查看所有试题
- 对于基建投产设备在投入运行的头三年内,应每()年进行一次定期检验。电力变压器的油起()作用。一#
二
半年绝缘#
防锈
冷却#
灭弧
- 汽动给水泵进行盘车的原因是()。A、消除泵体上、下温差;
B、减小泵的热应力;
C、给水泵汽轮机需要;#
D、加快给水泵预暖或冷却速度。
- 在建立纵向加密隧道时,以下哪项不是必要条件()。我们可以用()来解决广播流量过量问题。网络监视及协议分析常用在网络的()管理和故障管理等方面。网络互通
添加对端设备证书
添加对端设备地址
在纵向加密装置管
- 电机铁心常采用硅钢片叠装而成,是为了()便于运输
节省材料
减少铁心损耗#
增加机械强度
- 2013年银行业金融机构地方政府融资平台贷款以控制总量、()、隔离风险、明晰职责为风险管控重点。优化结构#
逐步压缩
不得增加
分类管理
- 调节级的最危险工况出现在()时。汽轮机运行时,监视段压力高与()无关。A、额定功率;
B、第一调节阀刚开足,第二调节阀未开;#
C、超负荷。A、通流部分结垢;
B、通流部分故障;
C、通流部分热应力;#
D、汽轮机调
- 可编程控器中存储器有()在我国,特高压电网是指由()千伏级交流和正负()千伏级直流系统构成的高压电网()要成功实施AGC,必须具备一些必备条件,哪项是必备条件()系统程序存储器#
备用存储器
读写存储器
用户程
- 汽轮机热态启动的起始负荷是()。A、低负荷暖机所需要的5%~10%额定负荷;
B、启动前汽缸调节级处的金属温度所对应的汽轮机负荷;#
C、80%额定负荷;
D、零负荷。
- 依据《特种作业人员安全技术培训考核管理规定》规定,特种作业人员在特种作业操作证有效期内,连续从事本工种()年以上,并符合相关规定,特种作业操作证的复审时间可以延长至每6年1次。5
10#
15
20
- 依据《关于电力行业继续深入扎实开展“安全生产年”活动的通知》,电力企业要进一步规范编制和完善应急预案,严格执行预案评审和备案制度,定期开展各类电力突发事件应急演练。()正确#
错误
- 某工程建设项目按照相关要求组织了职业危害预评价、职业危害控制效果评价,但是未将相关的报告提交有关部门备案,依据《作业场所职业健康监督管理暂行规定》,可对生产经营单位()。二次工作人员在现场工作过程中,凡遇
- 在定子绕组引出线或中性点附近相间短路时,两中性点连线中的电流较小,横差保护可能不动作,出现死区范围可达(),因此不能取代纵差保护。检修母线时,应根据()等实际情况确定地线数量。15%~20%#
10%~15%
5%~1
- 防止发电机损坏事故的措施有()防止因定子绕组端部松动而引起的相间短路#
防止定子绕组相间短路#
防止转子匝间短路#
防止发电机非全相运行#
- 那些是检查和处理高压断路器发生跳闸失灵的电气回路故障()为了人身和设备安全,互感器的二次侧必须实行()检查电源电压是否过低,使分闸铁芯的冲力不足或本身低电压分闸值不合格#
检查分闸回路中熔断器或其它动作元
- 热态启动从冲转到带上起始负荷不需要暖机,要求尽量快地操作,这是因为()。A、尽快地满足外界负荷的需要;
B、尽量提高启动过程的热经济性;
C、减少转子的热弯曲;
D、尽量减少汽轮机的交变热应力。#
- 引起轴向推力增大的原因是()。A、新蒸汽温度升高;
B、负荷突减;
C、动叶结垢;#
D、A和B。
- UPS的工作方式有4种,当UPS检修时,要采用()工作方式。将BCD码01011001转化为十进制数为()正常运行方式
电池工作方式
旁路运行方式
旁路维护方式#59#
69
57
67
- 在预防触电事故的措施中,分配电箱与开关箱的距离不得超过()米,开关箱与它说控制的电气设备不得超过()米。在室外高压设备上工作,应在工作地点四周装设围栏,其出入口要围至()。10,1
20,2
30,3#
35,3.5A、安全区
- 信息系统应急培训和应急演练应()。IEC60870-5-101规约通过()判断报文接收是否正常。定期组织#
仅在节假日前开展
仅在安全保电时开展
仅在特殊时期开展奇校验
偶校验
FCB是否翻转#
- 维护状态估计模块时,发现合格率偏低,可能的原因有()下列数据库恢复操作正确的是哪些()SCADA量测出现问题#
