查看所有试题
- 干粉灭火系统在紧靠手动启动装置的部位应设置()装置。消防应急广播设备调试内容()。A、自动启动
B、触发器启动
C、手动紧急停止#
D、自动紧急停止A、以手动方式在消防控制室对所有广播分区进行选区广播,对所有共
- 在组合分配干粉灭火系统中,每个防护区或保护对象应设()选择阀。干粉灭火系统的手动启动装置要求()。A、1个#
B、2个
C、3个
D、4个A、在全淹没灭火系统中应设置在防护区外邻近出口或疏散通道便于操作的地方#
B、
- 干粉灭火系统管网清扫工作应在()内完成。干粉灭火系统防护区警报器警报声响度通常比环境噪声高()。A、12h
B、24h
C、36h
D、48h#A、15dB
B、20dB
C、30dB#
D、10dB
- 干粉灭火系统在紧靠手动启动装置的部位应设置()装置。A、自动启动
B、触发器启动
C、手动紧急停止#
D、自动紧急停止
- 关于干粉灭火系统备用干粉储存容器等说法不正确的是:()。干粉灭火系统喷头的单孔直径不得小于()mm。A、干粉灭火系统备用干粉储存容器应与系统管网相连
B、干粉灭火系统备用干粉储存容器应与主用于粉储存容器切
- 干粉灭火系统在紧靠手动启动装置的部位应设置()装置。A、自动启动
B、触发器启动
C、手动紧急停止#
D、自动紧急停止
- 符合下列条件之一的场所,不宜选择点型光电感烟火灾探测器:()。线型光束感烟火灾探测器的设置应符合下列哪些要求:()。A、有大量粉尘、水雾滞留#
B、可能产生蒸气和油雾#
C、高海拔地区#
D、在正常情况下有烟滞
- 干粉灭火系统选择阀应采用快开型阀门,其公称直径应与连接管道的公称直径()。A、大
B、相等#
C、小
D、不限
- 局部应用干粉灭火系统可燃液体保护对象液面至容器缘口的距离不得小于()储存装置宜设在专用的储存装置间内。专用储存装置间的设置应符合下列规定:()。A、50mm
B、100mm
C、120mm
D、150mm#A、应靠近防护区,出口
- 局部应用干粉灭火系统采用体积法设计时,封闭罩的侧面及顶部当无实际围护结构时,它们至保护对象外缘的距离不应小于()。A、0.5m
B、1.0m
C、1.2m
D、1.5m#
- 全淹没干粉灭火系统防护区围护结构及门、窗的允许压力不宜小于()。局部应用干粉灭火系统采用体积法设计时,封闭罩的侧面及顶部当无实际围护结构时,它们至保护对象外缘的距离不应小于()。A、120Pa
B、1200Pa#
C、1
- 室外或有复燃危险的室内局部应用灭火系统的干粉喷射时间不应小于()。干粉灭火系统管道可采用()。A、60s#
B、45s
C、30s
D、15sA、螺纹连接#
B、沟槽(卡箍)连接#
C、法兰连接#
D、焊接#
- 干粉灭火系统选择阀应采用快开型阀门,其公称直径应与连接管道的公称直径()。A、大
B、相等#
C、小
D、不限
- 对火灾报警系统中的()等设备应分别进行单机通电检查。火灾自动报警系统工程质量验收评定标准应符合()。A、可燃气体报警控制器#
B、消防联动控制器#
C、气体灭火控制器#
D、消防电气控制装置#A、系统内的设备及配
- 干粉灭火剂的基料在火焰的高温作用下将会发生一系列的分解反应,该反应是()。A、吸热反应#
B、放热反应
C、聚合反应
D、以上都不对
- 消防控制室内设备的布置应符合下列哪些规定:()。火灾自动报警系统施工过程中,施工单位应做好()相关记录。A、设备面盘前的操作距离,单列布置时不应小于1.5m;双列布置时不应小于2m;#
B、在值班人员经常工作的一
- 局部应用干粉灭火系统保护对象周围的空气流动速度在没有挡风措施时可为()。干粉灭火系统选择公称直径等于或小于80mm的管道,宜采用()连接。A、1m/s#
B、3m/s
C、4m/s
D、5m/sA、焊接
B、法兰连接
C、沟槽(卡箍)连
- 下列场所宜选择吸气式感烟火灾探测器:()。消防专用电话的检验,应符合下列()要求。A、具有高速气流的场所;#
B、点型感烟、感温火灾探测器不适宜的大空间、舞台上方、建筑高度超过12m或有特殊要求的场所#
C、低
- 干粉灭火系统干粉的储存容器其增压时间不应大于()s。点型火焰探测器和图象型火灾探测器的安装应符合下列要求()。A、15
B、20
C、25
D、30#A、安装位置应保证其视场角覆盖探测区域#
B、与保护目标之间不应有遮挡
- 干粉灭火系统干粉的储存容器其增压时间不应大于()s。A、15
B、20
C、25
D、30#