查看所有试题
- 某轮吃水d=9.0m,水线面面积AW=1800m2,则此时船舶的海水厘米吃水吨数为()。船舶的每厘米吃水吨数TPC在()情况下,计算船舶的()误差较小。When a vessel is inclined by an external force,the().A.16.0
B.18.
- 船舶受外力作用发生横倾前后的重力(),重心横坐标()。以下()措施有利于提高观测吃水的精度。根据定义,则该处的吃水为()。船舶受外力作用发生纵倾前后的重力(),重心位置()。在水尺标志中,其数字高度和两数
- 平均型吃水是指在船舶中线面上,从正浮水线沿垂直于基平面的方向量到龙骨板()的垂直距离。以下()措施有利于提高夜间观测吃水的精度。某轮在某装载状态下的一处水线位于水尺标志“Ⅷ”字体高度一半处,则该处的吃水为
- From()the information concerning the tons per inch or centimeter immersion of a vessel shall be usually found.船舶的浮心B是指船舶()。某万吨轮在淡水中满载吃水为7.00m,进入海水水域后船舶吃水可能为(
- For a floating vessel,the result of subtracting KG from KM is the().船舶的浮心B是指船舶()。The ship has()of more than 10 meters at full load.height of the metacenter
height of the righting arm
h
- For a floating vessel,重心位置()。水尺标志是标绘在船壳板上的()。船舶进出不同水密度水域时平均吃水改变量计算公式为。公式中,密度ρs为()。船舶由海水水域驶入淡水水域时,船舶所受浮力()。船舶的每厘米吃
- As the displacement of a vessel increases,the detrimental effect of free surface().某轮在某装载状态下的一处水线位于水尺标志“④~⑤”字体间距的一半处,则该处的吃水为()。当船舶某装载状态下的某处水线达到
- Beams are cambered to().实际平均吃水是指在船舶中线面上,从正浮水线沿垂直于基平面的方向量到龙骨板()的垂直距离。当船舶某装载状态下的某处水线达到水尺标志的数字的()处时,则该处的吃水为该数字加上10cm。
- Aboard a vessel,multiplying a load’s weight by the distance of the load’s center of gravity from the centerline results in the load’s().船舶重力的作用中心称为()。某轮在某装载状态下的一处水线位于水
- An unstable upright equilibrium position on a vessel means that the metacenter is().平均型吃水是指在船舶中线面上,从正浮水线沿垂直于基平面的方向量到龙骨板()的垂直距离。船舶受外力作用发生纵倾前后的
- Aboard a ship,multiplying a load’s weight by the distance of the load’s center of gravity from the centerline results in the load’s().某轮首、中、尾的吃水分别是:6.45m,6.50m,且存在拱垂,船舶将()。
- Aboard a vessel,dividing the sum of the longitudinal moments by the total weight yields the vessel’s().From()the information concerning the tons per inch or centimeter immersion of a vessel shall
- A moment is obtained by multiplying a force by its().船舶的浮心B是指船舶()。某轮首、中、尾的吃水分别是:6.45m,6.50m,且存在拱垂,则其平均吃水为()m。船舶平均吃水等于首吃水与尾吃水之和的0.5倍成立的
- A vessel’s LCG is determined by().某轮首、中、尾的吃水分别是:6.45m,6.60m,6.50m,且存在拱垂,则其平均吃水为()m。在漂心的垂直线上卸载少量货物,船舶将()。将少量货物装于漂心的垂直线上,船舶将()。The
- 某轮在某装载状态下的一处水线位于水尺标志“Ⅷ”字体高度一半处,则该处的吃水为()。某轮排水量Δ=17272t,由密度为ρ1=1.014g/cm3的水域驶入密度为ρ2=1.002g/cm3,每厘米吃水吨数TPC=24.18t,则其平均吃水改变量为()m。
- 某轮装载后尾倾,则船舶的等容平均吃水()船舶的船中平均吃水。A neutral equilibrium position for a vessel means that the metacenter is().A.大于
B.小于
C.等于
D.取决于船舶漂心相对于船中的位置#lower
- 以下()措施有利于提高夜间观测吃水的精度。船舶平行沉浮的条件是:少量载荷增减于()的垂直线上。The ship should have a slightly deeper draft().A.利用强力照明设备
B.水面撒轻物
C.投小石击起浪花
D.以
- 船舶纵倾前后,漂心在船中前0.50m,dA=12.35m,则该轮的漂心修正量为()m。当船舶仅有横倾时,则该处的吃水读数即为该数字。某船正浮时由淡水进入海水,漂心在浮心之前,需卸下货物322t,则该轮在标准海水中的排水量为()
- A load line is assigned to a ship to insure adequate stability and().某轮船长200m,漂心在船中前0.50m,dF=10.20m,则该轮的漂心修正量为()m。某船由密度为ρ1=1.021g/cm3的水域驶入密度为ρ2=1.004g/cm3的水域,
- ()refers to the depth of a vessel below the waterline,measured vertically to the lowest part of the hull,propellers or other reference points.平均型吃水是指在船舶中线面上,从正浮水线沿垂直于基平面的
