查看所有试题
- 500kV变压器、电抗器施加电压前静止时间不小于()。在倒闸操作过程中,应避免用带断口电容器的断路器切带电磁式电压互感器的空母线,防止产生()。24h
48h
72h#
96h过电流
过电压
谐振过电流
谐振过电压#
- 1mmHg(或1Torr)=()。在220kV及以上高压配电装置敷设的控制电缆其绝缘等级宜选择()。以下属于操作过电压的是()。9.80665Pa
133.322Pa#
98.0665kPa
101.325kPa220/3800V
380/450V
450/750V
600/1000V#工频电压
- 测试连接与同一接地网的各相邻设备接地线之间的电气导通情况,以直流电阻值表示。直流电阻值不应大于()。绝缘电阻表有3个接线柱,其标号为G、L、E,使用该表测试某线路绝缘时()。0.2#
1
5
10G接屏蔽线、L接线路
- 1kgf•m=()。采用分裂导线,使得线路电抗()。0.980665N•m
1N•m
9.80665N•m#
98.0665N•m不变
增大
减小#
无法确定
- 1mmHg(或1Torr)=()。330kV变压器、电抗器施加电压前变压器油微水含量不大于()。9.80665Pa
133.322Pa#
98.0665kPa
101.325kPa20L/L
15L/L#
10L/L
8L/L
- 在220kV及以上高压配电装置敷设的控制电缆其绝缘等级宜选择()。220/3800V
380/450V
450/750V
600/1000V#
- 换流站()。只能作整流运行
只能作逆变运行
即可呈整流运行,也可呈逆变运行#
- 热力学温度K和华氏度℉在表示温度差和温度间隔时:1℉=()。直埋敷设于地中的电缆,沿电缆全长应覆盖宽度不小于电缆两侧各()的保护板,保护板宜用混凝土制作。5/9K#
1K
9/5K
10K30mm
50mm#
100mm
200mm
- 绝缘吸收比的测量是采用读数为()和15s的绝缘电阻的比值。直埋敷设于地中的电缆,沿电缆全长的上、下紧邻侧铺以厚度不小于()的软土或沙层。大接地电流系统中双母线上两组电压互感器二次绕组应()。30s
60s
300s
6
- 220kV变压器、电抗器施加电压前变压器油微水含量不大于()。20L/L
15L/L#
10L/L
8L/L
- 常规220~500kV变电站,在选择直流系统时,应采用()。两台充电装置和两组蓄电池互为备用的运行方式
采用两台充电装置和两组蓄电池相对独立,一台备用充电机分别对两台充电机进行备用的运行方式
两台充电装置和两组蓄
- 直埋敷设于地中的电缆,当位于车行道时,电缆外皮至地面深度不宜小于()。换流变压器发生直流偏磁现象会使铁芯饱和,导致()。0.5m
0.6m
0.7m
1.0m#铁损增加和噪声增大#
铁损增加和噪声降低
- 330kV变压器、电抗器施加电压前静止时间不小于()。1000kV变压器、电抗器施加电压前变压器油微水含量不大于()。24h
48h#
72h
96h20L/L
15L/L
10L/L
8L/L#
- 重要的500kV及以上电压等级的变电站,在选择直流系统时,应采用()。1000kV变压器、电抗器施加电压前静止时间不小于()。换流站的正(负)极是()。(A)两台充电装置和两组蓄电池互为备用的运行方式
(B)采用两台
- GIS(HGIS)组合电器与灭弧室相通的气室气体微水含量应不大于()。100L/L
150L/L#
200L/L
250L/L
- 真空断路器合闸过程中触头接触后的弹跳时间,40.5kV及以上断路器不应大于()。关于旁路隔离开关的闭锁,()描述是不正确的。2ms
3ms#
4ms
5ms线路的旁路隔离开关必须在旁路断路器断开时才可操作
旁路断路器的旁路母
- 《法律援助条例》对法律援助的实施作出了如下规定:由人民法院指定辩护的案件,人民法院在开庭()前将指定辩护通知书和起诉书副本或者判决书副本送交其所在地的法律援助机陶。真空断路器合闸过程中触头接触后的弹跳
- 1kgf•m=()。500kV变压器、电抗器施加电压前变压器油微水含量不大于()。0.980665N•m
1N•m
9.80665N•m#
98.0665N•m20L/L
15L/L
10L/L#
8L/L
- 330kV变压器、电抗器施加电压前静止时间不小于()。24h
48h#
72h
96h
- 《法律援助条例》对法律援助的实施作出了如下规定:由人民法院指定辩护的案件,人民法院在开庭()前将指定辩护通知书和起诉书副本或者判决书副本送交其所在地的法律援助机陶。直埋敷设于地中的电缆,沿电缆全长的上、