查看所有试题
- 矿物棉制品绝热层敷设,在敷设中发现有孔洞缝隙时()。要随即用散状矿物棉填充修补#
要在全部矿物棉制品绝热层敷设完后再修补
因是多层敷设,不需要修补
要安排专人去修补
- 重要电力用户应配置自备应急电源,自备应急电源的配备应符合要求有()。配置容量标准应达到保安负荷的110%
启动时间应满足安全要求#
与电网电源之间应装设可靠的电气或机械闭锁,防止倒送电#
- 安全工器具可分为()。常用的绝缘油有()。高压开关设备发生下列()情形之一者,应定为危急缺陷。A、电气绝缘工具类#
B、一般安全防护工具类#
C、施工机具类(起重类)#
D、运输车辆类DB-10#
DB-15
DB-20
DB-25#
D
- 计量自动化系统现有的采集装置类型有:()厂站电能量采集终端#
负荷管理终端#
配变监测计量终端#
集中器#
- 一有色溶液为紫色,进行比色分析时。选用的滤光片应为()。紫色
红色
绿色#
黄色
- 功率定值闭环控制简称()。电压暂降和短时中断试验属于()的一种。功控;#
购电控;
电控;
厂休控。结构和机械试验;
电磁兼容试验;#
绝缘性能试验;
电源影响试验。
- 油中微量水分测定用的电解液(卡氏试剂)的正确组成是()。二甲基硅油是表示一种()。吡啶、无水甲醇、二氧化硫;
碘、无水甲醇、吡啶;
吡啶、二氧化硫、无水甲醇、碘;#
甲醇、吡啶。抗氧化剂;
抗泡沫剂;#
防
- 1000MW机组凝结水精处理混床进出口压差()系统联络门门自动打开。滴定分析中,通过改变颜色指示化学计量点的试剂是()。A、>0.40MPa
B、>0.35MPa#
C、>0.30MPaA、标准溶液
B、指示剂#
C、催化剂
- 尖电极为负的击穿电压与其为正的击穿电压相比()。锯割中等硬度的材料时,锯割速度应以()次/min左右较为适宜。低很多;
接近;
相等;
高很多。#20;
40;#
60;
80。
- 某台断路器额定的操作顺序为:分-0.3s-合分-3min-合分。下列解释正确的是()。引起变压器谐振过电压的原因()。某油浸变压器冷却方式为ODAF,下列描述正确的是()。0.3s为无电流时间#
3min为强送时间#
这台断路器
- 碱性蓄电池的大修周期是()年。4
6
12#
18
- 目前空压机的启、停操作均由()集控进行操作;
个别或特殊情况还需就地操作;#
均由除灰值班员操作。
- 电流表、电压表某一刻度上划一红线表示()。()在电场作用下做有规则的定向移动就形成了电流。电流、电压的额定值或允许值#
电流电压的最大值
电流电压的标准值
电流电压的最小值电荷#
分子
原子
中子
- ()式低压开关可切断短路电流。磁力启动器;
自动空气开关;#
接触器;
闸刀。
- 电除尘器是利用()使烟气中的灰粒带电,通过静电作用再进行分离的装置。示波器的水平偏转板上所加的偏转信号一般是()。强场强;
电晕放电;#
电离;
尖端放电。锯齿波;#
方波;
恒定的直流;
正弦波。
- 在串联电路中各个电阻通过的()都是相同的电力系统运行应当连续、稳定,保证安全供电()。电压
电量
电流#
功率可行性
可靠性#
责任性
优越性
- 断路器相间的电动力的大小与电流成()线性运算放:大器有两个输入端:一个是同相输入端,另一个是()输入端。反比
一次方正比
平方正比#同相
反相#
正极
负极
- 同时给予电网企业部分资金用于资产的后续运维、技改支出补偿的,资产移交后,并按相应金额确认运维补偿收入,借记“其他应付款”科目,贷记“其他业务收入”科目。#
电网企业发生运维费用支出计入“其他业务成本”科目,并按相
- GCrl5钢平均含铬量为()%。奥氏体等温转变图可以被用来估计钢的淬透性大小和选择适当的()介质。去心力退火时()发生组织转变。A、0、15
B、1、5#
C、15A、淬火#
B、回火
C、正火A、会#
B、不会
C、不一定
- 三相四线低压电网,220V运行电压的允许偏差为额定电压的()。近年来机床电器逐步推广采用的无触头位置开关,80%以上采用的是()。+7%、-10%#
±10%
±7%
±5%电容型
光电型
高频振荡型#
电磁感应型
- 进电压电器的动作和返回概念与()断电器相似。电流#
电压
时间