电网结构发生改变#
PAS数据库没有及时更改#
设备参数错误#先使用回滚日志回滚,使数据文件处于最新状态
- 《电力调度自动化系统运行管理规程》(DL/T516-2006)规定,问答式规约比特差错率的极限值为()。发电厂是将水力、煤炭、石油、()等能量转变成电能的工厂。提高数据库可恢复性可以从下列哪几个方面着手()3×10-5
- 当电流互感器不满足10%误差要求时,可采取()措施。继电保护是以常见运行方式为主来进行整定计算和灵敏度校核的所谓常见运行方式是指()增大二次电缆截面#
将同名相两组电流互感器二次绕组串联#
改用饱和倍数较高的
- 控制汽包进水速度的主要目的是()。A、防止进水管接口处应力过大;
B、控制汽包上、下壁温差;#
C、控制饱和温度变化率;
D、控制汽包内、外壁温差。
- 调用()时需要指定其背景数据块。智能变电站中相量测量装置以()方式和站控层设备通信。国家电网公司2009版《能量管理系统(EMS)实用化标准(试行)》中,基本应用包括()FB和FC
SFC和FC
SFB和FB#
SFB和SFCMMS#
S
- 转子发生一点接地仍可以继续运行的危害()电动机外壳带电,可能的原因有()交流接触器接在与它额定电压相等的直流电源上,交流接触器将()发展为两点接地故障#
分转子绕组发热,有可能被烧毁#
电机转子由于作用力偏
- 热效继电器是利用双金属片的()而构成的过负荷保护。A、膨胀特性;
B、弯曲特性;#
C、电阻增大特性;
D、电阻减小特性。
- 当()时,柴油发电机自启动。A、机组跳闸;
B、当高压厂用变压器或启动变压器跳闸;#
C、保安电源高电压;
D、保安电源进线过电流未动作。
- 发电机强励动作允许时间到达强励允许时间时,处理方法应为()。A、不得干预,继续强励;
B、人为降低励磁到允许值;#
C、拉开励磁开关。
- 交流采样装置的交流工频电量每一电流/电压输入回路的功率消耗应不大于()VA。综合智能分析与告警可以获取的数据源包括()0.25
0.5#
0.75
0.8来自电网运行稳态监控功能模块的电网实时稳态告警信息#
来自电网运行动
- 对()渗透油层,聚合物降低渗透率的主要机理是吸附。A、高
B、中
C、高、中#
D、低
- 电阻限流有载调压分接开关有哪几部分组成()切换开关#
选择开关#
范围开关#
操动机构#
- 按照《国家电网公司安全事故调查规程》,地区电网调度自动化系统故障,延误送电或影响事故处理,属于()事故。根据GB/T2887-2000《电子计算机场地通用规范》的规定,调度自动化主机房的最小使用面积不应小于()平方米
- 正常运行时,锅炉再热器汽温高,你将首先选择()进行调整。A、降低烟气氧量;
B、提高火焰中心高度;
C、投入再热减温水;#
D、调整烟道挡板。
- 根据《建设工程安全生产管理条例》的规定,违反本条例的规定,县级以上人民政府建设行政主管部门或者其他有关行政管理部门的工作人员,有下列()行为之一的,给予降级或者撤职的行政处分;构成犯罪的,依照刑法有关规定
- 根据《电力建设安全生产监督管理办法》的规定,电力施工单位应当根据电力建设工程项目的(),对施工现场容易引发安全生产事故的危险源、危险部位、危险环节进行监控。下列关于国家法定休假日正确的是()。事故调查所
- 根据《华东电网时间同步系统技术规范》规定,标准时间同步钟本体和时标信号扩展装置的静态空接点(光隔离)输出允许外接工作电压为()用户对表中数据作出更改后又想将其恢复原值,选出下列最佳的实现方法()25V
110V
- 轴流送风机动叶调节原理是()。A、由气动定位执行器直接带动叶片机械调整装置;
B、由气动定位执行器带动油活塞;
C、由气动定位执行器带动错油门,通过液力驱动油活塞;#
D、气动转换后,由伺服电机带动油活塞。
- 在PE设备的私网路由表中,远端用户的私网路由的下一跳是()远端CE的loopback接口地址
远端PE与CE相连的接口地址
远端PE的loopback接口地址#
本PE的loopbac接口地址
- 接地网的接地电阻一般应不大于()0.5Ω#
0.4Ω
0.1Ω
5&Omega
- 在失稳分力作用下,转子涡动的频率总是约等于转子()的一半。A、额定转速;
B、临界转速;
C、当时转速。#