查看所有试题
- 两条平行导线,当通入方向一致的电流时,它们互相吸引,在电阻和电抗串联的交流电路中,若电阻R=3Ω,感抗X2=5Ω,则阻抗为8Ω。()通常所说交流220V是指它的()。4只60微法的电容串联使用时其等效电容量是()。两只额定
- 因为三极管是放大电路中的放大元件,所以它可以把输入信号的能量放大。()在电容器充、放电过程中,充放电流与()成正比。带电作业工具的电气试验周期为()。正确#
错误A.电容器两端电压
B.电容器两端电压的变化
- 用基尔霍夫第一定律列节点电流方程时,当求解的电流为负值,表示实际方向与假设方向相反。()选择一台异步电动机连续工作制时的保险丝的额定电流按()。在纯电阻的交流电路中,电流与电压的相位()。正确#
错误A.该
- 如果电路中某两点的电位很高,则该两点间的电压一定也很高。()平板电容器电容量的大小与()成正比。正确#
错误A.两极板之间距离
B.极板面积#
C.极板材料
- 4只60微法的电容串联使用时其等效电容量是()。离心泵要坚持备用泵的定时盘车保养制度,离心泵启运前一定要经过(),检查转子是否灵活,泵体内是否有不正常声音和金属撞击声。A.60法
B.240法
C.15法#
D.30微法A、
- 用电桥测量开关触头电阻时,应用()。A.单臂电桥
B.双臂电桥#
- 我国规定发电机的额定入口风温是()。A.40℃#
B.35℃
C.30℃
- 电路中某点的电位就是该点的电压。()在纯电阻电路中,电路有功功率因数为()。正确#
错误A.0
B.1#
C.0.5
- 电力系统在运行中,突然短路引起的过电压叫做()过电压。如果电流的方向是由正向负流动,那么电子流动的方向是()。A.大气#
B.操作
C.弧光接地A.由正向负#
B.由负向正
C.左右摆动
- 载流导体周围的磁场方向,与产生该磁场的()有关。A.磁场强度
B.磁力线的方向
C.电流方向#
- 发电机供出的电能是由()转换来的。在二次接线图中所有继电器的触点都是按()的状态表示的。把高级语言翻译成机器语言的程序是()。欧姆定律阐明了电路中()关系。所谓电力系统的稳定性,系指()。A.动能
B.机
- 载流导体周围的磁场方向,与产生该磁场的()有关。选择一台异步电动机连续工作制时的保险丝的额定电流按()。A.磁场强度
B.磁力线的方向
C.电流方向#A.该台电动机的额定电流
B.该台电动机的起动电流
C.该台电
- 发电机自动电压调整器用的电压互感器的二次侧()。带电作业工具的电气试验周期为()。A、不装熔断器;#
B、应装熔断器;
C、应装过负荷小开关。A.3个月
B.6个月#
C.12个月
- 平板电容器电容量的大小与()成正比。A.两极板之间距离
B.极板面积#
C.极板材料
- 带电作业工具的电气试验周期为()。两只额定电压均为220V的白炽灯泡一个功率为100W,另一个为40W,将二者串联接入220V电路,这时()。A.3个月
B.6个月#
C.12个月A.40W灯泡较亮#
B.100W灯泡较亮
C.两只灯泡同样
- 为把电流输送到远方,减少线路上的电能损耗,主要采用()。对于“掉牌未复归”小母线PM,正常运行时是()。A、提高变压器输出电压;#
B、增大线路导线截面,减小电阻;
C、提高功率因数,减小无功。A.带负电#
B.带正电
- 绝缘棒的试验周期为()。选择一台异步电动机连续工作制时的保险丝的额定电流按()。A.3个月
B.6个月
C.12个月#A.该台电动机的额定电流
B.该台电动机的起动电流
C.该台电动机的额定电流的2.3~3.2倍#
- 用电桥测量开关触头电阻时,应用()。10KV电压互感器高压侧熔丝电流应选()。A.单臂电桥
B.双臂电桥#A.0.5A#
B.1A
C.5A
- 将一根金属导线拉长,则它的电阻将()。10KV电压互感器高压侧熔丝电流应选()。A.变小
B.不变
C.变大#A.0.5A#
B.1A
C.5A
- 消弧线圈采用欠补偿运行时,当网络发生故障或因其它原因使某些线路断开后,可能()。我国规定发电机的额定入口风温是()。发电机自动电压调整器用的电压互感器的二次侧()。A.构成串联谐振,产生过电压
B.使中性点
- 要将电流表扩大量程应该()。A.串联电阻
B.并联电阻#
