查看所有试题
- 串联电容器两端所承受的电压,与各自的()成反比。二极管的最大正向电流是指在规定的散热条件及二极管()时允许通过的最大正向电流平均值。柴油机工作循环开始(即柴油机启动)时,需要用外力先使(),完成辅助过程,
- 闸瓦的含磷量过高,将增加闸瓦的()在重新调整D08-32型捣固车主转向架的闸瓦间隙时,制动缸鞲鞴行程应达到()。紧急制动时列车管压力由500kPA下降到零的时间不大于()。在二级检查保养中,要()ZF动力换挡变速箱液
- 换向阀属于哪一类液压控制阀。()当自动制动阀处在()时,均衡风缸的压力上升。利用铁路的两条钢轨作为导线所构成的电气回路称为(),它可以反映线路和道岔区段是否有车占用,以及钢轨是否完整。方向控制阀#
压力控
- 电路图中,符号表示()。原用铸铁闸瓦的车辆换装高摩合成闸瓦,就必须改变基础制动装置的(),更换专用闸瓦托。不带空气干燥器的YZ-1型空气制动机的供气系统,压力调节器、压力控制器的总风控制范围为()。在小闸性能
- 液压油作为液压系统中的工作介质,在动力元件和执行元件间传递(),驱动系统工作。哪一个因素必然导致柴油机功率下降。()万向传动轴在高速重载下工作,为了保证传动轴运转的平稳性和可靠性,要求新组装的万向传动轴都
- 属于大型养路机械捣固装置日常检查保养的项目为()。内燃扳手操作人员应仔细阅读(),了解机械性能、构造、使用方法,严守安全操作规程。液压直轨器定期保养,每()一次,要更换液压油,并清洗油箱。混凝土轨枕地段,冲
- 轮对轴身有打痕、碰伤、磨伤、或电焊打火等缺陷,经处理后痕迹深度大于(),应退轮修理或更换轮对。空气制动阀中,作用凸轮根据各工作位置的行程变化来控制()的左右移动,实现气路的联通或切断发动机磨合期(新发动机
- 双作用式液压缸正、反两方向的运动都靠()实现。大型养路机械的高速行驶功能是通过结构组成中的高速走行动力传动系统来实现的。目前,主要采用了液力机械传动和()两种方式。车钩闭锁位置尺寸超限会使车辆在()运
- 车长阀的开启和关闭,是通过手把转动()来完成的。当SRM80型柴油机操作驾驶室转换时,应先停机、停车。待司机转换驾驶室后,再重新启动(),进行运行操作。()不是YQB-250型液压起拨道器的组成部分。直轨作业时使锁勾
- SRM80型清筛机采用的是两台()型风冷柴油机。车轴齿轮箱的作用是将传动轴或液压马达传来的动力降低()、增大扭矩后,驱使轮对转动。YZ-1型空气制动机中,大闸下的调压阀控制总风进入均衡风缸的压力,调定值为()。根
- 4WG-65Ⅱ型液力机械变矩器中设有闭锁离合器。当涡轮转速达到泵轮转速的()时,涡轮与泵轮自动地闭锁为一体,成为刚性连接,液力机械变矩器也就变成刚性的机械传动。SRM80型清筛机主离合器在气动系统压力大于()后,气压
- 电磁换向阀包括()和电磁铁两部分。在二级检查保养中,要()ZF动力换挡变速箱液力传动油的滤清器,化验液力传动油。对于长期停放的大型养路机械,须由机组留守人员按机械临时停放要求()进行一次检查保养。如经常使
- 液压控制阀中,能够改变执行元件运动速度大小的是()。柴油机不能在有外载荷的条件下启动,在动力换挡变速箱处于()位时,能够切断传动系统中的动力,便于柴油机启动,也有利于安全停车。()不属于保持列车运行有一定
- 当电容器接通交流电源时,交流电的最大值不允许超过电容器的额定()。二极管的最大正向电流是指在规定的散热条件及二极管()时允许通过的最大正向电流平均值。液压控制阀中,能够改变执行元件运动速度大小的是()。
