D、顶板较坚硬或顶板破碎的煤层#
- ()直接位于煤层之上的极薄的松软岩层,由强度低、易垮落的炭质泥岩组成。采矿生产中采用的地质图形主要有()所有支护器材有基础台帐,对()等均有纪录伪顶#
直接顶
间接顶
老顶A、地形地质图#
B、剖面图#
C、水平
- 煤层直接顶稳定性分类以直接顶初次垮落步距为主要指标,分为()类。A、2
B、3
C、4#
D、5
- 按固定相的物理状态划分,色相色谱法又分为()两种。气固色谱法和液固色谱法
气固色谱法和气液色谱法#
气相色谱法和液相色谱法
气液色谱法和固相色谱法
- 回采工作面结束后,应在()天内按要求提出该工作面采后总结,经矿总工程师批准后,妥善保存。15
20
30#
60
- 声波速度测井曲线用来判断划分岩性的理论依据是()。A、声波在不同岩石中传播速度不同#
B、声波在不同岩石中传播时振幅不同
C、声波在不同岩石中传播时频率不同
D、声波在所有岩石中的传播速度相同
- 目前最常用的脱气器是()。A、浮子式脱气器
B、电动脱气器#
C、热空蒸馏脱气器
D、定量脱气器
- 地震勘探中,引起地震波存在的震源有()种。Exce1可以使用热键完成移动操作,选中文档内容后按下()组合键,将选中内容剪切到剪贴板中。1
2#
5
10Ctr1+1
Ctr1+C
Ctr1+V
Ctr1+X#
- 以河流作用为主的三角洲前缘沉积中,一般是()不发育。电缆测试取样有油花,但样品的水化学性质与钻井液滤液的水化学性质相差较大时,可确定为()。河口砂坝
远砂坝
席状砂#
指状砂油层
油水层#
水层
致密层
- 划分地层的单位从大到小为()。为矿区建设开发总体设计提供地质资料的煤田地质勘探阶段是:()。A、系、统、界
B、界、系、统#
C、统、界、系A、找煤
B、普查
C、详查#
D、精查
- 凝析油在地面上的相对密度低,一般小于()。0.80#
0.886
0.91
0.93
- ()在地表分布最广,是常见的一类岩石。岩浆岩
变质岩
沉积岩#
- 下列不属于“液压支架按与围岩力的相互作用”分为的架型()()液压支架型号及代号所表示的意义:ZY4800-19/40型掩护式液压支架。工作阻力KNA、掩护式
B、支撑式
C、支撑掩护式
D、放顶煤#工作阻力4800KN#
初撑力4800
- 地震勘探的理论基础是(),它包括运动学和动力学2方面的理论知识。反射波理论
弹性波理论#
折射波理论
透射波理论
- 对换完大泵的井,各级技术管理人员应加强管理,及时录取资料,认真分析()和措施效果。泵况#
油井
泵径
水井
- 在聚合物采油中,增加注入水的(),从而在注入过程中降低水浸带的岩石渗透率,提高注入水的波及效率,改善水驱油效果,而达到提高原油采收率的目的。密度
流度
温度
粘度#
- 把装有岩样的小塑料袋按井深由浅至深的顺序分别装入《油砂代表样》或()本中,排列整齐,纸卡片字面应朝外。《岩样汇集》#
《实物剖面》
《砂样袋》
《岩屑入库清单》
- 区域探井非目的层段钻井液录井间距要求()测量一个点,目的层段()测量一个点,碳酸盐岩地层2~l0m测量一个点,显示井段加密测量,每班至少测一次钻井液全性能。在地震波传播的过程中,由地质现象引起的波动称为(),如