- 离心泵要坚持备用泵的定时盘车保养制度,离心泵启运前一定要经过(),检查转子是否灵活,泵体内是否有不正常声音和金属撞击声。低周波减载装置()动作。A、预热
B、校正
C、检修
D、盘车#A.在系统故障时应可靠
B.在
- 要将电压表扩大量程应该()。35KV设备运行中的绝缘油耐压标准是()KV。发电机供出的电能是由()转换来的。A.串联电阻#
B.并联电阻A.30KV#
B.35KV
C.40KVA.动能
B.机械能#
C.化学能
- 如果电流的方向是由正向负流动,那么电子流动的方向是()。A.由正向负#
B.由负向正
C.左右摆动
- 选择一台异步电动机连续工作制时的保险丝的额定电流按()。4只60微法的电容串联使用时其等效电容量是()。A.该台电动机的额定电流
B.该台电动机的起动电流
C.该台电动机的额定电流的2.3~3.2倍#A.60法
B.24
- 在纯电阻的交流电路中,电流与电压的相位()。为把电流输送到远方,减少线路上的电能损耗,主要采用()。A.越前90°
B.滞后90°
C.相同#A、提高变压器输出电压;#
B、增大线路导线截面,减小电阻;
C、提高功率因数,
- 低周波减载装置()动作。A.在系统故障时应可靠
B.在系统电压下降时
C.在系统频率下降时#
- 一条粗细均匀的导线的电阻为48Ω,若把它切成相等长度的n段再把这n段并联起来,导线电阻变为3Ω,那么n应等于()段。欧姆定律阐明了电路中()关系。发电机供出的电能是由()转换来的。A.4#
B.6
C.8CA.动能
B.机械
- 在电容器充、放电过程中,充放电流与()成正比。如果电流的方向是由正向负流动,那么电子流动的方向是()。A.电容器两端电压
B.电容器两端电压的变化率#
C.电容器两端电压变化量A.由正向负#
B.由负向正
C.左右
- 电流速断保护的保护范围()。所谓电力系统的稳定性,系指()。10KV电压互感器高压侧熔丝电流应选()。要将电流表扩大量程应该()。发电机自动电压调整器用的电压互感器的二次侧()。A.随系统运行方式变大而变大
- 在纯电阻电路中,电路有功功率因数为()。如果电流的方向是由正向负流动,那么电子流动的方向是()。发电机供出的电能是由()转换来的。A.0
B.1#
C.0.5A.由正向负#
B.由负向正
C.左右摆动A.动能
B.机械能#
- 在电子放大电路中,当要求获得较高的输出阻抗时,采用()负反馈电路较好。10KV电压互感器高压侧熔丝电流应选()。发电机自动电压调整器用的电压互感器的二次侧()。A.串联
B.电压
C.电流#A.0.5A#
B.1A
C.5AA
- 不按工作需求布置安全措施,工作负责人应负()责任。A.直接
B.次要
C.主要#
- 调相机定子绕组换位的目的是()。为确保厂用母线电压降低后又恢复时,保证重要电动机的自启动,规定电压值不得低于额定电压的()。在纯电阻的交流电路中,电流与电压的相位()。A.减小集肤效应引起的损耗#
B.减少
- 35KV设备运行中的绝缘油耐压标准是()KV。我国规定发电机的额定入口风温是()。电力系统在运行中,突然短路引起的过电压叫做()过电压。A.30KV#
B.35KV
C.40KVA.40℃#
B.35℃
C.30℃A.大气#
B.操作
C.弧光接
- 10KV电压互感器高压侧熔丝电流应选()。由于能量在传递,转换过程中,不能发生突变,因此电容器的()不能发生突变。A.0.5A#
B.1A
C.5AA.充电电流
B.两端电压#
C.储存电荷
- 用控制开关进行断路跳闸时,先将控制开关逆时针旋转()至预备跳闸位置,此时()闪光,然后将控制开关逆时针再转动()至跳闸位置,此时()亮,表计指示(),最后松开手,控制开关自动逆时针旋转()到跳闸后位置。90°;
- 充油式电力变压器小间或室外变电所,应装设适当的()设施和事故()设施。在纯电阻的交流电路中,电流与电压的相位()。消防;排油A.越前90°
B.滞后90°
C.相同#
- 在电子放大电路中,当要求获得较高的输出阻抗时,采用()负反馈电路较好。变压器的激励涌流一般是额定电流的()。A.串联
B.电压
C.电流#3~5倍
5~8倍#
10倍
- 1THM、2THM、3THM代表()。在纯电阻的交流电路中,电流与电压的相位()。A.同期合闸小母线#
B.合闸小母线
C.控制小母线A.越前90°
B.滞后90°
C.相同#