查看所有试题
- 室内燃气管道主立管与燃具水平净距不应小于多少()家用燃气具与对面墙之间的净距应不小于()人工煤气的爆炸极限()20cm
30cm#
100cm0.5m
0.8m
1.0m#5%~50%#
5%~15%
1.7%~9.7%
- 在出现哪些情况时可以不立即停机?()影响加气机计量精度的故障不包括的是?()压缩机任何一部分温度升高超过允许值
压缩机关键点压力超出允许范围
电机声音不正常,或电路部分出现过热、冒烟等现象
电流表读数突然
- 门站中对调压装置每一路须相同或相类似的设计。当其中一路关上时,其余各路 应仍可以()进口压力及()出口压力满足最高流量值。最高、最低
最低、最高#
最低、最低
最高、最高
- 住宅内的暗埋管道宜在直埋管道的全长上加设有效地防止外力冲击的金属防护装置,金属防护装置的厚度宜大于多少()当与其他埋墙设施交叉时,应采取有效的绝缘和保护措施。1.0mm
1.2mm#
1.4mm
- 牺牲阳极法防腐系统上所有的管道/土壤电位的测试点宜最少每()个月测量一次,而强制电流法防腐系统则最少每()个月测量一次。所有测量记录须留作日后参考。3;6#
3;5
2;5
2;6
- 住宅内的暗埋管道宜在直埋管道的全长上加设有效地防止外力冲击的金属防护装置,金属防护装置的厚度宜大于多少()当与其他埋墙设施交叉时,应采取有效的绝缘和保护措施。1.0mm
1.2mm#
1.4mm
- 安全泄放阀设定压力允许偏差±0.01MPa;启闭压差极限值最大为()%整定压力,最小为()%整定压力。家用燃气灶的实测热负荷不应超过设计热负荷的()5、2.5#
4、2.5
5、3.5
4、3.55%
10%#
15%
- 热水器的排烟管应采用不锈钢材料,其厚度应不小于()0.1mm
0.2mm
0.3mm#
- 液化天然气储罐充装量宜控制在储罐有效容积的()%20-90#
20-80
10-90
10-80
- 空气中一氧化碳含量达到()时,就可使人中毒。0.04%~0.06%#
0.06%~0.10%
0.10%~0.14%
- 阀片升程的大小对压缩机有直接影响:升程(),阀片易冲击,影响发的寿命,升程(),气体通道界面积小,通过的气体阻力大,排气量小,生产效率低。在调节阀片升程大小时,对于没有调节装置的气阀,可以车削加工气阀升高限制
- 储气设施的工作压力应为()MPa,其设计温度应满足环境温度要求。10
20
25#
15
- 对于最大流量qmax>10m3/h的燃气表的检定周期一般不超过()年。燃气热水器应安装在通风良好的非居住房间、过道或阳台内;装有半密闭式热水器的房间,房间门或墙的下部应设有效截面积不小于多少的格栅,或在门与地面之
- 液化天然气立式储罐固定喷淋装置应在罐体上部和灌顶均匀分布()民用的各类用气设备应采用低压燃气,用气设备前(灶前)的燃气压力应在()Pn至()Pn的范围内(Pn为燃具的额定压力)。罐体上部和灌顶#
罐体下部和灌
- 聚乙烯管道可随地形弯曲敷设,应符合:当管道上无承插接头时,不应小于()D;当管段上有承插接头时,不应小于()D。应尽量避免使接口位于弯曲的部分。A