- 氨的引燃温度为()。液氨储罐的控制温度不高于()。651℃#
751℃
550℃
700℃25℃
30℃
35℃
44℃#
- 当高压电容器组发生爆炸时,处理办法之一是()。因为隔离开关(),所以隔离开关禁止带负荷拉合。在电路里()不是产生电流的原因。注意调节电容器运行温度
调换为较高额定电压电容器
切断电容器与电网的连接#A、没有
- 在建工程楼梯口、电梯口、通道口的照明灯具离地面高度低于2.4m时,电源电压应不大于()V。国家标准规定,PE保护线用()。成列低压配电屏安装,其盘表平整度的最大误差应小于()mm。220
110
36#黑色线
黄绿颜色相间线
- 熔断器选择的主要内容有()。在低压TN系统中,电缆线路和架空线路在每个进线处,均须做()。A、熔断器的型式;#
B、熔体的额定电流#
C、熔体选择性的配合以及熔断器额定电压;#
D、额定电流的等级#屏蔽接地
中性点接
- 在我国现行煤炭的分类标准中,挥发分VDAf最低的类别是()。A、贫煤
B、瘦煤
C、无烟煤#
- 玉柴电控发动机由哪几部分组成()外出安排的工作要求()A.控制器B.执行器C.传感器D.线速#若接到客户要求外出救急信息,在组织外出服务的同时,在YCSS系统的“外出申报”版块录入信息,向辖区办事处申报,办事处审批归档
- 吊钩有()个危险断面卷扬机卷筒壁磨损达原壁厚的(),卷筒应报废按GB16899-1997《自动扶梯和自动人行道的制造与安装安全规范》要求自动扶梯的倾斜角不应超过()。A.5
B.3#
C.4
D.2A.10%#
B.15%
C.20%
D.25
- 闪点在()℃以下的液体叫做易燃液体。氢冷发电机用密封油的酸值标准要求≤()mgKOH/g。根据试验温度选择适当的粘度计,使用≥0.4mm的粘度计必须使试样流动时间不少于()s。75
60
50
45#0.1;
0.2;
0.3;#
0.4。150;
- 备用转为第4类非计划停运,以()时间为界。某机于6月5日22:00-25日8:00小修,期间6日10:00-16日11:00进行该机5号磨煤机大修工作,5日22:00-6日10:00该机5号磨煤机统计为()。某厂#1机组(300MW)4月5日0:00开
- 线路相间过流保护和零序过流保护中的方向元件的保护方向都是()。综合自动化变电站遥信信息是指()。新设备投运前应编制启动方案,启动方案的内容包括:()。A、顺时针方向
B、逆时针方向
C、母线指向线路#
D、线
- 保护接地、接零线(PE线)的颜色是()。A、黑色
B、淡蓝色
C、黄绿/双色#
- 如果按轿厢所获动力区分,在用电梯使用最多的方式是()。当施工升降机提升速度小于0.8m/s时,上限位挡板应安装在距离导轨架顶部安全距离不小于()m位置柱塞式
螺杆式
曳引式#
齿条齿轮式A.3
B.2
C.1.8#
D.1.5
- 变电站计算机监控系统全站SOE分辨率为()。交流采样测量装置检验设备的基本配置:()。A、≤1ms
B、≤2ms#
C、≤3ms
D、≤4ms
E、≤5msA、数字万用表#
B、多功能标准表或现场校验仪#
C、标准检验装置#
D、钳形电流表#
- 用来确定载流导体在磁场中受力方向的定则是()。A、左手定则#
B、右手定则
C、螺旋定则
D、以上答案都不对
- 在汽车上采样,不论何种煤种,均应沿车箱对角线方向采取,首尾两点距车角()m。A、0.4
B、1
C、0.5#
D、0.2
- ()的密度大于1t/m3。变压器油;
汽轮机润滑油;
磷酸酯抗燃油;#
透平油。
- 某厂#1机组(200MW)2008年3月15日12:37因非计划降低出力20MW,持续5小时,其余时间全出力运行。该机组当月等效非计划降低出力时间是()小时。“发电设备可靠性信息管理系统”程序、事件编码、单位代码,由()组织编制
- 下列关于电压互感器的产生误差的主要原因中,由于一次绕组存在电阻,就形成了电压互感器的空载误差#
电压互感器的基本结构和变压器很相似。当U1在铁芯中产生磁通φ时,由于一次绕组存在漏抗,就形成了电压互感器的空载误
- 电力系统运行应当连续、稳定,保证安全供电()。一个工作簿内最多要可以有()个工作表可行性
可靠性#
责任性
优越性16
32
255#
256