查看所有试题
- WAMS由()部分组成。在Linux操作系统中的/etc/passwd文件包括的基本选项有()PMU子站#
WAMS主站#
国家电力数据通信网#用户ID#
加密的密码值
用户登录Shell#
用户登录的主目录#
- 凝汽器大气释放门的作用是()。A、检修用人孔门;
B、放出不凝结的空气;
C、凝汽器的安全阀;#
D、破坏真空的真空破坏门。
- 汽缸采用法兰加热装置的作用是()。A、减小运行时螺栓热应力;#
B、有足够的螺栓预紧力;
C、紧螺栓时省力;
D、减小汽缸法兰热应力,缩短启动时间。#
- 遇有电气设备着火时,应立即对将该设备的电源(),然后进行灭火。切断#
灭火
保护
毁灭
- 以下哪个选项不是路由器的功能()安全性与防火墙
路径选择
隔离广播
第二层的特殊服务#
- 安全评价的方法分类有()。按评价结果的量化程度分类法#
按评价的推理过程分类法#
按针对的系统性质分类法#
以危险、有害因素的类别为主划分
- 在停机过程中,汽缸壁最大应力危险点在()。A、1/2壁处;
B、内壁表面;#
C、外壁表面;
D、汽缸壁厚的中断面处。
- 甲乙丙类液体储罐区和液化石油气储罐区的消火栓,应设在()。储罐区内
储罐下
防护堤外#
防护堤内
- 在道路上发生交通事故,仅造成轻微财产损失的,并且基本事实清楚的,当事人应当()。应当先撤离现场,再进行协商处理#
立即抢救受伤人员
等保险公司派人到达现场
迅速报告交通警察或者交管部门
- 下列各种对飞灰比电阻影响的说法中,正确的是()。A、煤中含硫增大,飞灰比电阻一般减小;
B、煤中含硫增大,飞灰比电阻一般增大;#
C、烟温升高时,飞灰比电阻增大。
- 卤代烷灭火剂的灭火机理是()。冷却作用
隔离作用
窒息作用
破坏和抑制链反应#
- 《道路交通安全法》规定,抢救受伤人员的抢救费用超过保险公司责任限额的,未参加机动车第三者责任强制保险或者肇事后逃逸的,由()先行垫付部分或者全部抢救费用。保险公司社会救助基金
医疗机构社会救助基金
肇事车
- 根据《工伤保险条例》的规定,用人单位分立、合并、转让的,职工发生工伤由()承担工伤保险责任。晶体三极管作开关用时,是工作在()。原用人单位
人民政府
承继单位#
本人放大区;
饱和区;
截止区;
饱和区和截止区
- 磨煤机电机振动大的原因有()下列说法正确的有()电机端盖螺丝松动#
电机与所带机械中心不正#
电机轴承损坏或间隙过大#
电机轴承润滑脂过多照明电源可以用三相三线制
电动机的电源可以用三相三线制#
照明电源必须
- 低油压保护动作信号来自()。A、主油泵出口油压;
B、主油泵进口油压;
C、保护系统的安全油压;
D、冷油器出口润滑油压#
- 再热机组设置中压调节阀的作用是()。A、与动态校正器配合,改善机组的功率滞延性;
B、高压缸故障时,采取中压进汽控制机组负荷;
C、机组甩负荷时,防止超速;#
D、低负荷时保证高、中、低压缸蒸汽流量基本一致。#
- 消防器材的使用年限一般是()年。1
2
3#
5
- 发电机正常运行,功率因数为0.97;经无功调节后,功率因数为0.95。这是因为在调节过程中,()。A、开大了调节汽门;
B、关小了调节汽门;
C、增加了励磁电流;
D、减小了励磁电流。#
- 关于系统策略路由与接口策略路由的区别说法正确的是()系统策略路由只对本地产生报文作用,对转发的报文不起作用#
系统策略路由对本地产生报文和转发的报文都起作用
接口策略路由只对转发的报文作用,对本地产生的报
- 测量绝缘时,若兆欧表转速比要求转速低得过多时,其测量值与真实值比较,将()。A、可能偏高;#
B、可能偏低;
C、大小一样;
D、不能确定。
- 汽缸和法兰的相对胀差在()情况下会出现负胀差。A、升速;
B、增负荷;