- Your vessel was damaged and initially assumed a significant list and trim; however,further increase has been slow. Based on this data,what should you expect?()当()时,fuel,water,stores,passengers a
- Your vessel is damaged with no list,but down by the stern. There is progressive flooding and trim by the stern is increasing. What is the effect on transverse stability after the deck edge at the ster
- The TPC curve,one of the hydrostatic curves in a vessel’s plans,gives the number of tons().船舶横倾前后,重力和浮力(),浮心位置()。某轮首、中、尾的吃水分别是:6.45m,6.60m,6.50m,且存在拱垂,则其平均
- What is not usually a concern when loading a single-hulled tanker?()船舶受外力作用发生纵倾前后的重力(),重心位置()。实际平均吃水是指在船舶中线面上,从正浮水线沿垂直于基平面的方向量到龙骨板()的垂
- The Plimsoll mark on a vessel is used to().某轮在某装载状态下的一处水线位于水尺标志“④~⑤”字体间距的一半处,则该处的吃水为()。当船舶仅有横倾时,平均吃水为()。当船舶某装载状态下的某处水线达到水尺标
- The difference between the starboard and port drafts due to wind or seas is called().在漂心的垂直线上卸载少量货物,船舶将()。船舶由水密度ρ=1.010g/cm3的水域驶入标准海水水域,吃水约减小()。某轮装载
- The difference between the starboard and port drafts caused by shifting a weight transversely is().船舶重力的作用中心称为()。在漂心的垂直线上卸载少量货物,船舶将()。船舶由海水水域驶入淡水水域时,
- A neutral equilibrium position for a vessel means that the metacenter is().船舶由水密度ρ=1.010g/cm3的水域驶入标准海水水域,吃水约减小()。当()时,船舶首尾平均吃水小于等容吃水。海水密度的增加()。F
- 船舶的每厘米吃水吨数TPC在数值上等于()。某轮在某装载状态下的一处水线位于水尺标志“Ⅸ”字体的底边缘,则该处的吃水为()。某船正浮时由淡水进入海水,漂心在浮心之前,则在海水中时()。船舶的每厘米吃水吨数TPC在
- 某轮吃水d=7.00m时水线面面积AW=1200m2,则对应的淡水厘米吃水吨数为()t/cm。A vessel’s LCG is determined by().Vessel shall possess()valid for duration of charter Party showing winches and derricks in
- 船舶平行沉浮的条件是:少量载荷增减于()的垂直线上。当船舶有纵倾和横倾时,平均吃水为()。当船舶某装载状态下的某处水线达到水尺标志的数字的()处时,则该处的吃水为该数字加上5cm。当船舶某装载状态下的某处
- 船舶的漂心F是指()。以下()措施有利于提高观测吃水的精度。实际平均吃水是指在船舶中线面上,从正浮水线沿垂直于基平面的方向量到龙骨板()的垂直距离。将少量货物装于漂心的垂直线上,船舶将()。某船由密度为ρ
- 将少量载荷装于船舶漂心垂线处时,则船舶()。船舶的浮心B是指船舶()。当船舶某装载状态下的某处水线达到水尺标志的数字的()处时,则该处的吃水为该数字加上10cm。当()时,船舶首尾平均吃水等于等容吃水。某轮船
- 对于箱形船而言,6.60m,6.50m,且存在拱垂,则其平均吃水为()m。某轮到港时排水量Δ=15000t,TPC=25t/cm。现在港卸货1000t后又加载500t,按计算的平均吃水的精度()。为保持某轮在相对密度为1.008的水域中与在标准海水
- The magnitude of a moment is the product of the force and().Where must the draft marks be placed on a small passenger vessel? ()time
lever arm#
displacement
angle of inclinatioOn each side of the
- 当船舶某装载状态下的某处水线达到水尺标志的数字的()处时,则该处的吃水为该数字加上10cm。船舶平均吃水等于首吃水与尾吃水之和的0.5倍成立的条件是()。船舶由淡水水域驶入半淡水水域时,船舶所受浮力()。某船
- 以下()措施有利于提高夜间观测吃水的精度。将少量载荷装于船舶漂心垂线处时,则船舶()。船舶的漂心F是指()。A.利用强力照明设备
B.水面撒轻物
C.投小石击起浪花
D.以上均是#A.首尾吃水不变
B.吃水差不变,
- 根据定义,船舶实际平均吃水比其型平均吃水大()。某轮到港时排水量Δ=15000t,dM=8.15m,TPC=25t/cm。现在港卸货1000t后又加载500t,之后由标准海水区域进入水密度为1.006g/cm3的区域,其吃水为()m。For a floating ve
- 某轮船宽为20m,当其右倾2°时,左舷吃水减少()m。船舶横倾前后,重力和浮力(),浮心位置()。船舶的浮心B是指船舶()。A load line is assigned to a ship to insure adequate stability and().Load line regula
- 某轮装载后尾倾,则船舶的等容平均吃水()船舶的船中平均吃水。船舶重力作用线垂直于船舶()。船舶由半淡水水域驶入海水水域时,船舶所受浮力()。当()时,船舶首尾平均吃水等于等容吃水。对于箱形船而言,船舶的每