- 下列单位换算正确的是()。发动机磨合期(新发动机或解体检修后50h)内,应()润滑油油位,不足时须立刻补油。进给齿条要保持清洁,()向其表面擦20#机油即可。1mA=10的六次方A
1kw=103w#
1μF=1/103F每天检查一次
每
- 柴油发动机汽缸中进行的每一次将化学能转变为热能,热能又转变为()的一系列连续过程叫做一个工作循环。制动时,均衡风缸压力自500kPA.减压至360kPA.的时间为()。轨道电路是铁路信号基础设备(如自动闭塞、电器及中
- 铸铁闸瓦含磷量的多少对摩擦性能的影响较大,含磷量(),闸瓦的摩擦系数越大,耐磨性越好,故用较小的闸瓦压力即可获得较大的制动力。原用铸铁闸瓦的车辆换装高摩合成闸瓦,就必须改变基础制动装置的(),更换专用闸瓦托
- 道依茨风冷柴油机曲柄连杆机构的零件,承受的载荷较大,相对运动速度也很大,因此采用()润滑捣固车发动机停机后,()报警灯熄灭。电动捣固机的使用时应距轨枕边缘20~30mm下镐,镐板与轨枕面边线成45º角,在进行捣固时
- 当气温低于(),为了顺利启动柴油机,应用火焰加热塞对进气管的进气温度进行预热。SRM80型清筛机传动系统所用的GB2/380KR型主离合器属于()离合器。钢轨切割机锯轨后,切断面对钢轨纵轴的垂直偏差轨头部≤()mm,其它
- 电路处于开路状态时,电源的端电压()电源的电动势。喷油提前器将从高压油泵来的燃油通过()后,以雾状形态喷入燃烧室,使燃油在燃烧室与空气形成良好的混合气。SRM80型清筛机主离合器在气动系统压力大于()后,气压
- 运行监控装置通过实时检测机车运行的速度,与实现存在装置内的限制速度比较,当超速时,启动()进行减速,当速度降到限速值后自动缓解。若机油滤清器为纸质滤芯,发动机每工作()h需进行更换。常用制动#
紧急制动
全制
- 在直接制动时,分配阀是根据作用管的压力变化来控制()的压力变化。在大型养路机械临时停放时,()进行一次全面的日常检查保养工作。便携式内燃扳手要使用和机器匹配的火花塞,按照规定的型号购置,操作人员双手把持内
- 减压阀属于哪一类液压控制阀。()以下各阀,不属于气动压差阀的是()。利用铁路的两条钢轨作为导线所构成的电气回路称为(),它可以反映线路和道岔区段是否有车占用,以及钢轨是否完整。SRM80清筛机的调速换向手柄可
- 开口传动用于两轴平行并且旋转方向相同的场合,可以传递的功率()。液力传动的效率随工况变化,液力变矩器的最高效率可达到()。利用铁路的两条钢轨作为导线所构成的电气回路称为(),它可以反映线路和道岔区段是否
- 要使额定电压低的用电器能连接到电压高的线路上使用,必须采用()电路。在柴油机活塞运行的上、下止点,活塞的运动方向将得到改变,活塞的速度()。F12L413F风冷柴油机采用的长形喷油嘴用()压装在汽缸盖的安装孔座
- 不同的材料有不同的电阻率,电阻率的大小反映了各种材料()的好坏。不能产生制动力的原因是()。车钩缓冲装置中,从板座分为前从板座和后从板座,铆结于()内侧面上,用以阻挡从板的移动,从而使缓冲器实现衰减及缓和
- 铜、铝等金属材料的电阻率(),故常用来制成导线。电路处于开路状态时,电源的端电压()电源的电动势。容积室的压力受()的控制,按规定要求,大型养路机械紧急制动时的制动缸最高压力为450kPA.。以下车钩形式当中,具
- 液压执行元件的作用是将油液的压力能转化成()对外做功,以带动负载进行直线运动或回转运动。用作大闸的空气制动阀在()时,调压阀管压力空气经作用柱塞凹槽、转换柱塞的固定凹槽进入均衡风缸管,实现均衡风缸的充气