C、减负荷停机。#
- 变压器调压装置的作用是()变换线圈的分接头#
改变高压线圈的匝数比#
改变低压线圈的匝数比
调整电压,保持稳定#
- 汽轮机的高压抽汽在高压加热器中放热凝结后,却不能在高压加热器汽侧形成真空,这是因为()。A、高压抽汽有过热,故建立不起真空;
B、抽汽压力高,无法建立真空;
C、冷却水温度高,在高压加热器汽侧不能建立低于饱和温
- 根据Q/GDW680-2011《智能电网调度技术支持系统》系列标准规定:智能电网调度技术支持系统消息总线传输数据和消息的速率为:500报文/秒,其中每个报文长度为()字节。三层交换机收到数据帧进行二/三层转发的判定规则
- 新投产机组的AGC功能应在机组移交商业运行()投入使用。OSPF协议中,在同一区域(区域A)内,下列说法正确的是()之前
同时#
之后
不一定使用每台路由器生成的LSA都是相同的
每台路由器的区域A的LSDB(链路状态数据
- 清扫运行设备和二次回路时,要防止振动,防止(),要使用绝缘工具。并列运行的变压器应满足以下条件()误碰#
短路
开路
漏电变压比相等相差不应超过±0.5%#
阻抗电压百分值相等相差不应超过±10%#
接线组别相同#
额定
- 运行凝汽设备所做的真空严密性试验,是为了判断()。A、凝汽器外壳的严密性;
B、真空系统的严密性;#
C、凝汽器水侧的严密性;
D、凝汽设备所有各处的严密性。
- 励磁系统主要有以下()部分构成。励磁电源装置#
自动、手动励磁调节装置#
自动灭磁装置#
发电机转子绕组过电压保护装置#
备用励磁系统#
系统系统、测量仪表#
- 负荷频率控制(LFC)的基本任务是调整系统的()达到额定值或/和维持区域联络线()为计划值。用户对表中数据作出更改后又想将其恢复原值,选出下列最佳的实现方法()负荷、交换功率
频率、交换功率#
负荷、电压
频
- 在额定稳定工况下,汽轮机转子和汽缸的热应力()。一次调频时,机组自动承担的外界负荷变化量与调速系统的速度变动率()。A、趋于零;#
B、最大;
C、较大A、无关;
B、成反比;#
C、成正比。
- 汽轮机运行时,监视段压力高与()无关。A、通流部分结垢;
B、通流部分故障;
C、通流部分热应力;#
D、汽轮机调节阀开度。
- 原理上不受电力系统震荡影响的保护有()电流保护
距离保护
电流差动纵联保护和相差保护#
电压保护
- 各电气间隔事故信号组成全站事总时,采用()方式形成。在下列EMS传输的信息中,哪些是下行信息()触发加自动复归#
“与”逻辑
“或”逻辑
触发加保持遥测
遥信
遥控#
遥调#
对时报文#
- 油浸变压器的冷却方式有()电力系统对继电保护装置的基本要求是()油浸自然冷却#
油浸风冷却#
强迫油循环风冷却#
强迫油循环水冷却#稳定性
灵敏性#
无选择性
完整性
- SF6设备解体检修,打开设备封盖后,现场所有人员应暂离现场()min。A、10
B、20
C、30#
- 将十六进制数30H转化为十进制数为()。BGPMPLSVPN组网中,用户私网报文由CE侧进入PE设备时,PE如何判断该报文所属的VPN()40
48#
30根据报文所携带的私网标签判断
根据报文的目的IP地址判断
根据报文的源IP地址判断
- 汽轮机转子的最大弯曲部位通常在()附近。A、调节级;#
B、中间级;
C、末级
- 火灾自动报警系统通常由触发装置、报警装置、()、电源组成。警报装置#
探测器
报警按钮
控制器
- 下列常见的坍塌伤亡事故的预防措施中,说法正确的是()。安装和拆除大模板,吊车司机与安装人员应经常检查索具,做到稳起、稳落、稳就位,防止大模板大幅度摆动,碰撞其他物体,造成倒塌#
拆除工程必须编制施工方案和安全
- 变压器二次电流增加时,一次电流将()。A、不变;
B、减小;
C、增加;#