查看所有试题
- 如果基层局部强度不足,或沥青路面面层的网裂、龟裂未及时养护等,在汽车荷载作用下,路面将很容易产生()病害。A.坑槽#
B.龟裂
C.纵向裂缝
D.拥包
- 在沥青面层与半刚性基层或粒料基层之间应设置()。公路沥青路面设计规范中路面结构的验算指标为()代号为SMA的沥青类结构层属于()。A.透层沥青#
B.黏层沥青
C.上封层沥青
D.下封层沥青A.设计弯沉值
B.容许
- 沥青贯入式路面具有()等优点。A.强度较高#
B.稳定性好#
C.施工简便#
D.不易产生裂缝#
- 高速公路、一级公路表面层,除旧沥青面层上加铺抗滑层外,其厚度一般不宜小于()。粒料类基层按强度构成原理可分为()。沥青路面抗滑能力的大小主要与()有关。A.3.0cm
B.4.0cm#
C.4.5cm
D.5.0cmA.综合稳
- 拦水带按长度以()计量。路面表面外观特征有连片严重龟(网)裂或伴有车辙、沉陷时,路面的外观状况等级为()。代号为AC的沥青类结构层属于()。影响沥青路面压实的主要因素有()A.立方米
B.米#
C.千克
D.平
- 对路面垫层所用材料的要求是()。钢筋混凝土路面的面板配筋的主要目的是()A.水稳性、隔热性和吸水性一定要好
B.强度要求高,水稳性好#
C.造价便宜
D.强度要求不高,水稳性可差一些A.防止板块开裂
B.减薄混凝
- 在路面设计中,从路面结构的力学特性出发,下列路面面层类型中,()属于刚性路面。下列哪些是半刚性材料()水泥混凝土路面#
沥青混凝土路面
泥结碎石路面
沥青表面处治级配碎石
级配砾石
二灰土#
水泥碎石#
- 沥青路面结构层一般由()组成。级配碎石路面混合料的强度和稳定性主要取决于()。以下哪种结构层不能防止反射裂缝?()A.面层#
B.基层#
C.底基层#
D.垫层#A.集料间的摩阻力和级配
B.集料级配和施工含水量
C
- 无机结合料稳定类基层所用的无机结合材料,目前常用的是()。A.水泥#
B.石灰#
C.粉煤灰#
D.工业废渣#
- 下列路面面层类型中,()是简易铺装路面。《公路水泥混凝土路面设计规范》规定路面板中产生最大综合疲劳损坏的临界荷位为()A.沥青混凝土路面
B.沥青贯入式路面#
C.水泥混凝土路面
D.沥青表面处治路面#板中部
- 热拌沥青碎石适用于柔性路面的()。A.垫层
B.底基层
C.上基层及调平层#
D.沥青表面处治
- 目前,可供高速公路、一级公路选择的沥青路面面层是()。A.沥青混凝土#
B.沥青碎石
C.沥青贯入式
D.沥青表处
- 下列哪些是粒料类材料()公路沥青路面设计规范中路面结构的验算指标为()A.水泥土
B.二灰碎石
C.级配碎石#
D.石灰土碎石A.设计弯沉值
B.容许弯沉值
C.弯拉应力#
D.剪应力
- 当沥青面层由双层或三层组成,且不能连续施工而沥青层表面被污染,或载旧沥青面层及水泥混凝土面层上加铺沥青层时,均应在层间设置()。属于简易铺装路面的有()。A.透层沥青
B.黏层沥青#
C.上封层沥青
D.下封层
- 代号为SMA的沥青类结构层属于()。A、沥青混凝土
B、沥青玛蹄脂碎石#
C、沥青稳定碎石
D、沥青碎石
- 高速公路和一级公路热拌沥青混合料的配合比设计包括()。A.目标配合比设计阶段#
B.生产配合比设计阶段#
C.计算配合比阶段
D.生产配合比验证阶段#
- 高速公路、一级公路的沥青路面,应选用()。A.重交通道路石油沥青#
B.改性沥青#
C.乳化沥青
D.煤沥青
- 路面结构一般由()组成。水泥混凝土路面设计时以重100KN的单轴荷载作为标准轴载,将其它轴重换算成标准轴载时是按()进行的。A.面层#
B.基层#
C.底基层#
D.垫层#A.弯沉等效原则
B.疲劳断裂等效原则#
C.剪应
- 普通混凝土面板一般采用矩形,其板宽可按路面宽度和每个车道宽度而定,其最大间距不得大于()。沥青混合料的强度由()等组成。在石灰稳定土路面设计中,起稳定作用的石灰剂量为()。A.3.5cm
B.4.0cm
C.5.0cm
D
- 水泥混凝土路面板厚设计的最小厚度为()。BZZ-100的当量均布圆直径为()cm。密级配沥青碎石的代号为()。现拟在干旱高温地区修建高级路面,路面类型应选择()A.18cm#
B.20cm
C.22cm
D.24cmA、22.3
B、21.3#
C
- 沥青混凝土、沥青碎石的压实度,当以马歇尔实验密度为标准密度时,高速公路、一级公路应达到()的压实度。在路面设计中,从路面结构的力学特性出发,下列路面面层类型中,()属于刚性路面。A.98%
B.95%#
C.94%
D.93
- 下列工程中包含在相应的单价中,不另行计价的是()。A.排水管基础开挖#
B.排水管出水口预制混凝土垫块#
C.加固土路肩的混凝土立模、摊铺、振捣、养生、拆模#
D.透层和黏层
E.水泥混凝土面板接缝材料#
- 拦水带按长度以()计量。A.立方米
B.米#
C.千克
D.平方米
- 水泥混凝土路面板厚设计的最小厚度为()。沥青路面应具有坚实、平整、抗滑、耐久的品质;同时,还应具有()的功能。以路面设计弯沉值计算路面结构厚度时,采用的是()。水泥混凝土混合料配合比设计的参数有()A.1