查看所有试题
- 制动机的自动制动作用,是把小闸放在(),操纵大闸手把在各工作位置时的综合作用。该作用用于大型养路机械牵引其他车辆时操纵整个列车的制动、保压与缓解。在对清筛机日常检查保养时,应进行的项目有()。缓解位
保压
- 车轮踏面是车轮在钢轨面上()接触的部位,具有一定的斜度,踏面与轨面在一定的摩擦力作用下完成车轮的滚动运行。冷却风扇液力耦合器的机油滤清器罩在发动机每工作()h,应进行清洗保养。滚动#
滑动
蛇行运动50
100
20
- 下列单位换算正确的是()。大闸手把从缓解位移到运转位,由于()失电,中继阀中的总风遮断阀处于开启状态,所以列车管压力泄露可以得到补充。1mA=10的六次方A
1kw=103w#
1μF=1/103F单独制动阀
自动制动阀
电控阀#
- 要使额定电压低的用电器能连接到电压高的线路上使用,必须采用()电路。D08-32型捣固车用F12L513型风冷柴油机的额定功率为()kW。液压油的选择应根据使用地区的气候条件和季节而确定。一般情况,冬季应选用()机械
- 在转向架上装设有弹簧减震装置,当车辆运行在不平顺线路上时,转向架可以缓和车辆的冲击和振动,从而提高车辆的运行()。大型养路机械采用的是()车轮。闸瓦的含磷量过高,将增加闸瓦的()解体稳定装置夹轨轮,清洗检
- 曲柄滑块机构可以将()转变为直线往复运动。二极管的最大正向电流是指在规定的散热条件及二极管()时允许通过的最大正向电流平均值。液压减振器使用()后,要在专用实验台上进行性能试验。回转运动#
来回摆动
变速
- 轴箱的最高温度不得超过70摄氏度,轴箱温度高于环境温度()以上时,可判断为轴箱过热。SRM80型清筛机转向架沙箱应安装良好,无破损、漏沙现象。沙箱容沙量不少于容积的(),沙子干燥,沙质良好。撒沙阀及沙管应安装良好
- SPZ-200型配砟整形车在高速运行时,每个轮对上的车轴齿轮箱由相应的液压马达驱动,液压马达的动力来自于安装在分动齿轮箱对应输出口的()。大型养路机械转向架心盘间隙应不小于()mm。进给齿条要保持清洁,()向其表
- SRM80型清筛机转向架上、下旁承应保持()的间隙调整量。使用扳手时应选相应的旋转方向,将控制杆移()到F(顺时针旋转)或R(逆时针旋转)位置上去,将力矩设到低或高的位置。调直(或弯曲)钢轨作业时,其它人员须站
- 液压传动如密封不严或零件磨损后产生渗漏,影响工作机构运动的()。YZ-1型空气制动机系统中设有安全阀,用以控制系统风源的安全压力,其动作压力值为()。钩舌与钩腕内侧面距离称为车钩开度,在最小处测量,闭锁位置时
- 对捣固车检测系统进行检查保养时,不属于三级检查保养的项目为()。检测弦线的张紧情况#
检查GVA(RVA.装置
检修记录仪
- 安装在D08-32型捣固车起道伺服阀的进油路上的过滤器属于()。轨道电路是铁路信号基础设备(如自动闭塞、电器及中等)的基础,借助它可以监控列车在线路上的运行情况,也可传递与()有关的各种信息。高压过滤器#
回油
- 电容器的并联电路中,等效电容量等于各电容器的()之和。液压直轨器定期保养,每()一次,要更换液压油,并清洗油箱。电压与电荷量乘积
电容量#
电容量倒数三个月#
六个月
十个月
十二个月
- 在直接制动时,分配阀是根据作用管的压力变化来控制()的压力变化。按顺时针拧紧回油阀,摇动操作杆,使高压油输入工作油缸,当活塞伸长()之后,斜铁则可夹住钢轨,继续摇动操作杆则可推轨调缝。均衡风缸
容积室
制动缸
- 液压泵按结构形式可分为齿轮泵、叶片泵和()三大类。中继阀具有供排风快和灵敏度高的特点,模板鞲鞴的动作灵敏度为()。在二级检查保养中,要()ZF动力换挡变速箱液力传动油的滤清器,化验液力传动油。单向泵
双向泵
- 电容器的并联电路中,等效电容量等于各电容器的()之和。二极管的最大正向电流是指在规定的散热条件及二极管()时允许通过的最大正向电流平均值。轨道电路是铁路信号基础设备(如自动闭塞、电器及中等)的基础,借助
- 由于轨道电路发生方式不同和钢轨中传输的信号不同而产生了不同的轨道电路()。信号制式#
基本制式
模拟制式
- SRM80型清筛机的每台分动齿轮箱上安装了()驱动走行的液压油泵。闸瓦的含磷量过高,将增加闸瓦的()按顺时针拧紧回油阀,摇动操作杆,使高压油输入工作油缸,当活塞伸长()之后,斜铁则可夹住钢轨,继续摇动操作杆则可
- 进气温度高,导致柴油机进气量不足,燃烧恶化而排()。在大型养路机械运行途中,当施行紧急制动或由于其他原因引起紧急制动作用后,应及时把大闸手把移到()。黑烟#
蓝烟
白烟运转位
保压位#
缓解位
- 在硅(或锗)本征半导体中掺入微量的()元素,就形成了主要由自由电子导电的电子型半导体,即n型半导体。花键传动轴在花键套中可以伸缩,所以传动轴的长度能随其两端与之连接的部件间()的变化而变化,但是伸缩量不能
- 空气滤清器脏污,对空气流的阻力增大,造成进气量不足,引起柴油机冒()。黑烟#
蓝烟
白烟
- 二极管的最大正向电流是指在规定的散热条件及二极管()时允许通过的最大正向电流平均值。大型养路机械用铸铁闸瓦的最大磨耗量为()。自动制动后的单独换届时通过下压()的单独缓解阀实现的。长期运行#
短期运行
- 不能产生制动力的原因是()。若在钢轨中部钻孔,则不需要定位尺,可按钻孔位置向左(或向右)加()mm在钢轨顶部划线,然后将夹紧座的左面(或右面)对准划线,既是钻孔位置。进给齿条要保持清洁,()向其表面擦20#机油
- 紧急放风阀鞲鞴杆上轴向缩孔Ⅰ的孔径设计是与列车管的()排风速率相匹配的,它足以使紧急室压力空气的逆流速率与列车管压力空气的下降速率保持一致,使得紧急鞲鞴两侧不会形成更多压缩安定弹簧的压力差。全制动
常用制
- 安装在D08-32型捣固车起道伺服阀的进油路上的过滤器属于()。柴油机气门间隙过大,还会使个零件之间的撞击和()加剧,噪声变大。大型养路机械各工作装置每工作()h,应进行一次二级检查保养。高压过滤器#
回油过滤器